Black & Decker BDUH200C, 200UH User Manual

PLEASE READ AND SAVE THIS USE AND CARE BOOK. POR FAVOR LEA ESTE INSTRUCTIVO ANTES DE USAR EL PRODUCTO. VEUILLEZ LIRE ET CONSERVER CE GUIDE D’ENTRETIEN ET D’UTILISATION.
Utility Heaters Calentadores para uso general Radiateurs à usage général
Models/Modelos/Modèles
?
USA/Canada 1-800-231-9786 Mexico 01-800-714-2503
www.blackanddecker.com
Accessories/Parts
(USA/Canada)
1-800-738-0245
Accesorios/Partes
(EE.UU/Canadá)
Accessoires/Pièces (É.-U./Canada)
200UHPub1000002035 4/15/05 1:53 PM Page 1
2
1
WARNING: To reduce the risk of fire:
Keep combustible materials, such as furniture, pillows, bedding, papers, clothes and curtains at least 3 feet (0.9m) from the front, sides and rear of heater when the heater is plugged in.
Do not place heater near a bed, because objects such as pillows or blankets can fall off the bed and be ignited by heater.
Always unplug from electrical outlet whenever heater is not in use.
Avoid the use of an extension cord because it may overheat and cause a risk of fire. However, if an extension cord must be used, it shall be of a minimum size of 14 AWG and rated not less than 1875 watts.
When using any electrical appliances, basic precautions should always be followed to reduce the risk of fire, electrical shock, and injury to persons including the following:
Read all instructions before using heater.
Heater is hot when in use. To avoid burns, do not let bare skin touch hot surface. Unplug and let heater cool down for at least ten (10) minutes before moving it. Use handles provided.
Extreme caution is necessary when any heater is used by or near children or invalids, and whenever heater is left operating and unattended.
Do not operate any heater with a damaged cord or plug or after it malfunctions or is dropped or damaged in any manner. Return heater to the nearest authorized service facility for examination, repair, or electrical or mechanical adjustment. Or call appropriate toll-free number listed on the cover of this manual.
Do not use outdoors.
This heater is not intended for use in wet or moist locations such as bathrooms, laundry areas or similar indoor locations. Never locate heater where it may fall into a bathtub or other water container.
Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or similar coverings. Arrange cord away from traffic areas, and where it will not be tripped over.
To disconnect heater, press OFF button, then remove plug from outlet by pulling the plug, not the cord.
Do not insert or allow foreign objects to enter any ventilation or exhaust opening, as this may cause an electric shock or fire, or damage heater.
IMPORTANT SAFETY
INSTRUCTIONS
SAVE THESE INSTRUCTIONS.
A heater has hot and arcing or sparking parts inside. Do not use it in areas where gasoline, paint or flammable liquids are used or stored.
Use heater only as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock or injury to persons.
Avoid using heater when sleeping.
To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not use on soft surface, like bed, where openings may become blocked.
POLARIZED PLUG
This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of electric shock, this plug will fit into a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Do not attempt to modify the plug in any way.
TAMPER-RESISTANT SCREW Warning: This appliance is equipped with a tamper-resistant screw to prevent removal of the outer cover. To reduce the risk of fire or electric shock, do not attempt to remove the outer cover. There are no user-serviceable parts inside. Repair should be
done only by authorized service personnel.
SPECIAL ATTENTION:
The use of an extension cord is not recommended. However, if it is absolutely necessary, be sure that the cord is (1) No. 14 AWG minimum size and rated no less than 1875 watts; (2) UL Listed; (3) as short as possible (long cords can overheat, as well as trip circuit breakers); (4) not used for operating more than one appliance at a time.
Note: If the power supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard.
200UHPub1000002035 4/15/05 1:53 PM Page 2
How to Use
This appliance is intended for household use only.
Important: For warranty verification, do not remove line cord sticker. The Advanced Safety Technology™ (AST) system features unique technology built
into your heater that offers protection detailed in the "Special Features" section.
Before Use: Important:
During the first few minutes of initial use, you may notice a slight odor. This is normal and will quickly disappear. This heater is intended for use on a flat, stable surface, such as a floor, tabletop, shelf, or desk in a location where the airflow grille openings won’t be obstructed. Do not use in wet or moist locations, like bathrooms or laundry areas, or in areas where paint or other flammable or volatile liquids are used or stored.
Caution: Be sure no other appliances are plugged into same circuit with heater/fan. A circuit overload could occur.
1. Place heater on a flat, stable surface, such as a floor or tabletop where airflow grille opening won’t be obstructed. Use fold-down handle when moving unit. Do not use in wet/moist locations, like bathrooms or laundry areas, or in areas where paint, flammable, or other volatile liquids are used or stored.
2. Be sure control knob is in the OFF position, then plug heater into a standard AC outlet.
3. Room Select: Turn switch to the appropriate setting
for a small (approx. 10' x 10'/3 m x 3 m), medium (approx. 12'x12'/3.8 m x 3.8 m) or large (approx. 12'x 16'/3.8m x 5m) room (B)
4. Turn thermostat control to HOT to activate heater. Once desired room temperature is achieved, lower thermostat control toward FROST WATCH until unit cycles off.
The thermostat will cycle unit on and off to maintain your comfortable temperature level.
5. Turn timer knob to the 1 hr., 2 hr., 3 hr. or 4 hr. setting to select how long you’d like heater to stay on. The unit will shut off automatically once the selected time runs out. To operate heater continuously, turn timer knob to ON. Remember to shut unit Off when done.
6. To use as a fan without heat, move control knob to FAN ONLY and thermostat control toward HOT until fan begins to operate. No heating will occur in this mode.
7. To turn off, turn thermostat control to FROST WATCH and control knob to Off.
Note: The power indicator light shows heater is on and operating. It continues to glow even if thermostat has cycled off and heating elements are off.
8. Frost Watch: When heater is plugged in and POWER indicator light is on, you can select any setting for room size (depending on your model) and leave thermostat control on toward lower settings or FROST WATCH. Heater will remain off unless the temperature drops below (40° F/4°C). If this happens, FROST WATCH will automatically cycle unit on to protect against freezing pipes or frost damage.
4
3
Product may vary slightly from what is illustrated.
1. Fold-down handle
2. Timer knob
3. Control knob
4. CAUTION indicator
5. Heat sensor patch
6. Front grille
7. Roll-over bars
8. Power indicator
9. Thermostat control
B
200UHPub1000002035 4/15/05 1:53 PM Page 4
Special features and the Advanced Safety Technology™ (AST) system
1. This unit has a safety auto off, plus a safety thermal fuse and CAUTION light. If unit experiences excessive heat, the safety auto off will shut off unit, and the CAUTION light will go on. If this happens, turn control knob to OFF immediately. Be sure front grille is not blocked and nothing is restricting airflow. Unplug unit, let it cool down, and wait 10-15 minutes. To reset, plug unit back in and turn thermostat control to HOT. You can then readjust temperature or room settings. If unit fails to operate after 15 minutes, it may mean heater has internal damage and thermal fuse has been tripped so heater can no longer operate.
2. A built-in tip-over switch will cut power if the unit is accidentally knocked over forward or backward. To reset, simply place heater in upright position on a level surface. If it falls forward, the roll-over bars on the front of unit will help prevent heater from burning surfaces.
3. Even though unit has a cool-touch housing, the front grille will get hot. Be careful not to touch it during operation. This patch changes color when front grille becomes hot to the-touch (C). Do not touch front of heater when this happens.
Care and Cleaning
This heater is permanently lubricated and will not require additional lubrication. There are no user serviceable parts. Refer service to qualified service personnel.
1. Always turn heater off, unplug, and allow it to cool completely before cleaning.
2. To clean exterior, use a soft dry cloth or one moistened with mild detergent to wipe outside surfaces. Do not use abrasives or harsh cleansers. Dry surfaces thoroughly before using heater. Or, you can use a vacuum with a dusting brush attachment to clean away dust.
Caution: Do not immerse heater in water or allow water to drip into interior of heater, as this could create an electric shock hazard.
3. Store heater in a cool, dry location in its original carton. Gather power cord in loops and secure with a twist tie. Don’t let power cord come in contact with sharp edges or get compressed by heavy objects. Portable electric heaters are designed for space heating as a supplementary heat source. They are not intended to be the main source of heat.
6
5
C
INSTRUCCIONES IMPORTANTES
DE SEGURIDAD
ADVERTENCIA: Para reducir el riesgo de incendio:
Mientras el calefactor se encuentre conectado, mantenga todos los materiales combustibles, tales como muebles, almohadas, ropa de cama, papeles, prendas de vestir y cortinas a una distancia mínima de 3 pies (0,9m) de la parte frontal y posterior del calefactor así como de los costados del mismo.
No coloque el calefactor cerca de una cama, ya que las almohadas o mantas pueden caer sobre el calefactor y prenderse fuego.
Desconecte siempre el calefactor de la toma de corriente eléctrica cuando se encuentre fuera de uso.
Evite utilizar un cable de extensión ya que puede calentarse demasiado y presentar así un riesgo de incendio. No obstante, si debe utilizarse un cable de extensión, debe medir como mínimo 14 AWG (1,63 mm) y tener una capacidad no menor de 1875 watts.
Cuando se utilizan aparatos eléctricos, siempre se deben tomar ciertas precauciones a fin de reducir el riesgo de un incendio, un choque eléctrico y lesiones a las personas, incluyendo las siguientes:
Lea todas las instrucciones antes de utilizar el calefactor.
El calefactor se calienta cuando está en funcionamiento. Para evitar quemaduras, no toque ninguna superficie caliente. Desconecte el calefactor y permita que se enfríe durante diez (10) minutos como mínimo antes de moverlo. Utilice los mangos que se proporcionan.
Es necesario vigilar a los niños o a las personas minusválidas que utilicen el calentador; del mismo modo, se debe supervisar el uso del calentador cerca de ellos y cuando el aparato se encuentra en uso sin supervisión.
No opere este artefacto si tiene el cable o enchufe dañado, después de un mal funcionamiento o si se ha caído o dañado de alguna manera. Lleve el calefactor al centro de servicio autorizado más cercano para su revisión, reparación o ajuste eléctrico o mecánico. También puede llamar gratis al número apropiado que aparece en la cubierta de este manual.
Este aparato no se debe utilizar a la intemperie.
El calefactor no está diseñado para su uso en áreas mojadas o húmedas, tales como baños, habitaciones donde se lava ropa u otras áreas interiores similares. Nunca coloque el calefactor en un lugar desde donde puede caerse a una bañera o recipiente con agua.
No tienda el cable debajo de una alfombra. No cubra el cable con alfombrillas, camineros o tejidos similares. Coloque el cable de manera que se mantenga alejado de las zonas de tráfico y que nadie se enrede con él.
200UHPub1000002035 4/15/05 1:53 PM Page 6
Loading...
+ 9 hidden pages