How it Works
Blomberg
Loading...
DW34110
Installation Manual
28 pgs2.19 Mb0

Blomberg DW14120, DW15110, DW14110, DW14140, DW15140 Installation Manual

...
Dishwasher
Installation Manual
USA
FOR MODELS
DW 14110 NBL00 DW 14120 NBL00 DW 14140 NBL00 DW 15110 NBL00 DW 15111 NBL00
DW 15120 NBL00 DW 15121 NBL00 DW 15140 NBL00 DW 15141 NBL00 DW 34100 NBL00
DW 34110 NBL00 DW 34120 NBL00 DW 34140 NBL00 DW 35100 NBL00 DW 35110 NBL00
DW 35120 NBL00 DW 35140 NBL00 DW 36100 NBL00 DW 36101 NBL00 DW 36110 NBL00
DW 36111 NBL00 DW 36120 NBL00 DW 36121 NBL00 DW 36140 NBL00 DW 36141 NBL00
Installation Manual
For Dishwasher Models
DW 14110 NBL00 DW 14120 NBL00 DW 14140 NBL00
DW 15110 NBL00 DW 15111 NBL00 DW 15120 NBL00
DW 15121 NBL00 DW 15140 NBL00 DW 15141 NBL00
To prevent accidents, which could cause serious injury or death, as well as machine damage read these instructions before installation and / or use.
Contents
1. IMPORTANT SAFETY INSTRUCTIONS..........................................................................................1
1.1 INSPECT THE DISHWASHER.........................................................................................2
1.2 HOW TO CONTACT US...................................................................................................2
2. TOOLS WHICH MAY BE NEEDED...................................................................................................3
3. MATERIALS WHICH MAY BE NEEDED
(Additional materials may be needed) ...............................................................................................3
4. MATERIALS SUPPLIED
(If parts are missing contact your dealer or our customer service department) ................................4
4.1 PARTS SUPPLIED ...........................................................................................................4
4.2 MANUAL BAG ..................................................................................................................4
4.3 DISHWASHER PARTS BAG 1 .........................................................................................4
4.4 DISHWASHER PARTS BAG 2 .........................................................................................4
5. DISHWASHER SPECIFICATIONS ...................................................................................................5
5.1 TECHNICAL FEATURES .................................................................................................5
6. ENCLOSURE PREPARATION .........................................................................................................5
6.1 ELECTRICAL PREPARATION .........................................................................................5
6.2 PREPARATION / INSTALLING MOUNTING BRACKETS................................................6
6.3 ADJUSTING HEIGHT.......................................................................................................7
6.3.1 INSTALLING THE FOOT SUPPORTS .............................................................................7
6.4 INSTALLING THE SIDE TRIM STRIPS ...........................................................................8
6.5 PREPARING THE WATER CONNECTION (A)................................................................9
6.5.1 INSTALLING THE 90° ELBOW FITTING (B) ...................................................................9
6.5.2 JUNCTION BOX PREPARATION (C)...............................................................................9
6.6 DRAIN PREPARATION ..................................................................................................10
6.6.1 UNDER THE SINK DRAIN .............................................................................................10
6.6.2 INSTALLING AN AIR GAP..............................................................................................10
6.3 DISPOSAL......................................................................................................................10
7. PLACEMENT OF DISHWASHER INTO THE OPENING................................................................11
7.1 DRAIN HOSE CONNECTION, WATER SUPPLY & ELECTRICAL CONNECTIONS.....11
7.1.1 DRAIN HOSE CONNECTION ........................................................................................11
7.1.2 WATER SUPPLY CONNECTION ..................................................................................12
7.1.3 BRAIDED HOSE/COPPER TUBING..............................................................................12
7.2 ELECTRICAL CONNECTION ........................................................................................12
7.2.1 GROUDING INSTRUCTIONS........................................................................................12
7.2.2 FASTEN JUNCTION BOX..............................................................................................14
7.3 READJUSTING FOOT LEVELS.....................................................................................14
7.4 ADJUSTING THE MOVABLE TOE KICK .......................................................................15
7.5 INSTALLING THE OUTER DOOR .................................................................................16
8. INSTALLER CHECKLIST ...............................................................................................................22
9. FINAL INSTRUCTIONS ..................................................................................................................22
10. SELF HELP HINTS .........................................................................................................................22
1. IMPORTANT SAFETY INSTRUCTIONS
In addition to these instructions, the dishwasher shall be installed:
= In accordance with all local codes or, in absence
of a local code,
=
In the United States, with the National Electric Code,
= In Canada, with the Canadian Electric Code
C22.1-latest edition/Provincial and Municipal codes and/or local codes.
WARNING
When installing the dishwasher, follow basic precautions, including the following:
INTRODUCTION
Please read this installation manual and particularly the safety instructions completely and carefully. They will save you time and effort and help to ensure optimum dishwasher performance.
Be sure to observe all listed warnings and cautions. Look particularly for the icons with exclamation marks inside. The information icon also will provide important references.
Read these installation instructions completely before installing and follow them carefully. Save these installation instructions and pass them on to any future user.
Ý
Notice :
= The dishwasher installation must be performed in
accordance with this installation manual. If you did not receive an installation manual, order it by calling 1-800-459-9848 or you may also download it from our web site at www.Blombergappliances.com
= Installation and repair should be performed by a
qualified installer. Work by unqualified persons could be dangerous and may void the warranty.
= Do not operate the appliance if damaged,
malfunctioning, partially disassembled or if it has missing or broken parts.
= Also follow the safety instructions of the user manual.
= To reduce the risk of electric shock, fire, or injury
to persons, the installer must ensure that the dishwasher is completely enclosed at the time of installation.
= Only connect the dishwasher to the power supply
when all installation and plumbing work is complete.
= If the dishwasher is installed in a location that
experiences freezing temperatures (e.g. in a vacation home, cabin, etc.), you must drain all the water from the dishwashers interior. Water system ruptures that occur as a result of freezing are not covered by warranty.
= Dishwasher must be secured to adjacent cabinetry
using the brackets provided. Failure to do this may cause damage to property or bodily injury.
= Connect to a properly rated, protected and sized
power supply circuit to avoid electrical overload. The dishwasher is designed for an electrical supply of 120 V (volts), 60 Hz (hertz), AC, connected to a dishwasher-dedicated, properly grounded electrical circuit with a fuse or breakers rated for 15 amperes. Electrical supply conductors shall be a minimum of # 14 AWG copper wire rated at 75 °C (167 °F) or higher. These requirements must be met to prevent injury and machine damage. Consult a qualified electrician if in doubt.
= Do not use any extension cord or portable outlet
device to connect the dishwasher to a power supply.
= Ensure that any plastic wrappings, bags, small
pieces etc. are disposed of safely and kept out of the reach of children. Danger of suffocation!
= Remove the door to the washing compartment
when removing an old dishwasher from service or discarding it. Ensure that the appliance presents no danger to children while being stored for disposal.
= Old appliances may contain materials that can be
recycled. Please contact your local recycling authority about the possibility of recycling these materials.
WARNING:Indicates a potentially hazardous
situation which, if not avoided, could result in death or serious injury.
CAUTION:Indicates a potentially hazardous
situation which, if not avoided, may result in injury. It may also be used to alert against unsafe practices.
Notice: Indicates a potentially hazardous
situation which, if not avoided, may result in damage to the dishwasher, the table­ware, the equipment or the environment.
1
CAUTION
WARNING
Ý
Notice
Ý
Notice :
After unpacking the dishwasher and prior to installation, thoroughly inspect the dishwasher for possible freight or cosmetic damage. Report any damage immediately.
Ý
Notice :
= Cosmetic defects must be reported within 10 days
of installation.
=
Do not discard any bags or items that come with the original package until after the entire installation has been completed.
= The dishwasher drain hose must be installed with
a drain loop at least 28" (710 mm) off the cabinet floor; otherwise the dishwasher may not drain properly.
=
This dishwasher is intended for residential use only, and should not be used in commercial establishments.
=
New installation - If the dishwasher is a new installation, most of the work must be done before the dishwasher is moved into place.
=
Replacement - If the dishwasher is replacing another dishwasher, check the existing dishwasher connections for compatibility with the new dishwasher, and replace parts as necessary.
1.1 INSPECT THE DISHWASHER
HOW TO CONTACT US :
You may either call our Toll Free Number at
1-800-459-9848 or contact us via the web site at www.Blombergappliances.com or Contact the
Blomberg Distributor for your State or Province as listed on the Distributor Contact List provided.
2
Hot Water Supply Line - Minimum 3/8" O.D. copper tubing or metal braided dishwasher supply line.
Shut-off valve and fittings appropriate for hot water supply line (copper tubing/compression fitting, or braided hose).
Electrical Supply Cable - Minimum #14AWG, 2 conductors, 1 ground, insulated copper conductors.
90° elbow with 3/8" N.P.T. male threads on one leg, and sized to fit your water supply line (copper tubing/compression fitting, or braided hose) on the other leg.
UL listed conduit connector or strain relief.
Teflon tape or other pipe thread compound to seal plumbing connections.
Slicone
Glue
2. TOOLS WHICH MAY BE NEEDED
3. MATERIALS WHICH MAY BE NEEDED
(Additional materials may be required to comply with local codes)
Pipe Wrench
Wire Cutter Drill
Hole Saw
Hammer Wire Stripper
Tape Measure
Torx Screwdriver Phillips Screwdriver
Adjustable Wrench
Scot Screwdriver
Scissors
Level Brush Pencil
(T20)
3
4. MATERIALS SUPPLIED
4.1 PARTS SUPPLIED
Parts for your dishwasher will come in several plastic bags. Check your parts bags shown to make sure you have all the parts as listed to the left.
4.2 MANUAL BAG
The dishwasher comes with a manual bag containing:
= User manual, = Installation manual and = Quick reference guide.
4.3 DISHWASHER PARTS BAG 1
This dishwasher bag comes with the following parts:
a. Side Trim Strips (Left) b. Side Trim Strips (Right) c. Adjusting Wrench d. Screws Ø
1
/8" x 5/8" (Ø 3.5 mm x 14 mm) e. Mounting Bracket Left f. Mounting Bracket Right g. Spring Clamp h. Screw Clamp
i. Short Legs j. Rubber Connector
k. Toe Kick Bracket - Left
l. Toe Kick Bracket - Right
m. Wire Nuts
n. Toe Kick (toe kick without slots) o. Toe Kick p. Plastic Caps r. Screws Ø
1
/8" x 5/8" (Ø 3.5 mm x 14 mm)
4.4 DISHWASHER PARTS BAG 2
In addition to the manual bag and the dishwasher parts bag 1 DW 34, DW 35 and DW 36 (dishwasher models which can accept a wooden kitchen door) also come with a door panel installation kit which contains:
s. Template
t. Screws Ø 1/8" x 5/8 (Ø 3.5 mm x 14 mm)
u. Screws Ø
3
/16" x 13/4 (Ø 4 mm x 43 mm)
4.5 PARTS ATTACHED TO THE REAR OF THE DISHWASHER
a. Side Trim Strips (Left) b. Side Trim Strips (Right) n. Toe Kick (toe kick without slots) o. Toe Kick
x1
x1
x2
x2
a.
b.
d.
e.
f.
g.
h.
j.
k.
l.
m.
n.
o.
p.
r.
t.
i.
s.
7
3 / 4
(196,5mm)
c.
u.
x1
x4
x1
x1
x1
x1
x1
x3
x1
x1
x10
x1
x4
x1
x1
x4
4
Ý
Notice :
=
For proper dishwasher operation and appearance ensure that the enclosure has the minimum dimensions shown in the figure
above.
WARNING
To avoid electrical shock and/or a fire hazard, make sure electrical work is properly installed. Only qualified electricians should perform electrical work.
Before installation disconnect the power supply to the work area by unplugging the unit, "tripping" the circuit breaker or removing the fuse.
The installer has the responsibility of ensuring that the dishwasher electrical installation is in compliance with all national and local electrical codes and ordinances. The dishwasher is designed for an electrical supply of 120 V, 60 Hz, AC, connected to a dishwasher-dedicated, properly grounded electrical circuit with a fuse or breaker rated for 15 amperes.
WARNING
Electrical supply cords must be a minimum #14AWG copper wire.
Position the cable extending approximately 30" (760 mm) from the enclosure's back (Figure A).
Ý
Notice
5.1 TECHNICAL FEATURES
5. DISHWASHER SPECIFICATIONS
6. ENCLOSURE PREPARATION
6.1 ELECTRICAL PREPARATION
32
1
/
4
-34
1
/
4
(819mm - 870mm)
24
(610
mm
)
24
(610
mm
)
23
9
/
16
(598mm)
24 max
(610mm max)
32
1
/
2
- 34
1
/
4
(825mm - 870mm)
Load capacity 12 place settings
Permissible water pressure 4.35 - 145 psi (0.3 - 10 bars)
Electrical connection 120 V (volts), 12 A (amps), 60 Hz (hertz)
Total power 1200 W (watts)
Heater power 1000 W (watts)
Figure A
Because we continually strive to improve our products, we may change our specifications and design without prior notice. This device corresponds to the following directives:
UL 749 Household Dishwasher directive.
5
Loading...
+ 19 hidden pages
Buy Points How it Works FAQ Contact Us Questions and Suggestions Privacy Policy Cookie Policy Terms of Use