Bosch DPH30652UC User Manual [en, es, fr]

Boschventilation

DPH36652UC - DPH30652UC

useandcaremanual

IMPORTANT SAFETY INSTRUCTIONS

Read All Instructions Before Using the Appliance.

READ AND SAVE THESE INSTRUCTIONS

WARNING
TO REDUCE THE RISK OF A RANGE TOP
GREASE FIRE.

a) Never leave surface units unattended at high

settings. Boilovers cause smoking and greasy
spillovers that may ignite. Heat oils slowly on
low or medium settings.

b) Always turn hood ON when cooking at high heat

or when flambeing food (i.e. Crepes Suzette,
Cherries Jubilee, Peppercorn Beef Flambe’).

c) Clean ventilating fans frequently. Grease

should not be allowed to accumulate on fan or
filter.

d) Use proper pan size. Always use cookware

appropriate for the size of the surface element.

WARNING
TO REDUCE THE RISK OF INJURY TO
PERSONS, IN THE EVENT OF A RANGE TOP
GREASE FIRE, OBSERVE THE FOLLOWING:

a) SMOTHER FLAMES with a close-fitting lid,

cookie sheet, or other metal tray, then turn off
the gas burner or the electric element. BE
CAREFUL TO PREVENT BURNS. If the flames
do not go out immediately, EVACUATE AND
CALL THE FIRE DEPARTMENT.

b) NEVER PICK UP A FLAMING PAN - you may

be burned.

c) DO NOT USE WATER, including wet dishcloths

or towels - a violent steam explosion will result.

d) Use an extinguisher ONLY if:

1) You know you have a class ABC
extinguisher, and you already know how to
operate it.

2) The fire is small and contained in the area
where it started.

3) The fire department is being called.

4) You can fight the fire with your back to an
exit.

FOR GENERAL RESIDENTIAL KITCHEN
VENTILATING USE ONLY. TO AVOID A FIRE OR
EXPLOSION HAZARD DO NOT USE TO
EXHAUST HAZARDOUS OR EXPLOSIVE
MATERIALS OR VAPOR.

For indoor use only.
Note: The appliance referred to throughout this

manual is manufactured by BSH Home Appliances
Corporation.

When children become old enough to use the
appliance, it is the legal responsibility of the
parents or legal guardians to ensure that they
are instructed in safe practices by qualified
persons.
WARNING: Whenever possible, do not operate

blower during a cooktop fire. However, DO NOT
REACH THROUGH FIRE TO TURN OFF
BLOWER.

TABLE OF CONTENTS

Important safety instructions 2
Features 3

Control panel 4
Care and cleaning 5-6
Customer service 6-7

2

1. Blower and lights controls

2. Light shield
CAUTION! Use ONLY 120 Volt, 40 Watt (maximum)

olive shaped, made for a E14 base, suitable for use in
open luminarie.

FEATURES

1

2

3

4

3

3. Grease filter handle

4. Grease filter

3

Light ON-OFF
Rocker switch

Control panel

Blower OFF/low/high
Rocker switch

FAN Control

Set Blower Rocker switch to Low or high blower
speed as needed.

ALWAYS USE THE HIGH SETTING WHEN
GRILLING.

For Best results

• Continuous use of the fan system while cooking
helps keep the kitchen comfortable and less
humid.

• It also reduces cooking odors and soiling
moisture that create a frequent need for
cleaning.

• Turn the blower on before starting to cook.

• Use a rear burner when browning or pan frying
meat.

• Open a window or inside door slightly.

• Clean the filters and the wall behind the filters
frequently.

• The blower should be turned on for a few
minutes before cooking in order to establish air
currents up-ward through the hood. Thus when
heat, smoke, moisture, grease and cooking
odors are produced, they will be carried outside
instead of drifting into other rooms.

• Use the low speeds for normal use and the
higher speeds for strong odors or fumes.

• Drafts across the range or cooktop will cause
the escape of heat, smoke, moisture, grease
and cooking odors from the hood. Such drafts
should be prevented in so far as possible.

• The best job of ventilation in the kitchen is done
where the only air currents are those created by
the blower itself.

• For Gas Cooktops, a lower blower speed
should be used if:

• the gas flame is being distorted by the air

movement.

• the burner continually sparks (clicks)

• the burner flame repeatedly blows out.

LIGHT Control

Set Light ON-OFF Rocker switch to switch ON or
OFF the lights.

4

CARE AND CLEANING

The efficiency of the range hood system depends on the cleanliness of the intake and filters.
The frequency of cleaning depends on the amount and type of cooking.

• Do not use the ventilating system without the filters in place or with grease-laden filters or surfaces.

WARNING To avoid risk of fire and explosion do not use flammable liquids or solvents.
Always unplug or disconnect the appliance from the power supply before servicing.
WARNING: Be sure the entire hood (including the filters and light bulbs) has cooled and grease has
solidified before attempting to clean any part of the appliance.

Filters

These hoods have reusable metal grease filters.
The metal filters also help prevent flaming foods on
the cooktop from damaging the inside of the hood.
For this reason, the metal filters must
in place when the hood is used.

To Clean Filters

• The metal filters should be cleaned once a
month, or as needed.

• To clean the metal filters, drain and wipe all
excess grease with a dry paper towel. Soak
them and then swish them around in hot water
and detergent. Don’t use ammonia or ammonia
products because they will darken the metal.

• Do not use abrasives or oven cleaners. Rinse,
shake and let them dry before replacing. They
may also be cleaned in an automatic
dishwasher.

ALWAYS

be

To Remove The Metal Grease Filters

• Turn the fan and lights off.

• Push each handle towards the back and pull
downwards.

To Replace The Metal Grease Filters

• Reverse procedure.

LIGHTS

CAUTION:

Before replace the lamps, switch power off at
service panel and lock service panel disconnecting
means to prevent power from being switched on
accidentally.

NOTE: Turn off the lights and fan. Allow the
lights to cool before handling. If new lights do
not operate be sure lights are inserted correctly
before calling service.

Fig. 1

Replace Lights

• Use a little flat blade screw driver or similar tool
as a lever to remove the pin that fixes the light
shield to the body of the hood , and remove it
carefully from its housing.

• Remove the damaged light (turn counter
clockwise) and replace with a new 120 Volt, 40
Watt (maximum) olive shaped, made for a E14
base, suitable for use in open luminarie.

5

CARE AND CLEANING

• Always use the mildest cleaner that will do the job. Use clean, soft cloths, sponges or paper towels.

• Rub stainless steel finishes in the direction of the grain. Wipe area dry to avoid water marks.

• After cleaning, place all parts in their proper positions before using.
The cleaners recommended below indicate a type and do not constitute an endorsement. Use all
products according to package directions.

Care and Cleaning Chart

A

B

C

D

E

Anodized

Aluminum

surfaces

Aluminum

Mesh Filters

Plastic

surfaces

Painted surfaces

Stainless

Steel Surfaces

Top cap is not removable. Wash top and underside with hot sudsy water.
Rinse and wipe dry or apply Fantastic® or Formula 409® first to a clean
sponge or paper towel and wipe clean. DO NOT USE powdered cleansers or
steel wool pads.

Clean filters in the dishwasher or by agitating in sudsy water. Ensure that
there is no soil trapped in the fine mesh. Dry the filters before reinstalling
them.

DO NOT REMOVE control knob. Wipe with a moist soapy sponge. Rinse
and dry.

For general care, wipe the outside of the hood with sudsy water or household
cleaners such as Fantastic or Formula 409, rinse well and dry with a clean
soft cloth to avoid water marks.

DO NOT USE powdered cleansers or steel wool pads.

Wipe and dry stainless steel in the same direction as the grain. Avoid using
too much pressure, which may mar the surface. To remove finger prints and
give added shine, use cleaners such as Stainless Steel Magic. Do not allow
any cleaning compounds to remain in contact with stainless steel for
extended periods.

CUSTOMER SERVICES

Before Calling for Service

If the blower does not operate:

• Ensure that the electrical cord is properly connected and the supply circuit is energized.

• Check that the intake is fully raised.

• Make sure that the blower speed control knob is not in the OFF position.

How to Obtain Service

For authorized service or parts information, call 1-800-994-2904.
We want you to be a satisfied customer. If a situation arises that has not been resolved to your satisfaction, please
let us know.
Write: Customer Support, BSH Home Appliances, Corp. 5551 McFadden Ave., Huntington Beach, CA 92649,
or call: 1-800-994-2904.
Please include the model number, serial number, and date of original purchase/installation.

6