These instructions contain important information to easily and safely install and operate the device.
•
Read these instructions carefully and
completely before using the device.
•
Keep the instructions at a location so
that they are always accessible to all
users.
•
Always pass on the device to third parties together with these instructions.
In addition, observe the instructions of the
devices used in conjunction with this device.
Symbols used
Use as directed
This device is intended for installation and
operation in a vehicle with 12 V vehicle system voltage and must be installed in a DIN
slot. Observe the 'performance limits in the
technical data. Repairs and installation, if
necessary, should be performed by a specialist.
Declaration of conformity
The Blaupunkt GmbH declares that the
Kingston MP47 device complies with the
basic requirements and the other relevant
regulations of the directive 89/336/EWG.
ENGLISH
These instructions employ the following
symbols:
CAUTION!
Warns about laser beam
CAUTION!
Warns about damaging the CD
drive
The CE mark confi rms the compliance with EU directives.
Identifi es a sequencing step
쏅
Identifi es a listing
•
43
For your safety
For your safety
The device was manufactured according to
the state of the art and established safety
guidelines. Even so, dangers may occur if
you do not observe the safety notes in these
instructions:
If you are installing device
yourself
You may only install the device yourself if
you are experienced in installing car sound
systems and are very familiar with the electrical system of the vehicle. For this purpose, observe the installation instructions
at the end of these instructions.
Observe the following!
CAUTION
The device contains a Class 1 laser
that can cause injuries to your eyes.
Do not open the device and do not perform
any modifi cations.
In operation
Operate the device only if traffi c situa-
•
tion permits it! Stop at a suitable location to perform more extensive operations.
Remove or attach the control panel only
•
while the vehicle is standing an.
To protect your hearing, always listen
•
at a moderate volume. During mute
phases (e.g. when changing the audio
source or CD in the CD changer and
DANGER
Increased risk of injury from plug.
In case of an accident, the protruding connector in the front AUX-IN socket may
cause injuries. The use of straight plugs or
adapters can lead to an increased risk of injury.
For this reason, we recommend using angled jack plugs, e.g. the Blaupunkt accessories cable (7 607 001 535).
Travelstore), changing the volume is
not audible. Do not increase the volume
during this mute phase.
Always listen at a moderate volume so
•
that you can always hear acoustic warning signals (e.g. police).
After operation
The device is worthless to a thief with-
•
out the control panel. Always remove
the control panel whenever you leave
the vehicle.
Transport the control panel so that it is
•
protected against impacts and the contacts cannot become dirty.
44
For your safety Scope of delivery
Cleaning instructions
Solvents, cleaning and scouring agents as
well as dashboard spray and plastics care
product may contain ingredients that will
damage the surface of the device.
Use only a dry or slightly moistened cloth
for cleaning the device.
Disposal of old unit
(EU countries only)
Do not dispose of your old unit in the
household trash!
Use the return and collection systems available to dispose of the old device.
Scope of delivery
The scope of delivery includes:
1 Car sound system
1 Case for the control panel
1 Support frame
2 Disassembly bar
1 Guide pin
1 USB connecting cable
1 Operating instructions
Optional equipment
(not part of the scope of delivery)
Use only accessories approved by
Blaupunkt.
ENGLISH
Remote control
The steering wheel and/or handheld remote
control allows you to access the basic functions of your car sound system safely and
conveniently.
You cannot switch the device on/off using
the remote control!
You can fi nd out from your Blaupunkt dealer
or on the Internet at www.blaupunkt.com
which remote controls can be used with
your car sound system.
Amplifi er
You can use all Blaupunkt and Velocity amplifi ers.
CD changers
You can connect the following Blaupunkt
CD changers:
CDC A 03, CDC A 08 and IDC A 09.
45
Warranty Detachable control panel
Warranty
We provide a manufacturer's warranty
for products bought within the European
Union. Devices purchased outside the
European Union are subject to the warranty
terms published by our respective regional
agency.
The warranty terms can be called up under
www.blaupunkt.com or requested directly
from:
Blaupunkt GmbH
Hotline
Robert-Bosch-Str. 200
D-31139 Hildesheim, Germany
Service
In some countries, Blaupunkt offers a repair
and pick-up service.
Information about the availability of this
service in your country can be found at
www.blaupunkt.com.
If you want to take advantage of this service, you may request a pick-up service for
Detachable control panel
Theft protection
The device is equipped with a detachable
control panel (fl ip-release panel) as a way
of protecting your equipment against theft.
The device is worthless to a thief without
this control panel.
Protect your device against theft by taking
the control panel with you whenever you
leave your vehicle. Do not leave the control
panel inside your vehicle - not even in a hiding place.
Notes:
•
Never drop the control panel.
•
Do not expose the control panel to direct sunlight or another heat source.
•
Avoid direct skin contact with the
control panel’s electrical contacts. If
necessary, clean the contacts with a
lint-free cloth moistened with cleaning alcohol.
your device via the Internet.
Detaching the control panel
Press the button 1.
쏅
The control panel opens to the bottom.
Hold the control panel by its right side
쏅
and then pull it straight out of the
bracket.
46
Detachable control panel
Notes:
The device is switched off after a time
•
preset by you. For further details,
please read the section "Switch-off
time (OFF TIMER)" in this chapter.
The device remembers the audio
•
source played last for the next switchon.
Any CD already inserted in the device
•
remains there.
Attaching the control panel
Switch-off time (OFF TIMER)
After opening the control panel, the device
is switched off after an adjustable time. You
can set this time from 15 to 30 seconds.
Press the MENU/OK button ;.
쏅
Press the
쏅
until the displays shows "OFF TIMER".
Press the MENU/OK button ; to open
쏅
the menu.
쏅
Set the time with the
When you have fi nished making your changes,
press the ESC/DIS button 5.
쏅
or button < repeatedly
or button <.
Timeout function
ENGLISH
2.
1.
Hold the control panel approximately
쏅
at a right angle to the device. (see fi gure, 1.)
Push the control panel into the guides
쏅
at the bottom edge of the device.
Push the control panel carefully into the
쏅
bracket until it clicks into place.
Fold the control panel up into the slot
쏅
and press it gently into place until it
clicks. (see fi gure, 2.)
If the device was still switched on when you
detached the control panel, it will automatically switch on with the last setting activated (radio, CD, CD changer, USB or AUX)
The device features a time-out function
(time window).
For example, if you press the MENU/OK
button ; and select a menu item, the device switches back after approx. 8 seconds
after the last button activation. The settings
performed are saved.
when the panel is replaced.
47
Switching on/off Volume
Switching on/off
There are various ways of switching the device on/off:
Switching on/off with the On/Off button
For switch-on, press the On/Off but-
쏅
ton 3.
The device switches on.
To switch off the device, press and hold
쏅
down the On/Off button 3 for longer
than two seconds.
The device switches off.
Switching on/off using the vehicle
ignition
The device will switch on/off simultane-
Adjusting the volume
You can adjust the volume in increments
from 0 (off) to 66 (maximum).
To increase the volume,
turn the volume control 4 clockwise.
쏅
To decrease the volume,
turn the volume control 4 counter-
쏅
clockwise.
Setting the power-on volume
You can set the power-on volume.
Press the MENU/OK button ;.
쏅
Press the
쏅
edly until "ON VOLUME" appears on the
display.
or button < repeat-
ously with the ignition if the device is correctly connected to the vehicle’s ignition as
shown in the installation instructions and
you did not switch the device off by pressing the On/Off button 3.
Switching the device off using the
detachable control panel
Detach the control panel.
쏅
The devices switches off after the time set
in the "OFF TIMER" menu.
Note:
To protect the vehicle battery, the device will switch off automatically after
one hour if the ignition is off.
Press the
쏅
cifi c power-on volume, or the
9 to select the "LAST VOL" setting.
Set a specifi c power-on volume with
쏅
the
To help you adjust the setting more easily,
the device will increase or decrease the volume as you make your changes.
If you enable "LAST VOL", the volume which
was set the last time you switched off the
device is re-enabled.
Note:
To protect your hearing, the power-on
volume is limited to the value "38" for
the setting "LAST VOL". If the volume
was higher before switch-off, the value
or button <.
button 9 to adjust a spe-
button
48
is automatically set to "38" at switchon. This prevents an unintentionally
and unexpectedly high volume when
switching on the device.
Volume
When you have fi nished making your changes,
press the ESC/DIS button 5.
쏅
Quickly reducing the volume
(MUTE)
You can quickly reduce the volume to a preset level.
Briefl y press the On/Off button 3.
쏅
"MUTE" appears on the display.
Cancelling mute
To return to your previously set volume
level,
쏅
briefl y press the On/Off button 3
again.
Telephone Audio/Navigation
Audio
Muting during telephone mode
If your car sound system is connected with
a cell phone or navigation system, "picking"
up the phone or a voice output of the navigation system automatically mutes the car
sound system. The call or the voice output
is played back via the loudspeakers of the
car sound system. For this purpose, the cell
phone or the navigation system must be
connected to the car sound system as described in the installation instructions.
You can fi nd out from your Blaupunkt dealer
which navigation systems can be used with
your car sound system.
ENGLISH
Adjusting the mute level
You can adjust the mute level.
쏅
Press the MENU/OK button ;.
쏅
Press the
edly until "MUTE LVL" appears on the
display.
Press the MENU/OK button ; to open
쏅
the menu.
쏅
Set the mute level with the
ton <.
When you have fi nished making your changes,
press the ESC/DIS button 5.
쏅
or button < repeat-
or but-
If you answer a call or a navigation announcement takes place, the display shows
"TELEPHONE".
Adjusting the volume for telephone
audio/navigation audio
During a telephone call or a voice output of
the navigation, no traffi c announcements
are switched through. The traffi c announcement is not recorded!
You can set the volume level at which the
telephone calls or navigation announcements are mixed in.
쏅
Press the MENU/OK button ;.
쏅
Press the
until "TEL VOL" appears on the display.
or button < repeatedly
쏅
Press the MENU/OK button ; to open
the menu.
쏅
Set the desired volume with the
button <.
or
49
Volume
When you have fi nished making your changes,
ess the ESC/DIS button 5.
pr
쏅
Note:
You can use the volume control 4 to
adjust the volume of telephone calls
and navigation announcements whilst
you are listening to them.
Switching the confi rmation beep
on/off
The system will output a confi rmation beep
for some functions if you keep a button
pressed down for longer than two seconds,
for instance, when assigning a radio station
to a station preset button. You can switch
the beep on or off.
쏅
Press the MENU/OK button ;.
Automatic Sound
This function automatically adjusts the volume of the car sound system to the vehicle
speed. For this purpose, the car sound system must be connected as described in the
installation instructions.
You can adjust the automatic sound in 6
increments from (0 - 5).
Press the MENU/OK button ;.
쏅
Press the
쏅
until "AUTO SD" appears on the display
with the current setting.
Press the MENU/OK button ; to open
쏅
the menu.
Set the automatic sound 0 - 5 with the
쏅
or button <.
When you have fi nished making your changes,
or button < repeatedly
쏅
Press the
until "BEEP ON" or "BEEP OFF" appears
on the display.
Switch the BEEP ON or OFF with the
쏅
or button 9.
When you have fi nished making your changes,
press the ESC/DIS button 5.
쏅
or button < repeatedly
press the ESC/DIS button 5.
쏅
Note:
The optimum setting for the speeddependent volume adjustment feature
depends on how noise levels develop in
your particular vehicle. Determine the
perfect value for your vehicle using trial
and error.
50
Loading...
+ 28 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.