™
M50, M60 and M80 Speakers
User Manual
®
INTRODUCTION
Thanks for choosing a Newton Series speaker.
The M50, M60 and M80 all feature the finest drivers, precision internal crossover circuitry, and an elegant enclosure design.
The Design Team at Cambridge SoundWorks believes there is no better combination of audiophile-level attention to detail and reasonable cost.
AFTER UNPACKING
Store the shipping carton and packing material for future use and transport.
CONTENTS
M50
1.One pair of speakers
2.Eight rubber feet
3.Two 3/4" long 1/4" x 20 phillips head screws
M60
1.One pair of speakers
2.Eight rubber feet
M80
1.One speaker
2.Four rubber feet
3.Allen wrench
INSPECTING FOR DAMAGE
Examine each part carefully for shipping damage. If there is any, do not install or use the speakers. Return the speaker to the store or merchant where you made the purchase or call Cambridge SoundWorks at 1-800 FOR-HIFI (1-800-367-4434) for assistance.
M50
M50
+
—
Front |
Back |
M60
M60
+
—
Front |
Back |
M80
M80
+
+
—
—
Front |
Back |
|
|
|
|
|
|
|
|
|
|
Rubber Feet
Allen Wrench
3/4" long 1/4"—20 phillips head screws (M50 only)
3
SPEAKER PLACEMENT
Mounting the M50 on a wall:
There is a metal insert in the back of the M50 with 1/4-20 threads. The recommended bracket (available from Cambridge SoundWorks) is the Vogel’s® Satellite 5 (part number A1SAT5BL for black or A1SAT5WH for white). For stability, the speaker should be installed on the wall inverted, so the bracket is above the speaker’s center (fig.1).
Attaching the bracket: Place the inverted speaker on a flat surface. Attach the Multi-Position Adapter and the upper half of the Speaker Bracket to the M50’s threaded insert as shown in figure 2, using the 3/4” 1/4-20 Philips head screw that comes with the speaker. Tighten securely. Attach the lower half of the Speaker Bracket as described in the instructions that come with the speaker bracket.
Attaching the M50 to the Newton Series floor stands:
Follow the assembly and wire routing instructions that come with the stands. Be sure to use the plastic washer (supplied with the stands) between the stand bracket and the back of the speaker as shown.
Figure 1
Wall Mounting Options for M50
Threaded Insert
Multi-Position
Adapter
Upper Half of
Speaker Bracket
1/4"—20 x 3/4" long
Figure 2
Speaker Bracket for M50
|
Plastic Washer |
|
(supplied with stands) |
|
M50 |
+ |
|
|
8 Ohms |
— |
Mounting Knob |
|
|
|
(supplied with stands) |
Stand Mounting for M50
4
Loading...