1-1
Wireless LAN Board-C1
Check of bundled parts
Installation procedure
If bundled parts are used;
If the parts bundled with this product are used, the symbol indicating the use of
bundled parts is illustrated.
Bundled
parts
In this procedure manual, the frequent operations are illustrated with symbols.
Screw Connector Binding wire
Attach Detach Attach Detach Attach Detach
Claw
Attach Detach Push Plug in Switch ON
[1] Wireless board x 1 [2] Flat cable x 1
[3] Screw (T P;M3x 6) 1
Check Visual check Noise check
1-1
1-2
Check of main power OFF
Check that the main power switch of the main body is OFF.
1) Turn OFF the main power switch of the main body.
2) Check that the indication lamps on the operation panel and the mai n p ower
lamp are out, and pull out the power plug.
Schematic diagram of attachment
1) Press cassette [1].
2) Press button [2]. Open cartridge door unit [3].
3) Open ADF unit and reader unit [1].
Installation procedure
1-2
1-3
4) Remove claw [1] and arm cover [2].
6) Shift the left side of main body [1] from the workbench by about 10 cm.
5) Disconnect arm [1] and push it back.
1-3
7) Open ADF unit and reader unit [1]. Reset claw [2].