Broan P8 Marketing Sell Sheet
Installation and Blower Selection
Guidelines
Guidelines
1. Distance from cooking surface:
of your cooktop width. For example, a 36” wide
cooktop requires a blower with a minimum of 300
For optimal performance, the distance from
CFM.
the cooking surface to the bottom of the range hood
should be between 24” and 30”, unless otherwise
noted. DO NOT install a Broan Elite range hood
less than 24” above cooking surface.
To maintain hood performance at heights greater than
the recommended range, use the following guidelines:
• High heat cooking or aromatic foods may require
additional CFM. Always check with the range
manufacturer. NOTE: Increasing capture area
by 3” on each side is also a recommended way
to address this issue.
Range hood should be
between 24” to 36”
unless otherwise noted.
• As a means to estimate the approximate CFM
• For every 3” increase in installation height,
add 100 CFM to the minimum exhaust requirement
and/or a minimum of 3” to the hood/liner width
(may require going to the next hood width).
requirement for cooktops OVER 60,000 BTUs,
choose a blower with 1 CFM per 100 BTU of
cooktop output. To quickly calculate this number,
add the BTU output from all burners and drop the
last two zeros. For example, if the total BTU output
2. Range hood width:
The range hood should never be less than the width
of the cooktop.
3. Required blower CFM based on cooktop BTU output:
• For cooktops UNDER 60,000 BTUs, choose a
blower with a minimum of 100 CFM per lineal foot
of the cooktop burners is 65,000 BTUs, choose a
blower with at least 650 CFM.
4. Additional CFM needs for a grill or griddle:
If your cooktop has a grill or griddle, ADD 200 CFM
to your estimated CFM needs as calculated in step
3. For example, if your cooktop BTU requires a 650
CFM blower, add 200 CFM for a total of 850 CFM.
INSTALLATION EXAMPLE:
A consumer purchases a cooktop
with these specications:
• Four burner, 36” cooktop
• Burner output is 60,000 BTU
• The cooktop features a grill.
• Installation requirements call
for the range hood to be 33”
over the range
(3” above recommended maximum height)
BLOWER CFM
Option 1
(Using the guidelines above)
The blower must equal
a minimum of 600 CFM
(60,000 BTU) + 200 CFM
(for grill requirement)
+ 100 CFM (for 3” of
installation height)
= 900 CFM
Option 2
(Using the guidelines above)
Select a range hood that
is a minimum of 3” WIDER
than the cooktop,
a minimum 600 CFM
(60,000 BTU) + 200 CFM
(for grill requirement)
= 800 CFM
Internal Blowers
Broan Elite internal blowers provide high ventilation and durable construction
to meet the needs of professional-style cooking appliances for the home.
• The P5 and P8** are designed for use with the Broan
Elite RMIP Insert.
• Rough-In Kits are included to make the installation
clean and simple.
SPECIFICATIONS
MODEL MOUNTING CFM MAX COOKTOP BTU HVI VOLTS AMPS ROUGH-IN
P5 Internal 500 60,000 Y 120 1.8 3-1/4” x 10” — V or H —
P8 Internal 850 95,000 Y 120 3.4 3-1/4” x 14” — V or H —
331* Exterior 600 60,000 Y 120 2.3 10” Round — — Single-speed
332* Exterior 900 90,000 Y 120 5.8 10” Round — — Single-speed
335* Exterior 1200 120,000 Y 120 3.0 10” Round — — Single-speed
336* Exterior 1500 120,000 Y 120 3.8 10” Round — — Single-speed
◆
HLB3*
HLB6* In-Line 600/600** 65,000 Y 120 2.9 — 10”/10” Round V or H Single-speed
HLB9* In-Line 800/700** 85,000 Y 120 3.0 — 10”/10” Round V or H Single-speed
HLB11* In-Line 1100/1000** 110,000 Y 120 5.0 — 10”/10” Round V or H Single-speed
* Model 332KR Rough-In Kit required for installation with RMIP Series only.
** Straight CFM/Right angled CFM (rated with transitions provided).
◆
120V 60Hz
In-Line 280/260** 40,000 Y 120 2.6 — 8” or 10”/8”
DUCT
INLET/OUTLET DIRECTION MOTOR TYPE
V or H Single-speed
Round
87453 09/09
Broan-NuTone Canada Inc.
1140 Tristar Drive
Mississauga, Ontario L5T 1H9
www.broan.ca
1-888-882-7626
Specications subject to change without notice.
® 2009 Broan-NuTone Canada Inc.
Exterior Blowers
Our external blowers offer you powerful ventilation performance at its very quietest, and something you won’t nd anywhere else - Broan quality.
Guidelines
• Safety screen keeps small animals and debris
away from blower and motor.
• Designed for use with our professional
style Broan Elite E60000 and E64000, EX Series,
RMPE Power Pack and RMIP Inserts.
• Model 332KR Rough-In Kit required for installation
with hood series RMIP.
All external blowers can be installed on the roof
or to an outside wall for the ultimate in quiet,
high-performance kitchen ventilation.
• Reduce kitchen noise by locating
range hood blowers outdoors.
• The 332 is recommended for the
27000/28000 Series.
• Residential design ts unobtrusively on home exterior.
• Durable, weather-resistant, all-aluminum construction
that mounts on the roof or outside wall.
331 (600 CFM) 336 (1500 CFM)332 (900 CFM)335 (1200 CFM)
In-Line Blowers
This quiet performance solution is a perfect alternative to internal or exterior blowers. Works with all Broan range hoods designed for use with external blowers.
• Powerful and quiet, in-line blowers are available
in a range of CFM ratings to match your cooking
preferences and ventilation requirements.
• Installs remotely in the interior of the home.
• 8-position mounting brackets, or suspends with
special suspension chains (hanger kit included).
• Designed to work independently from internal or
external blowers, this is not a boost blower—the HLB
series needs no other blowers in the system.
• Specially designed resilient motor mounts
and housing isolation mounts prevent vibration noise.
• Flexible duct design allows straight-through
or right-angle connections with built-in damper.
• Includes 10” round ductwork transition(s).
HLB3 (280 CFM)
HLB6 (600 CFM)
HLB9 (800 CFM)
HLB11 (1100 CFM)
Broan-NuTone Canada Inc.
1140 Tristar Drive
Mississauga, Ontario L5T 1H9
HLB3 In-Line Blower
with 8” round integrated
duct connectors.
(Includes Qty. 1 8” to 10” round
transition.)
www.broan.ca
1-888-882-7626
HLB6 In-Line Blower
with 4-1/2” x 18-1/2”
integrated duct connectors.
(Includes Qty. 2 transitions
to 10” round.)
HLB9 and HLB11 In-Line Blowers
In-Line Blower with 8” x 12”
integrated duct connectors.
(Includes Qty. 2 transitions
to 10” round.)
87453 09/09
Specications subject to change without notice.
® 2009 Broan-NuTone Canada Inc.
Loading...