Bosch TDS2229GB, Sensixx B22L Operating Instructions Manual

Sensixx B22L
en Operating instructions

 























4
Thank you for buying the Sensixx B22L steam station, the new steam-ironing system from Bosch.
Carefully read through the operating instructions for the appliance and safeguard them for future refer-­ence.
Introduction
These instructions for use contain valuable information about the unique features of this system and some hints to make ironing easier for you.
We hope that you enjoy ironing with this steam station.
Important
Open out the rst page of the booklet, this will help you to
understand how the appliance works. This appliance complies with international safety
standards. This appliance has been designed exclusively for
domestic use and must not be used for industrial purposes.
This appliance must be used only for the purposes for
which it was designed, i.e. as an iron. Any other use will
be considered improper and consequently dangerous. The manufacturer will not be held responsible for any damage arising from misuse or improper use.
General safety instructions
• This appliance is to be connected and used in accordance with the information stated on its characteristics plate.
• This appliance must be connected to an earthed socket. If it is absolutely necessary to use an extension
cable, make sure that it is suitable for 16A and has a
socket with an earth connection.
• The iron should not be used if it has been dropped,
if there are visible signs of damage or if it is leaking water. It must be checked by an authorized Technical Service Centre before it can be used again.
• If the safety fuse tted in the appliance blows, the
appliance will be rendered inoperative. To restore normal operation the appliance will have to be taken to an authorised Technical Service Centre.
• In order to avoid that, under unfavourable mains conditions, phenomena like transient voltage drops or lighting uctuations can happen, it is recommended
that the iron is connected to a power supply system
with a maximum impedance of 0.27 Ω . If necessary,
the user can ask the public power supply company for the system impedance at the interface point.
• This appliance is not intended to be used by persons
(including children) with reduced physical, sensory or mental capacities, or lack of experience and knowledge, unless they have been given supervision
or instruction concerning the use of the appliance by a person responsible for their safety.
• Children should be supervised to ensure that they do not play with the appliance.
• Remove the plug from the socket before lling
the appliance with water or before pouring out the remaining water after use.
• The appliance must never be placed directly under the
tap to ll the water tank.
• The appliance must be used and placed on a stable surface.
• When placed on its stand, make sure that the surface
on which the stand is placed is stable.
• The iron must not be left unattended while it is connected to the supply mains.
• Unplug the appliance from the mains supply after
each use, or if a fault is suspected.
• The electrical plug must not be removed from the socket by pulling the cable.
• Never immerse the iron or steam tank in water or any
other uid.
• Do not leave the appliance exposed to weather
conditions (rain, sun, frost, etc.).
• With the aim of avoiding dangerous situations, any work or repair that the appliance may need, e.g. replacing a faulty mains cable, must only be carried out by qualied personnel from an Authorised Technical
Service Centre.
Important :
• This appliance reaches high temperatures and
produces steam during use, this could cause scalds
or burns in case of improper use.
• The steam hose, base station, metal plate at the
bottom of the removable iron pad (2) and in particular the iron can get hot when used. This is normal.
• Never aim the steam at people or animals.
• Do not allow the power cable to come into contact with the soleplate when it is hot.
• Be aware that the system can keep on steaming for a short additional time after releasing the steam trigger. This is a normal function.
Description
1. Water tank
2. Removable iron pad
3. Steam hose storage xing
4. “Calc’n’Clean Advanced” scale collector *
5. Mains cable storage compartment
6. Mains cable
7. Steam hose
8. “Energy Saving” button *
9. “Steam ready” / “Auto shut-off” pilot light
10. Variable steam control *
11. “Rell water tank” / “Clean warning” pilot light
12. Illuminated main power button (0/I)
13. Iron xation system “SecureLock”
14. Housing with internal steam generator
15. Temperature control knob
16. Steam release button
17. Steam shot button “Pulse steam” *
18. Iron pilot light
19. Soleplate
20. Fabric-protection soleplate cover*.
* Model dependent
en
Loading...
+ 8 hidden pages