BMW M Coupe User Manual

Installation Instructions

Page 1 of 10
January 2009

Audio, Alarm Ver. 3.0 Accessory

Development

These installation instructions supersede all previous versions

SUBJECT

ALARM KIT - P/N 65 73 0 444 089

MODEL

1 Series Coupe (E82): Select Vehicle Production 12/07 – 02/09*

* Vehicle must have optional alarm pre-wiring (SA 5GA), which is 100% option for US spec vehicles.

SUGGESTED INSTALLATION TIME: 1.0 HOUR**

** Suggested installation time includes re-coding of the vehicle only for this retrofit kit. This time is based on a

vehicle that is at the current software level and does not require any updates. Before installing this accessory
into the vehicle, the vehicle should be checked for software updates. If updates are avail able the vehicle should
be programmed prior to installing this accessory. If vehicle is under warranty, the costs of programming

prior to retrofit should use defect code 72 60 93 02 00.

Please refer to SI B09 05 01 for latest BMW approved Retrofit coding procedures.

Please refer to SI B01 09 06 – Defect Code for Programming Prior to Accessory Retrofit

Total installation time may vary depending on vehicle options and equipment.

The instructions below are developed for BMW vehicles and are not to be compared to any other existing
instructions for vehicles other than BMW. No methods other than those specified in this docu ment are to be
used for installation in BMW vehicles. Left and right are determined from the driver’s seat.

Carefully read all instructions and supplements before proceeding with the installation. Reference should be
made to TIS for instructions dealing with a stock part of the vehicle but not stated in detail in these instructions.

The instructions were complete and up to date at time of publication; however, changes to the vehicle or
installation may have occurred. Please report any problems or changes noted with the installation to BMW
Technical Hotline, along with VIN, date of manufacture and as much detail as possible.

  DO IT RIGHT THE FIRST TIME, ON TIME, EVERY TIME  

Installation Instruction P/N 01 29 0 444 091
2009 BMW of North America, LLC Installation Instruction P/N 01 29 0 444 091

2

PARTS INFORMATION

Contents of Kit - P/N 65 73 0 444 089

Description Qty BMW Part Number

Bracket for Hood Switch 1 61 31 6 932 791
Mounting Plate 1 65 75 6 936 588
Bracket for Alternate Power Siren 1 65 75 6 940 124
Alternate Power Siren/Tilt Sensor 1 65 75 9 124 581
Screw ST 4.8x13 1 07 11 9 906 163
Ultrasonic Module Interior Sensor 1 65 75 9 149 671
Hood Switch 1 61 31 9 119 052
Hex Nut M6 w/captive washer 4 07 12 9 904 008
Hex Bolt M6x18 w/washer 2 07 12 9 904 868

Interior Ultrasonic Module Installation

3

1. Disconnect negative battery terminal.

2. Remove ceiling light cover (1) from ceiling
light housing (2) using Special Tool 00 9 341.
Refer to TIS 63 31 004.

3. Install ultrasonic module (1) into ceiling light
as shown.

4. Connect 8-position black connector (2) to
ultrasonic module (1).

5. Reinstall ceiling light cover to headliner.

Installation Instruction P/N 01 29 0 444 091