Blaupunkt ODENSE AR 28 User Manual

Radio

Odense
AR 28

Operating instructions

L

O

R

T

N

O

C

E

C

N

IE

N

E

V

N

ARI

ARI

O

C

E

V

N

O

C

m

-

lo

m

-

lo

L

O

R

T

N

O

C

E

C

N

IE

N

lo

m

lo

m

ODENSE AR 28

ODENSE AR 28

E

M

U

L

O

V

E

M

U

L

O

V

E

N

O

T

E

N

O

T

FM-T

FM-T

1-5

1-5

1

L

TRO

N

CE CO

IEN

VEN

N

CO

IEN

VEN

N

CO

m

-

lo

m

-

lo

CE CO

L

TRO

N

lo

m

lo

m

VOLUM

VOLUME

ODENSE AR 28

ODENSE AR 28

E

TONE

TONE

FM-T

FM-T

1-5

1-5

ARI

ARI

2

8

7 6 5 4

3

3

Table of Contents

Important information.................. 10

Traffic safety ......................................... 10

Installation / Hook-up ............................ 10

Radio operation............................ 10

Station search ....................................... 10

Manual station search ........................... 10

Adjusting station search sensitivity

for FM.................................................... 10

Stereo - mono switch ............................ 10

Storing stations ..................................... 11

Storing the strongest stations

automatically ......................................... 11

Recalling stored stations....................... 11

Traffic messages (ARI) ................ 11

Appendix....................................... 12

Technical data....................................... 12

8

Legend

1 On/off

Turn knob.
On
Off
Adjust volume:
Turn knob.

2 Display for

frequency range

frequency
memory bank

channel preset

stereo
manual fine

tuning
sensitivity

(station search)

3

Station selection

automatic or manual (“m” in display).
Switch over by pressing lo • m 4

4 lo • m

Changing the search tuning sensitivity
for FM stations
Io lit up in the display indicates normal
sensitivity for the station search functi­on.

Io not lit up in the display indicates high
sensitivity for the station search functi­on.

m lit up indicates manual station fine
tuning.
To change: Press button briefly.

Added feature:
Switch over from stereo to mono:
Press lo • m for longer than 2 seconds
and release.

5 ARI (traffic messages)

When ARI is visible in the display, you
are able to tune into only those radio
stations which broadcast traffic messa­ges.

6 1- 5

For storing and recalling radio stations

7 FM•T (frequency modulation)

Switch for the FM memory banks I, II,
III and “T” (Travelstore) - for storing and
recalling the six nearest, strongest stati­on signals.
Store “T”:
Press FM•T until the search begins in
the display.
Recall “T”:
Press FM•T until T appears in the dis­play. Then press the station button qui­ckly and repeatedly if necessary.

8 TONE

Adjust tone.

more bass
more treble

DEUTSCH

ENGLISH

FRANÇAIS

ITALIANO

NEDERLANDS

SVENSKA

ESPAÑOL

9

PORTUGUÊS

Important information

Radio operation

Traffic safety

As the driver of a motor vehicle, it is your
responsibility to pay attention to the traffic
situation at all times. Never use your car radio
in a way that could distract you. Should the
traffic situation become particularly deman­ding, we would advise you not to use the
radio. Please keep in mind that you travel a
distance of 14 m per second at a speed of
only 50 km/h. When adjusting the volume,
make sure that you are still able to hear
sounds coming from outside of the vehicle,
so that you are always able to react to war­ning signals.

Installation / Hook-up

If you would like to install your new car radio
yourself or add other audio components to
the existing ones, then please read the enclo­sed instructions on installation and hook-up
carefully.
Do not ground the loudspeaker outputs!
Use only Blaupunkt-certified accessories and
spare parts.

With this car radio you can receive FM fre­quencies ranging from 87.5 to 108 MHz.

Station search

m should not be lit up in the display. If it is,

switch it off by pressing lo • m

•

If you hold the button pressed, the search
function will forward quickly.

press right or left.
The car radio will automatically tune
into the next station.

Manual station search

m (manual) must be lit up in the display. If it

is not, switch it on by pressing lo • m.

•

If you hold the button pressed, then the
frequencies will move up or down more
quickly.

press right or left quickly.
The frequency will move up or down in
short intervals.

Adjusting station search sensiti­vity for FM

You can adjust the sensitivity of the automa­tic station search.

• Press lo • m.
When “Io” is visible in the display, then
only those stations with relatively strong
signals will be picked up (low sensitivi­ty).
When “Io” is not visible in the display,
then stations with weaker signals will
also be picked up (high sensitivity).

Stereo - mono switch

If you would like to switch between stereo
and mono reception:

• Press lo • m for approximately 2 se-
conds and release.
During mono reception the stereo sym-

will disappear from the display.

bol

Each time the car radio is switched on, the
reception will automatically be set to stereo.
The radio will automatically switch to mono
when the reception conditions are poor.

10

Traffic messages (ARI)

Storing stations

For each memory bank (I, II, III, T) you can
store up to five stations using the button 1-5.

• For FM select the memory bank by
pressing FM•T.

• Select the button 1-5 to store the new
station and press it.

• Press
want to store (automatically or manual­ly).

• Press the button 1-5 and hold it. First
the station will be muted and then be­come audible again.

The station has been stored in the memory
bank.
The corresponding memory bank and the
button preset will appear in the display.

Note:

If you tune into a station which has already
been stored, then the corresponding button
preset and the memory bank will flash in the
display for approximately 5 seconds.

to tune in the station you

Storing the strongest stations
automatically

(Travelstore)

In your reception area you can automatically
store the five nearest FM stations, sorted
according to their frequencies.
This feature is particularly useful when you
are travelling.

• Press FM•T for at least 2 seconds.
The radio will search for the nearest FM
stations and store them in the memory
bank “T” (Travelstore). When the pro­cess has been completed, the first stati­on will be set.

If you wish, you can also store stations in the
Travelstore memory bank manually.

Recalling stored stations

You can recall the stored stations by pressing
the corresponding buttons.

• Select the memory bank.
Press FM•T until I, II, III or T appears in
the display.

• Select the station by pressing the but­ton 1-5, press repeatedly if necessary.

Many FM stations broadcast traffic news for
their reception area at regular intervals. Sta­tions using the ARI system broadcast an “ARI
signal” during their programmes, so that your
car radio can recognize them. Another signal
is broadcast to indicate the beginning and
end of a traffic message. These traffic mes­sages are broadcast at a preset volume. If
you are playing a cassette, it will be interrup­ted until the traffic message has ended and
will then resume operation.

Switching the traffic messages (ARI) on
and off

If you want to switch the reception of traffic
messages (ARI) on or off

• Press ARI.
ARI will light up in the display, when the
reception is switched on.

Now the radio will only pick up those stations
broadcasting the ARI signal.

Warning beep

Should you leave the reception area of the
station you are tuned to, then you will hear a
warning beep after approximately 30 se­conds. If you should press a button preset for
a station which does not broadcast the ARI
signal, then you will also hear a warning
beep.

DEUTSCH

ENGLISH

FRANÇAIS

ITALIANO

NEDERLANDS

SVENSKA

ESPAÑOL

11

PORTUGUÊS

Appendix

Switching the warning beep off

a) Tune to a different station broadcasting

the ARI signal:

• Press

• select a stored station with the ARI
signal by pressing the button preset
1-5.

or
b) Switch the traffic message priority off:

• Press ARI.

or

Technical data

Amplifier:

Output power: 2 x 5.5 W RMS power

according to DIN 45324/

3.1 at 4 Ω

FM:

Sensitivity: 1.3 µV at 26 dB

S/N ratio

Response: 35 - 15 000 Hz (-3 dB)

12

Information subject to change!

Illustrationen • Illustrations • Ilustraciones • Illustrazioni • Illustrationer • Afbeeldingen • Ilustraçoes

L

R

5A

L

L

F

R

F

R

L

R

R

R

LR

LF

RF

RR

58,5

150

8 601 310 742

50

182

53

165

5,2-6,3

188

)

V

+

)

2

–

1

A

N

D

N

(

N

R

IO

N

8 908 603 223

E

W

O

P

A

+12V

5A

U

IT

. +

E

O

T

N

C

R

N

IG

G

AC

(

+12V

+12V

+12V

+12V

+12V

Kl. 30

V

2

1

+12V

Blaupunkt-Werke GmbH

Bosch Gruppe

9/99 K7/VKD 8 622 401 404

8

Amplifier

5A

L

L

F

R

F

R

L

R

R

R

Equalizer

Fader

8 601 910 002

1

2

1

2