BENQ JoyBee 200 256 Mo User Manual

Joybee 200
MP3 Player User Manual
Welcome
Copyright
All rights reserved. No part of this publication may be reproduced, transmitted, recorded, stored in a retrieval system, or translated into any language or computer language, in any form or by any means, electronic, mechanical, recording, photocopying, or otherwise, without the prior permission of the BenQ Corporation.
Disclaimer
The BenQ Corporation shall make no warranty or representation, either expressed or implied, with respect to the quality, accuracy or fitness for any particular purpose of this document. The informa­tion in this document is subject to change without notice. The con­tent of this manual has been checked and proofread prior to publication.
*Windows is the registered trademark of Microsoft Corporation. All trademarks or product names appearing in this manual are regis­tered property of their respective owners.
Cautions
This MP3 player is a delicate electronic device - DO NOT OPEN IT.
Do not format memory using the FAT32 format.
Do not attempt to disassemble or modify any part of the device.
Avoid shock or impact to the device.
Keep the device away from water.
Keep the device away from extreme temperatures, humidity, dust or direct sunlight.
Do not clean the device with chemical solvents. Clean the device with a cloth dampened with water.
Use only the adapter and accessories approved by the manu­facturer. The warranty is voided if other adapters or accesso­ries are used, which may be dangerous.
Avoid listening at high volume, which may damage your ears and cause loss of hearing.
The BenQ Corporation assumes no responsibility for the loss of data due to damage to the device, repair of the device and/ or battery replacement. Users are advised to back up all data on other storage devices. Use of the device not in accordance with the instructions will void the warranty.
Memo
Table of Contents
Introduction .................................................................................1
System requirements.................................................................... 2
Package contents .......................................................................... 3
Touring the BenQ Joybee 200 MP3 Player ................................. 4
Buttons and ports .....................................................................4
Putting leather strap on................................................................ 5
LCD display............................................................................... 9
Charging the battery..................................................................... 11
Connecting earphones and wired remote control...................... 13
Connecting the Joybee 200 to a PC ............................................. 14
Disconnecting the Joybee 200 from a PC.................................... 15
Installing the software ..................................................................17
Installing the USB driver.............................................................. 19
Installing in Windows ME/Windows 2000/Windows XP...... 19
Installing in Windows 98SE .....................................................19
Turning the Joybee 200 on and off..............................................20
Transferring data to the Joybee 200 ............................................21
Transferring data with Windows Explorer.............................. 21
Transferring files with QMusic ................................................ 21
Playing MP3/WMA music files ................................................... 22
Repeat play ................................................................................ 23
Selecting an EQ mode............................................................... 24
Selecting a playback speed........................................................ 24
Listening to FM radio................................................................... 25
Saving preset channels in memory ..........................................26
Recording FM radio.................................................................. 26
Using the recorder function......................................................... 27
Playing back recorded audio files ................................................ 28
System setup .................................................................................29
Deleting files from the Joybee 200 ........................................... 29
1
Setting the recording options .................................................. 30
Setting up a timer recording.................................................... 33
Setting the power save option.................................................. 34
Using the lyric sync function ................................................... 35
Using the play list function...................................................... 36
Setting the date and time ......................................................... 37
Setting the language ................................................................. 38
Formatting the Joybee 200....................................................... 39
Upgrading the firmware........................................................... 40
Viewing system information.................................................... 41
Overview of QMusic .................................................................... 43
Adding music to the Joybee 200 using QMusic ......................... 47
Adding music from an audio CD to Joybee 200..................... 48
Adding files from a PC to Joybee 200...................................... 52
Updating Joybee 200 automatically with QMusic ..................... 55
Deleting files using QMusic......................................................... 58
2
Introducing the BenQ
o n
­e
h
s e k
-
­e
Joybee 200 MP3 Player

Introduction

Thank you for purchasing the BenQ Joybee 200 MP3 Player!
The BenQ Joybee 200 MP3 Player offers high quality audio playback and voice recording functions at low power con­sumption.
The Joybee 200 supports MP3, WMA, and WAV music for-
ats for your listening pleasure. Moreover, the seven built-in Q modes of the Joybee 200 allow you to enjoy music at the est sound quality. In addition to being a MP3 player, the
oybee 200 also functions as a FM radio, an audio recorder,
nd a FM transmitter for music share. The FM radio function enables you to preset up to 16 radi stations for quick and easy listening. The recording functio enables you to record your voice from the built-in micro phone, from the radio receiver or from the MP3 player. Th FM transmitter allows you to broadcast your music wit another device equipped with a FM transceiver.
Joybee 200 not only enriches your musical life but also allow you to carry your data everywhere. Its convenient driver-fre plug and play function allows you to use it as a USB flash dis on Windows 98SE/2000/ME/XP.
The Joybee 200 comes equipped with a software suite for addi tional convenience. The QMusic software enables you to con vert and transfer music from your PC or audio CDs to th Joybee 200.
1
When the batteries are fully charged, Joybee 200 offers about 10 hours of continuous replay time for MP3 music. However, the exact replay time depends on the condition of the battery, the volume level and many other factors.

System requirements

Your PC must comply with the following requirements in order to enable data transfer to your player:
OS: Microsoft Windows 98/2000/Me/XP/98SE (QMusic supports Windows 2000/XP/98SE)
CPU: Pentium 200 MHz or faster
I/O port: USB (1.1 or higher)
Device: CD-ROM
Hard disk space: 40 MB (minimum)
System memory: 32 MB (minimum)
2

Package contents

MAX
MIN
0
415
Check the contents of your Joybee 200 MP3 Player pack­age. Contact your dealer immediately if any of the follow­ing are missing or damaged.
12 4
r
ye
la
P 3 P
M
200
ybee o
J
5
3
7
8
9
10
11
1. BenQ Joybee 200 MP3 Player
2. Carrying pouch
3. Warranty card
4. AC power adapter & plug
5. Quick start guide
6. Software CD-ROM (E-manual, driver, QMusic, etc.)
7. Leather strap
8. FM Transmitter or Wired remote(Optional)
9. Stereo headphones
10. USB cable
11. Line-in Cable
6
3
Touring the BenQ Joybee 200 MP3 Player
The following section describes the various components of the Joybee 200.

Buttons and ports

Left View
MODE A-B VOL
T
T
LINE IN
Front View
Right View
Bottom View
4
12 3 4
oybeeJ200 MP3Player
56
REC
78 9 10
11

Putting leather strap on

Follw the steps below to put the leather strap on your Joy­bee 200.
(1)
(3)
(2)
(4)
5
Item Description Function
(1) Mode Press to switch modes.
MODE
Press and hold for 2 seconds to display options for the current mode.
Press to cancel current setting and go back to the previous level in setup or playback mode.
(2) A-B repeat/
Lock)
A-B
T
Follow this procedure to repeat a desired section during audio playback.
i. Press once to set point A.
ii. Press again to set point B and the
section from point A to B repeats continuously.
iii. Press again to disable the repeat
function.
Press and hold for 2 seconds to lock or unlock the keys.
(3) Volume control Press VOL – to decrease volume and VOL +
VOL
to increase volume.
(4) LINE IN For external audio signal recording.
(5) LCD Display Displays player status and file information.
See "LCD display" on page 9 for details.
(6) Neck strap hook For attaching the neck strap.
6
Item Description Function
(7) Power on/off,
Play/Pause/ Stop/Enter
(8) Record Press to start recording. Press again to stop
REC
Press and hold for 2 seconds to turn on the Joybee 200.
Press and hold for 2 seconds to turn the player off. The message ‘System Off ’ is displayed on the screen before the power goes off.
Press once to play an audio file in play­back mode. Press once to pause playback and press again to continue playing in playback mode.
Press and hold for 2 seconds to stop playing or recording and switch to file layout.
Press to confirm a selection in setup mode.
recording.
7
Item Description Function
(9) Previous/Fast
Rewind, Next/Fast Forward buttons
/
(10) Earphone and
wired remote control jack
(11) USB port Connects the Joybee 200 to a PC or to the
(12) Force shutdown Turns Joybee 200 off when system
Press once to skip to the previous or next file in audio file playback mode.
Press and hold for 4 seconds to rewind or fast forward an audio file in playback mode.
Press once to scroll to the previous or next item in menu mode.
Press and hold for 2 seconds to scroll back or forward continuously in menu mode.
Press once to skip to the previous or next channel or frequency in FM radio mode.
Press and hold for 2 seconds to auto-scan the frequencies in forward or reverse direction in FM radio mode.
Press to skip to the previous or next item in setup mode.
Connects to earphones and wired remote control jack.
battery charger for charging the built-in battery.
malfuntions. Turn on the Joybee 200 by using after force shutdown.
8

LCD display

R
The LCD screen displays information about the player mode and file information. The following table shows the icons displayed on the screen and their meanings.
Icon Description
Indicates audio file being scanned in forward direction (Forward).
Indicates audio file is being scanned in reverse direction (Rewind).
Indicates FM radio mode.
Indicates that recording time is remaining.
Indicates recording in progress.
Indicates that recording has been paused.
Indicates single track repeat mode.
1
Indicates random mode.
Indicates random repeat mode.
RR
Indicates sampling mode.
Indicates repeat mode is disabled.
OFF
Indicates A-B repeat mode.
ALL
Indicates fast (110), slow (90) and very slow (80)
110 90
Indicates repeat mode for all files.
80
playback speeds.
Indicates MP3/WMA mode.
9
Icon Description
Indicates voice recording mode.
Indicates audio recording mode.
Indicates FM mode.
Indicates setup mode.
Indicates battery status.
Indicates keys are locked.
Indicates player is connected to a PC with the USB
USB
port.
10

Getting Started

0415
0415

Charging the battery

Follow these steps to charge the Joybee 200’s battery.
1. Remove the translucent rubber cover from the charger socket. Insert one end of the power adapter cable into the USB port of the Joybee 200 and the other end to the adapter.
2. Connect the adapter to a wall outlet.
oybeeJ200MP3Player
11
It takes around 1 hour to quick charge the Joybee 200 built-in battery. For fully charge of thwe battery, it takes about 3.5 hours.
Exact charging time depends on battery status.
Chargers for use in some areas may not have an indicator. Check the
battery charge status using the indication on the LCD display (see "LCD display" on page 9).
The life of battery depends on how often it has been charged. Fre-
quent charging results in shorter playing time.
12

Connecting earphones and wired remote control

Follow these steps to connect earphones and wired remote control.
Plug the earphones into the earphone jack on the wired remote control as shown in the illustration.
oybeeJ200MP3 Player
To connect both the wired remote control as well as the earphones, connect the wired remote control to the Joybee 200. Connect the earphones to earphones jack on the wired remote control.
oybeeJ200MP3 Player
13
Connecting the Joybee 200 to a PC
Connect the Joybee 200 to your PC with the USB cable provided as shown in the illustration.
oybeeJ200MP3Player
When the Joybee 200 is successfully connected to the PC, a new Removable Disk icon appears in the My Computer window on your PC. A message saying Connection Com­pleted along with a connection icon is also displayed on the LCD screen of the Joybee 200.
If the dialog box “Windows found new hardware” keeps appearing on the PC screen after the connection, press Next or OK to close the dialog box.
14
Disconnecting the Joybee 200 from a PC
Follow these steps to disconnect the Joybee 200 from a PC.
1. Double click the USB device icon on the taskbar. A dialog box as shown below appears on the screen.
2. Select USB Mass Storage Device in the dialog box and press Stop. Another dialog box appears on the screen.
3. Select BenQ Joybee 200 MP3 Player USB Device and press OK
15
Loading...
+ 48 hidden pages