Bully Dog Jeep JK 2007-2010 User Manual

32305: Jeep JK 2007-2010

Most custom gauge pods come in black.

Consider before beginning installation

that the custom gauge pod can be

painted to match the color of the

vehicle interior. The custom gauge

pod is made from ABS plastic and can

be painted with spray paint found at

auto parts stores.

Existing Trim Removal

1. Using a no. 2 Phillips, back out
the plastic screw(s) from the
A-Pillar trim.

2. Remove Torx screws from the
visor mounting bracket with
the T20 Torx bit.

3. Pull upper visor trim down/o.

4. Pull o the stock A-pillar.

5. You should now have exposed

i

the corner frame of your Jeep
where you can install the Bully
Dog custom gauge pod mount.

Custom Pod Mount Install

6. Install the appropriate mount adapter and run cables
for your vehicle through the accessory hole in the Bully
Dog A-pillar as needed. (Some route out through, while
some mount back in before install) Pull the driver side

dash panel o to run cables under the dash to the

OBDII Plug.

7. Install Bully Dog A-pillar by
guiding the push pin into the
appropriate hole and pushing
it into place. Secure it with the
remaining screw.

8. Install visor trim piece.

9. Reinstall visor.

10. Finish by inserting plastic
screws.

11. Enjoy the sleek new look of
your Custom Mounted Bully
Dog GT!

32305-99 v1.1

ii