Bosch D130 Specsheet
Intrusion Alarm Systems | D130 Auxiliary Relay Module
D130 Auxiliary Relay Module
www.boschsecurity.com
u 12 VDC or 24 VDC relay
u Allows switching of current or voltage
u Two non-latching Form C dry contact outputs
The D130 Auxiliary Relay Module can be used with all
Bosch Security Systems control panels. The relay
module consists of a 12 VDC or 24 VDC relay. This
device allows the system to handle larger amounts of
current or different voltages that are beyond the
control panel's auxiliary power rating, or the rating of
modules such as the D8129 OctoRelay.
Notice
A UL Listed, 12 VDC or 24 VDC auxiliary power
supply is required to supply power to the D130's
coil.
The relay is polarized and has two sets of non-latching
Form C contacts. When the contacts are in the inactive
state, the normally-closed terminal has continuity with
the common terminal. When the contacts are in the
active state, the normally-open terminal has continuity
with the common terminal. The relay is activated by
switching polarity. A red LED lights to indicate the coil
is energized.
u Red LED shows coil is energized
u Mounts in control panel enclosure
System overview
Initiating Circuit Application
The D130 is commonly used with a D125B Dual Class
B Initiating Module and a UL Listed 24 VDC power
supply. In this configuration power to the detectors
can be interrupted by a command from the fire alarm
control panel (FACP).
Certifications and approvals
Region Certification
USA UL APOU: Proprietary Alarm Units
(UL1076), UOJZ: Control Units, System
(UL864, 9th edition)
FM
CSFM see our website
FDNY-
#6174 UL 864 9th Edition
CoA
FDNY-
6059 [D9412GV3 & D7412GV3]
CoA
NYC-
12-92-E, Vol. 12 12-92-E, Vol. 12
MEA
2 | D130 Auxiliary Relay Module
Region Certification
NYCMEA
NYCMEA
12-92-E, Vol. 15 12-92-E, Vol. 15
12-92-E, Vol. II 12-92-E, Vol. II
Installation/configuration notes
Compatible Products
The following products are compatible with the D130
Auxiliary Relay Module:
Category Product
ID
Control Panels All Bosch Security System control panels and FACPs
Modules D125B Dual Class B initiating module
D8129 OctoRelay module
Power Supplies D9142F 24 VDC auxiliary power supply
Product Description
Mounting
The D130 Auxiliary Relay Module attaches to a
mounting plate for easy mounting in any enclosure.
The assembly can be mounted in the control panel's
enclosure by means of supplied screws.
Wiring Considerations
The D130 can connect directly to the FACP or can
connect through a D8129 OctoRelay Module. Refer to
the installation instructions for the FACP or the D8129
for specific wiring requirements.
Ordering information
D130 Auxiliary Relay Module
12 VDC or 24 VDC relay. Allows switching of current or
voltage.
Order number D130
Parts included
Quantity Component
1 D130 module
1 Mounting plate
1 Hardware pack
1 Literature pack
Technical specifications
Properties
Dimensions: 2.75 in. x 3.0 in. (7 cm x 7.6 cm)
Outputs
Rating: 10 mA at 5 VDC mimimum
Type: Two non-latching Form C
5 A at 30 VDC maximum
Power Requirements
Current: 60 mA maximum
Voltage (operating): 12 VDC or 24 VDC nominal
Loading...