Canon PIXMA MG6220 Network Setup Manual

<< Previous Next >>

Getting Your Multifunction

Back On Your Network

After A Router Or Network Change

PIXMA MG6220

Macintosh OS

1

Important

If any of the following situations exist

• You have replaced your Router or Access Point

• You want to use a different wireless network

• Router settings have been changed.

Please complete the following steps to apply the new configuration settings to your multifunction.

2

<< Previous Next >>

Information

Preparing to Connect Your Multifunction

To the Network

<< Previous Next >>

Network Requirements

Before connecting the machine to the network, make sure that configuration of the computer and access point or router is

complete, and that the computer is connected to the network.

Wireless Connection

Before connecting the machine to the network, the computer needs to be connected to the network. Make sure that

configuration of the computer and access point or router is complete.

3

Preparing to Connect Your Multifunction

To Your Network

<< Previous Next >>

4

Notes on Network Connection

• The configuration, router functions, setup procedures and security settings of
the network device vary depending on your system environment. For details,
refer to your device's instruction manual or contact its manufacturer.

• In an office setup, consult your network administrator

• If you connect to a network that is not protected with security measures, there

is a risk of disclosing data such as your personal information to a third party.

• If an error message appears or if you have trouble with the network
connection, refer to the printed manual: Network Setup Troubleshooting.

• Place the machine and computer on the same network segment.

An "Ad-hoc connection," which establishes a direct connection to the computer
over a wireless connection without using an access point, is not supported.

A wireless access point or router is required to use your printer on a wireless

LAN.