BENDIX TCH-001-029 User Manual

Technical Bulletin

Bulletin No.: PRO-01-29 Effective Date:10/30/86 Cancels: N/A Page: 1 of 1

Subject: POWERMISER 501 MACK RETROFIT INSTALLATIONS (Kit

#209926)

When using kit #209926 to retrofit the Powermiser 501 compressor clutch on the Mack
six cylinder engine, it is necessary to replace the engine’s existing compressor drive with
the drive coupling (297125) provided in the kit. The oil pump drive gear must be pressed
off the existing drive and onto the kit’s replacement drive coupling.

It has come to our attention that some older Mack engines used a one piece compressor
drive and oil pump gear and, therefore, the gear cannot be pressed off. Mack obsoleted
the one piece drive, however, a few can still be found in rebuilt engines. When the one
piece drive is encountered, it is necessary to purchase a separate engine oil pump drive
gear from Mack. To determine the correct Mack part number, count the teeth on the oil
pump drive gear of the one piece unit and refer to the chart below.

No. of T eeth on Mack Pa rt No. for
Oil Pump Gear of Separate Oil Pump
One Piece Drive Drive Gear

13 682 GB 113
15 683 GB 195
17 683 GB 1154