Candy P 604 User Manual
CONTENTS
Unpacking the appliance.......................................................................... 3
Recommendations .................................................................................... 3
• INSTALLATION
Safety instructions .................................................................................... 4
Electrical connection ............................................................................ 5/6
Fitting the hob ..................................................................................... 7/8
• USING THE APPLIANCE
Presentation of the hob ............................................................................ 9
Technical data .......................................................................................... 9
The hot plate ......................................................................................... 10
Using the hot plate ................................................................................ 10
Cooking with the hot plate .................................................................... 11
General maintenance ............................................................................. 12
2
UNPACKING THE APPLIANCE
Inside the appliance you will find a plastic bag containing the fixing brackets to install the hob
in the worktop.
RECOMMENDATIONS
PLEASE READ THE FOLLOWING CAREFULLY IN ORDER TO GET THE BEST FROM
YOUR APPLIANCE.
Please keep the operating and installation instructions in a safe place for future reference.
Before fixing the hob, note the serial number of the appliance just in case you may require
repairs from after sales service organisation.
. Rating plate (located under the lower casing of the hob)
• All accessible parts of the hob become hot while it is in operation. Always keep
children away from it.
• The hob should be given a quick clean after each use, to avoid the accumulation of
spillages and grease, which if not removed, will harden, and could cause the production of
smoke and unpleasant smells.
• When cooking with fats or oils, never leave gas burner unattented. Overheated fats or oils
can quickly catch fire.
3
INSTALLATION
Installing a domestic appliance can be a complicated operation which, if not
carried out correctly, can seriously affect consumer safety.
It is for this reason that the task should be undertaken by a professionally
qualified person who will carry it out in accordance with the technical regulations
in force.
In the event that this advice is ignored and the installation is carried out by an
unqualified person, CANDY declines all responsibility for any technical failure
of the product whether or not it results in damage to goods or injury to
individuals.
INSTALLATION: "ELECTRICAL CONNECTION"
The mains electricity supply connected to the appliance should comply with the norms in
force in the country of installation.
Candy declines all responsibility for any damage that may be caused by unsuitable or
unreasonable use.
Warning :
• Always check before any electrical operation, the supply voltage shown on the
electricity meter, the adjustment of the circuit-breaker, the continuity of the
connection to earth of the installation and that the fuse is suitable.
• The electrical connection to the installation should be made via a socket with a plug
with earth, or via an omnipole cut-out switch with an opening gap of at least 3 mm.
• The yellow/green wire of the power supply cable must be connected to the earth
of both power supply and appliance terminals.
• Candy cannot be held responsible for any accidents resulting from the use of an
appliance whic h is not connected to earth, or with a faulty earth connection continuity.
• Any queries regarding the power supply cord should be referred to After Sales
Service or a qualified technician.
The hob "PL 604" is supplied with a terminal block which enables you to choose the
correct connection for the particular power supply.
The terminal block permits different connections :
• Monophasé 220-240 V~
• Biphasé 220-240 V2~
• Biphasé 380-415V2N~
• Triphasé 220-240 V3~
• Triphasé 380-415 V3N~
4
To proceed to the new connection, you mus adhere the following instructions
• Before making the connection, make sure that the installation is protected by a suitable
fuse, see table on next page, and that it is fitted with wires of a large enough section to
supply the appliance normally.
1 - O perations t o be carried out to make a connection :
. Choose the supply cord in accordance with the recommendations in the table on the
next page.
. Turn the hob against the worktop.
. Unscrew the cover.
Terminal
block
Shunt
bars
Cable
clamp
Earth
Terminal
. Pass the supply cord into the cable clamp.
. Unscrew the shunt bars fixed on the earth terminal.
. Strip the end of each conductor of the supply cord to a 10 mm length, by taking in
account the requested length of the cord for the connection on the terminal block.
. According to the installation and with the help of shunt bars, fix the conductor as
shown on the chart.
. Engage the earth wire yellow/green on the earth terminal, tighten the nut and verify
the continuity of the earth.
. Secure the cable clamp.
. Fix the cover.
5
Loading...