12
Note: Specifications are subject to change for improvements.
SPECIFICATIONS WIRELESS OPERATION GUIDE
1
1.Power Supply.................................................................... AC 230V/50Hz
2.Total Power Consumption......................................................................100W
3.Subwoofer Power Output ........................................................................50W
4.Soundbar Power Output ....................................................................2 x 25W
5.Input Sensitivity (Subwoofer).................................................300mV 20mV
6.Input Sensitivity (Soundbar)...................................................750mV 50mV
7.Speaker Impedance (Subwoofer)..........................................................8 Ohm
8.Speaker Impedance (Soundbar)............................................................8 Ohm
9.S/N (A Weight)........................................................................................80dB
10.THD (1kHz, 1W)...................................................................................0.5%
11.Frequency Response(Subwoofer)...................................30Hz~150Hz 3dB
12.Frequency Response (Soundbar).................................200Hz~20KHz 3dB
13.L/R Separation (1kHz)..........................................................................30dB
14.L/R Balance (Stereo)........................................................................... 2dB
......
If the subwoofer is not linking properly with the soundbar or there is no
sound coming from the subwoofer please follow the below steps:
1) Switch off the soundbar and subwoofer.
3) Please repeat the above steps if the soundbar is not connecting to the
subwoofer wirelessly.
4) Once the above steps have been completed and the soundbar is
connected to the subwoofer the settings will automatically save and there
should be no need to follow the above steps again unless the product is
disconnected from the mains power.
2) Switch on the soundbar and then press the "STANDBY" button on the
remote control, this will put the soundbar into play-mode. Within 10
seconds you will need to switch on the subwoofer. Please wait a further
15 seconds while the coding is completed for the subwoofer to connect to
the soundbar wirelessly. (You can confirm this by the blue light on the front
of the subwoofer. If the soundbar and subwoofer are connected the blue
light will be solid but if it is flashing then the subwoofer is not wirelessly
connected to the soundbar).
Loading...