Brother Innov-is BQ2450 Upgrade KIT II Operation Manual

Upgrade KIT II Operation Manual

a
b

c

a

b

This manual provides details on the functions added/upgraded. Before using this manual, upgrade your
machine according to the procedure in the Installation Guide. Before using the functions described in this
manual, read the Operation Manual included with the machine.
The screen illustrations in this manual may differ from actual ones shown on the machine.

New Features of Upgrade KIT II

“Automatic Presser Foot Lift”
functions

“Automatic Presser Foot Lift” has been added to
page 3 of the settings screen. By setting the presser
foot to operate automatically, sewing operations can
be performed more smoothly.

a Auto Down

When set to “ON”, pressing the “Start/Stop” button
(or depressing the foot controller) automatically
lowers the presser foot when it is raised, allowing
sewing to begin.

b Auto Up

When set to “ON”, pressing the “Start/Stop” button
(or releasing the pedal of the foot controller) to stop
sewing, it will then automatically raise the presser
foot. The presser foot is raised to the height
specified for “Presser Foot Height” on page 1 of the
settings screen.

* Depending on selected patterns, the presser foot

will not be raised automatically.

When the pivot setting ( ) is selected, the
presser foot is raised to the height specified for

“Pivoting Height” on page 3 of the settings screen.

c Press to Trim

When set to “ON”, pressing the “Thread Cutter”

button ( ) automatically lowers the presser foot

when it is raised, allowing the thread to be cut.
After the thread is cut, the presser foot is raised

again.

Additional settings for the multi­function foot controller

“Presser Foot Up/Down” and “No Setting” have
been added as functions that can be set for the
multi-function foot controller.

a Presser Foot Up/Down

When this is selected, the multi-function foot
controller can be used to raise and lower the presser
foot.

b No Setting

When this is selected, no operation is performed.
This prevents an incorrect operation from being
performed if the multi-function foot controller is
accidentally depressed.

Pivot setting

If the pivot setting is selected ( ), it will remain
selected even after the machine is turned off.

Additional settings

“Presser Foot Height” on page 1 of the settings
screen can be set to from 2.0 mm to 10.0 mm.
“Pivoting Height” on page 3 of the settings screen
can be set to from 2.0 mm to 7.5 mm.

1

Additional Decorative Stitches

2