Canon iR5800C, iR5800CN, iRC6800C, iRC6800CN ir6800c-010
Canon Service Bulletin COPIER
Issued by Canon Europa N.V.
Model:
iR6800C
iR6800CN
Ref No.:
iR6800C-010
(F2-T01-0M3-10027-01)
Date:
30-07-04
Location:
Vertical Size Detection Kit Installation
Subject:
Remedy Against the Glare of Scanning Lamp
Background
Reports of users complaining about the glare of the scanning lamp have been filed, and a vertical size sensor kit (AB/
Inch) will be offered as a remedial kit.
Vertical Size Sensor Kit (AB) FM2-0646
Vertical Size Sensor Kit (Inch) FM2-0647
Overview
The use of a reflection type size sensor in both main and sub scanning directions will eliminate the need for the
machine to execute size detection using its CCD, thus permitting the detection of original size without having to turn
on the scanning lamp.
It is important that the user be fully informed of the following changes in regard to detecti on size. Moreover, the
installation of the vertical size sensor kit (Inch; FM2-0647) calls for upgradi ng the reader controller software to
version 9.02 (iR C6800 Series) or later.
Size Detection by a
CCD
Size Detection by a
Reflection Type
Sensor
AB-Configuration
B6、B5R、A5、A4R、
B5、B4、A4、A3
B5R、A4R、B5、B4、
A4、A3
Inch-Configuration
STMT-R、STMT、LTRR、LEGAL、LTR、
11"×17”
（279mm×432mm）
LTR-R、LEGAL、LTR、
11"×17”
（279mm×432mm）
(1/10)
iRC6800-010
]
Note:
As opposed to the use of a CCD, the use of a reflection type sensor will not permit detection of the follow ing: for
AB-configuration, absence of paper, B6, A5; for Inch-configuration, absence of paper, STMT, STMT-R.
Installation Procedure
When installing the Vertical Size Sensor Kit (Inch; FM2-0647), be sure to upgrade the reader controller software
to version 9.02 or later (iR C6800 Series).
1.Check the contents of the kit.
[1] [2]
[3]
F-1
[1] Vertical size sensor unit.......................1 pc.
[2] Horizontal size sensor..........................1 pc.
[3] Clamp ..........................................5 pc.
[4] Edge saddle.....................................1 pc.
[5] RS tightening screw (M4x8)..................... 1 pc.
[4]
[5
(2/10)
2.Installation
]
]
2.1 Installing to the Host Machine
Be sure to go through the following in strict sequence before starting the work:
1. Turn off the control panel power switch [1].
2. Turn off the main power switch [2].
3. Disconnect the power cable [3] from the power outlet.
[2]
OFF
[1]
OFF
ON/OFF
/
iRC6800-010
[3]
F-2
1) Remove the 2 screws, and detach the right glass retainer [2]; then, detach the copyboard glass [3].
[1]
[1]
[3]
[3]
[2
[2
F-3
(3/10)
Loading...