Bosch PBH6B5B60A, PBH6B5B80A, PBH6B5B90A User Manual
*
This cooktop is for use with Natural Gas and
Universal LPG
Leave this instructions with the owner
PBH6B5B80A, PBH6B5B60A, PBH6B5B90A
USER INSTRUCTIONS
INSTALLATION INSTRUCTIONS
MAINTENANCE INSTRUCTIONS
0.
en
Table of contents
[en]Instruction manual
( Important safety information . . . . . . . . . . . . . . . 2
For your safety . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
What to do if you smell gas . . . . . . . . . . . . . . . . . . . . . 2
Warnings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2
5 Installation and connection. . . . . . . . . . . . . . . . . 3
Statutory requirements . . . . . . . . . . . . . . . . . . . . . . . . . 3
Preparing to install . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Clearances . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Installation of cooktop into the kitchen bench . . . . . . . 4
Connection. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5
Converting the cooktop from Nat. Gas to
Universal LPG. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
Changing the nozzles of the burners on the cooktop. . 6
Adjustment of the taps . . . . . . . . . . . . . . . . . . . . . . . . . 6
(Important safety
information
For your safety
DO NOT MODIFY THIS APPLIANCE.
DO NOT USE OR STORE FLAMMABLE MATERIALS
NEAR THIS APPLIANCE.
DO NOT SPRAY AEROSOLS IN THE VICINITY OF THIS
APPLIANCE WHILE IT IS IN OPERATION.
If the information in this manual is not followed exactly,
a fire or explosion may result causing property damage,
personal injury or death.
Do not store articles on or against this appliance.
1 Operating the appliance . . . . . . . . . . . . . . . . . . . 7
Burner locations . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
Accessories . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
Cooking pans. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .9
Cleaning and maintenance. . . . . . . . . . . . . . . . . . . . . . 9
Service . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .10
Wiring diagram. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11
Produktinfo
Additional information on products, accessories,
replacement parts and services can be found at
www.bosch-home.com and in the online shop
www.bosch-eshop.com
What to do if you smell gas
Do not try to light the appliance.
Do not touch any electrical switch; do not use any
phone in your building.
Inmediately call your gas supplier from a neighbour’s
phone. Follow the gas supplier’s instructions.
If you cannot reach your gas supplier, call the fire
department.
Installation and service must be performed by an
authorised person.
Warnings
Do not allow the flame to extend beyond the edge of
the cooking utensil. This instruction is based on safety
considerations.
Do not forget that the unit becomes hot when in use.
Common sense is important. Just because the flame is
out, does not mean parts cannot still be hot.
This appliance shall not be used for space heating. This
instruction is based on safety considerations.
Be sure to disconnect the electrical supply before
disassembly of the appliance.
Keep the appliance area clear and free from
combustible materials, gasoline and other flammable
vapours and liquids.
This appliance must be installed in a position with the
proper level of ventilation. Do not obstruct the flow of
combustion and ventilation air.
Cabinets installed above the gas cooktop must have a
minimum clearance of 650 mm (24”).
The gas pressure regulator supplied with the appliance
must be installed in line with the gas pipe. (N.G. only).
For pressure testing in excess of 3.5 kPa (1/2 psig) the
appliance and its individual shutoff valve must be
disconnected from the gas supply piping system.
Important. When using a very large pot, leave a gap of
at least 50 mm (2”) to avoid damaging any parts in
2
en
bench top wood, plastic or other non-heat resistant
materials. Never leave oil or hot fat unattended.
The surfaces on heating and cooking appliances get
hot when in use. Be careful. Keep children away from
the appliance.
Only use your appliance for the preparation of food and
never for room-heating purposes.
This appliance leaves the factory set for the gas supply
indicated on the data label. Call the Service Centre if it
needs to be altered.
Do not tamper inside the appliance. If necessary, call
your local Service Centre.
Overheated fat or oil can easily catch fire. Never leave
the appliance unattended when cooking food with fat or
oil, e.g. chips.
Never pour water on burning fat or oil. DANGER OF
BURNS! Cover the receptacle to smother the flames
and turn the cooktop off.
If the liquefied gas bottle is not upright, liquefied
propane/butane can enter the appliance. Intense
darting flames may therefore escape from the burners.
Components may become damaged and start to leak
over time so that gas escapes uncontrollably. Both can
cause burns. Always use liquefied gas bottles in an
upright position.
In the event of a fault, cut the gas and electricity
supplies to the appliance. Call our Service Centre to
repair the fault.
Do not use unstable or uneven-based receptacles on
cooking plates or burners. They may accidentally tip
over.
If a gas supply knob/valve jams, do not force it. Call
your official Service Centre immediately for them to
repair or replace it.
The illustrations used in this booklet are only intended
as a guide.
Grids become very hot during use. When operating the
appliance control knobs, take care not to make contact
with the grids.
This appliance is not suitable for use in a marine craft,
caravan or mobile home.
This appliance is not intended for use by persons
(including children) with reduced physical, sensory or
mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person
responsible for their safety.
Make sure you keep these instructions for use and
assembly in a safe place, so that you can hand them on
with the appliance if it ever changes owner.
Note: To avoid jeopardising the electrical safety of the
appliance, it is forbidden to use high-pressure or steam
jet cleaning devices.
SHOULD THE RELEVANT CONDITIONS NOT BE
PROPERLY SATISFIED, THE INSTALLER, AND NOT THE
MANUFACTURER, SHALL BE HELD LIABLE.
5Installation and connection
Statutory requirements
This installation must conform with the following:
■ Manufacturer’s Installation instructions
■ Local Gas Fitting Regulations
■ Municipal Building Codes
■ Refer to AS/NZS 5601.1 for Gas Installations
■ S.A.A. Wiring Code
■ Local Electrical Regulations
■ Any other statutory regulations
Preparing to install
Refer to AS/NZS 5601.1 for piping size details. These
built-in cooktops are intended to be inserted in a
benchtop cutout.
Only an officially authorised technician should connect
the appliance.
Before you begin, turn off the gas and electricity supply.
PLQ
¸
PLQ
PLQ
PLQ
3
en
a¸
a
a
Before connecting the unit, check whether the local
connection conditions (type of gas) are compatible with
the unit’s setting. Observe any special conditions
imposed by local suppliers (utilities). The specifications
of this cooktop are stated on the data label located on
the bottom of the cooktop base.
A duplicate data label is supplied for adhesion to an
accessible location near the hotplate if the data label on
the base of the hotplate cannot be accessed when the
hotplate is installed.
Clearances
A range hood fitted above the top must be installed
according to the installation instructions for the range
hood. A minimum distance of 650 mm is required for a
range hood and 750 mm for an exhaust fan.
Any adjoining wall surface situated within 200 mm from
the edge of any hob burner must be a suitable noncombustible material for a height of 150 mm for the
entire length of the hob. Any combustible construction
above the hotplate must be at least 650 mm above the
top of the burner and no construction shall be within
450 mm above the top of the burner.
PLQ
PLQ
PD[
PLQ
PLQ
PLQ
PD[
If an oven is positioned below the cooktop the barrier
does not need to be fitted, but a space of 35 mm must
be maintained between the underside of the cooktop
and the top of the oven.
Installation of cooktop into the kitchen bench
Side clearances: If the distance measured from the
periphery of the nearest burner to any vertical surface is
less than 200 mm, the surface shall be protected in
accordance with clauses 6.10.1.2 of AS/NZS 5601.1.
For cutout dimensions and clearances see Preparing to
install
.
Installation procedure:
The adhesive seal provided prevents leaks. Adhere it to the
work surface around the cut-out. It must be adhered around
the edge of the area cut out.
PLQ
PLQ
A minimum depth of 50 mm from the top of the worktop
surface must be provided for the appliance.
If the base of the hotplate can be touched, a protecting
shield must be fitted.
The shield must be at least 10 mm from the lowest part of the
hotplate and must be capable of withstanding the appliance
temperatures. Minimum thickness of benchtop is 30 mm.
After installation of the shield the clearance around the
top and sides of shield will allow adequate ventilation.
Ensure the side and top clearances are not obstructed.
Fitting the appliance onto the kitchen unit:
1. Place the cooktop in the correct position then loosen
each of the clips so that they all turn freely (it is not
necessary to completely undo them).
2. Insert and centre the cooktop.
Press the sides of the cooktop until it is supported
around its entire perimeter.
3. Turn the clips and tighten them fully.
The position of the clips depends on how thick the work
surface is.
4
Loading...