Breville BBL920 User manual

the Super Q

Instruction Book - BBL920

Contents

IMPORTANT SAFEGUARDS

2 Breville Recommends

Safety First

8 Components 10 Functions 12 Tips 14 Blending Chart 16 Troubleshooting 17 Care & Cleaning

BREVILLE RECOMMENDS SAFETY FIRST

At Breville we are very safety conscious. We design and manufacture consumer products with the safety of you, our valued customer, foremost in mind. In addition we ask that you exercise a degree of care when using any electrical appliance and adhere to the following precautions.

FOR ALL ELECTRICAL APPLIANCES

READ ALL INSTRUCTIONS BEFORE USE AND SAVE FOR FUTURE REFENCE

• Remove and discard all packaging materials and stickers before ﬁrst use.

• To avoid choking hazard for young children, remove and safely dispose the protective cover ﬁtted on the power plug.

• This appliance is for household use only. Do not use it in moving vehicles or boats, do not use it outdoors, and do not use it for anything other than its intended use. Misuse can cause injury.

• This appliance shall not be used by children. Keep the appliance and its cord out of reach of children.

• Cleaning and user maintenance shall not be made by children without supervision.

• Children shall not play with this appliance.

• This appliance can be used by persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and if they understand the hazards involved.

• Do not use the appliance near the edge of a countertop or table. Ensure the surface is level, clean and free of water and other substances. Please be aware that vibration during use may cause the appliance to move.

• Do not use the appliance on (or close to) a hot gas or electric burner, or where it could touch a heated oven or surface.

• Do not allow the cord to hang over the edge of a countertop, or to become knotted.

• To avoid electric shock, do not immerse the cord, plug or motor base in water (or other liquids).

• Installation of a residual current device (a standard safety switch on your wall socket) is recommended to provide additional safety protection when using appliances. It is advisable that a safety switch (with

a rated residual operating current not more than 30mA) be installed in the electrical circuit supplying the appliance. Contact your electrician for further professional advice.

• In order to avoid the possible hazard of the blender starting by itself due to inadvertent resetting of the overload protector on the motor, do not attach an external switching device (such as a timer) or connect the blender to a circuit that can regularly switch the blender on and off.

• Do not operate appliance with a damaged cord or plug, or after appliance malfunctions, or if dropped or damaged in any way. Stop use immediately and contact Breville by phone or email for replacement or repair.

• All maintenance (other than cleaning) is to be done by an authorised Breville Service Centre.

SAFEGUARDS FOR YOUR BLENDER

• Wash the blender jug with warm soapy water before ﬁrst use.

• Use only the blender jug and lid that is supplied with this blender. The use of attachments, including canning jars or accessories not manufactured or speciﬁed by Breville may cause the risk of ﬁre, electrical shock, or injury.

• Always ensure the blender is assembled properly before using. Lid must be ﬁrmly secured to the jug before operation to ensure internal contents do not escape, spray or overﬂow.

• If the motor is straining under a heavy load, do not operate continuously for more than 10 seconds. Allow the motor to rest for 1 minute between uses on heavy loads. Note that none of the recipes in these instructions are considered a heavy load.

• Do not leave the blender unattended when in use.

• Flashing light indicates ready to operate. Avoid any contact with blades or moving parts.

• Keep hands, ﬁngers, hair and clothing away from the blender during use. Always turn blender off and unplug at the wall before reaching inside.

• Be careful when handling the blender jug as the blades are very sharp. Be careful when emptying the jug and during cleaning. Mishandling of the blades may cause injury.

• Do not remove the jug from the motor base while blender is in use.

• The blender is intended for food or drinks preparation. Do not use for anything other than food or drinks. Do not operate without any ingredients in the blender jug.

• Never attempt to operate with damaged blades, or with utensils, or any foreign objects inside the blender jug.

• To reduce the risk of severe injury to persons or damage to the blender, keep hands and utensils out of the jug while blending. The scraper and frozen dessert tamper provided can be used, provided the main lid is in place.

• Never blend boiling hot liquids. Allow temperature to drop before putting into the jug for blending.

• Be careful if hot liquid is poured into the blender, as it can be ejected out of the jug due to sudden steaming.

• When blending hot liquids ensure inner measuring cap is in place. Cap will protect from splashing of hot liquids during blending and includes vents designed to relieve pressure and avoid steam build up.

• Be careful removing the lid after blending hot liquids, as steam traps can form in the liquid and be ejected out of the jug.

• Do not put the blender jug in extremes of heat or cold, for example placing a cold jug into hot water, or vice versa.

• Before moving the blender, cleaning or putting it away for storage, always turn blender off and unplug at the wall.

When using the Personal Blender Attachment please note:

Opening a pressurised personal blender cup may lead to ingredients splattering, or may cause burning/scalding if the contents are hot. To minimise the risk of this happening, always follow the instructions below:

• Never blend hot or warm ingredients. Stop the blending process if contents become hot due to blending. Never blend any ingredients for more than 1 minute. Blending for more than 1 minute may cause the ingredients to become hot and steam may cause the cup to become pressurised.

• Never attempt to unscrew the blade from the base of the cup when the cup becomes pressurised due to steam build-up. Allow cup to cool to room temperature before carefully unscrewing the blade.

• Never blend carbonated liquid, detergent, or any ingredient that could expand or generate a gas.

• Never ﬁll the cup beyond the cup’s indicated maximum capacity.

• If leakage occurs during blending, immediately stop blending and unplug the unit from the power point. Check to ensure that the personal blender cup is not ﬁlled past the maximum level and that there is no damage to the seal or to the cup. Clean up the leakage with a dry towel and screw the cup ﬁrmly to the blending mechanism before resuming blending.

FOR HOUSEHOLD USE ONLY SAVE THESE INSTRUCTIONS

+ 14 hidden pages