Multiquick
Leporello, 130x297 mm, 8 pages, 1/1c = black
MR 430 CA MR 430 HC
MR 400 CA MR 400 HC Plus
99568878/VI-10
China/GB
A
B
MR 430 CA
MR 430 HC
MR 400 CA
MR 400 HC Plus
C
D1
D
D2
E
hc
HC
F
ca
CA
G
1
15…20 °C
1
2
2
4…8 °C
3
a
b
CA
ca
c
hc
HC
d
12 3 4
ca
ca
5
CA
6
ca
hc
7
ca
ca
8
ca
9
10
ca
ca
ca
HC
MR 400
CA
200 g
150 g
100 g
200 g
200 g
20 g
20
HC
ca
+/- +/-
15-30
30
10
20
10
15
25
70 g
80 g
50 g
20 g
80 g
80 g
hc
5
20
6 x 1
6 x 1
7
5 x 1
12 x 1
12 x 1
200 g
30
150 g
90 g + 45
12 x 1
25
ml
Our products are engineered to meet the
highest standards of quality, functionality
and design.
We hope you thoroughly enjoy your new
Braun appliance.
Caution
Please read the use instructions carefully
and completely before using the appliance.
• The blades are very sharp! To avoid
• Always
•
• Do not hold the motor part (A) nor the gear
• Braun electric appliances meet
• Before plugging into a socket, check
• The appliance is constructed to process
• The beaker (G) is not microwave-proof.
injuries, please handle blades with
utmost care.
unplug the appliance before
assembling, disassembling, cleaning or
storing.
This appliance is not intended for use by
children or persons with reduced physical,
sensory or mental capabilities, unless
they are given supervision by a person
responsible for their safety. In general, we
recommend that you keep the appliance
out of reach of children. Children should be
supervised to ensure that they do not play
with the appliance.
attachment (D1) or the upper part of the
«CA» chopper (F) under running water, nor
immerse them in water.
applicable safety standards. Repairs or
the replacement of the mains cord must
only be done by authorised service
personnel. Faulty, unqualified repair
work may cause considerable hazards
to the user.
whether your voltage corresponds
with the voltage printed on the bottom
of the appliance.
normal household quantities.
Description
A
Motor part
B
On/off switch
C
Shaft with blade
D
Gear attachment (D1) for whisk (D2)
E
«HC» chopper
F
«CA» chopper
G
Mixing beaker
How to operate your handblender
The handblender (motor part with shaft) is
perfectly suited for preparing dips, sauces,
soups, mayonnaise and baby food as well as
for mixing drinks and milkshakes.
1. Insert the motor part (A) into the shaft with
blade (C) and turn until it locks.
2. To avoid splashing, insert the handblender into the vessel first, only then
press switch (B).
You can operate the handblender in the
mixing beaker (G), and just as well in any
other vessel. When blending directly in the
saucepan while cooking, take the pan from
the stove first to protect your handblender
from overheating.
Recipe example: Mayonnaise
200 – 250 ml oil
1 egg (yolk and white)
1 tbsp. lemon juice or vinegar
Salt and pepper to taste
Put all ingredients into the beaker according
to the a.m. order. Introduce the handblender
to the base of the beaker, switch it on and
keep it in this position until the oil emulsifies.
Then, without switching off, slowly move it
up and down until the mayonnaise is well
combined.
How to operate your whisk
Use the gear attachment with whisk only
for whipping cream, beating eggwhites and
mixing sponges and ready-mix desserts.
1. Insert the whisk (D2) into the gear
attachment (D1) until it locks.
2. Then insert the motor part (A) into the
gear attachment (D1) until it locks.
3. Insert the whisk into the vessel and only
then press switch (B) to operate it.
For best results:
• Use a wide vessel.
• Only whip up to 400 ml chilled cream.
• Only whip up to 4 eggwhites.
• Move the whisk clockwise.
How to use your chopper
attachment
The chopper is perfectly suited for chopping
meat, cheese, onions, herbs, garlic, carrots,
walnuts, hazelnuts, almonds, prunes etc.
Pre-cut meat, cheese, onions, garlic, carrots,
chilis (see table page 3). Remove stalks and
un-shell nuts.
N.B.:
Beef: before chopping, all bones, tendons
and gristle should be removed.
Chilis (with water): only use «HC» chopper.
Do not chop ice cubes or extremely hard
food, such as nutmeg, coffee beans,
chocolate and grains.
1. Carefully remove the plastic cover from the
blade (b).
2. Caution: the blade (b) is very sharp!
Always hold it by the upper plastic part.
Place the blade on the centre pin of
the chopper bowl (c), press it down and
turn 90° until it locks. Always place the
chopper bowl (c) on the anti-slip base (d).
3. Place the food in the chopper bowl.
4. Put the upper part (a) on the chopper bowl.
5. Insert the motor part (A) in the upper part
(a) of the chopper and turn until it locks.
6. Press switch (B) to operate the chopper.
During processing, hold the motor part
with one hand and the chopper with the
other.
7. First remove the motor part.
8. Then remove the upper part (a).
9. Carefully take out the blade (b).
(You may have to turn the blade slightly.)
10.
Then remove the processed food from the
chopper bowl. The anti-slip base also
serves as an air-tight lid for the chopper
bowl.
Cleaning
After use, remove the shaft with blade or
the chopper. Clean the motor part (A),
the upper part of the «CA» chopper (a) and
the gear attachment (D1) with a damp cloth
only. All other parts can be cleaned in the
dishwasher. However, after processing very
salty food, you should rinse the blades of the
shaft and the chopper right away. Also, be
careful not to use in your dishwasher an
overdose of cleaner and decalcifier.
When processing foods with colour (e.g.
carrots), the plastic parts of the appliance
may become discoloured. Wipe these parts
with vegetable oil before cleaning.
Accessories
(not in every country)
The following accessories are available at
your retailer or at Braun Service Centres:
CA-4: Powerful chopper
HC-4: High speed chopper
WH-4: Metal whisk
Subject to change without notice.
Please do not dispose of the product in
the household waste at the end of its
useful life. Disposal can take place at a
Braun Service Centre or at appropriate
collection points provided in your country.
Loading...