Page 1
Universal
FiberExpress® Brilliance
®
900 µm INSTALLATION INSTRUCTIONS
LC-SC-ST
2 4
Clean ber.
3
Strip off 24 ± 2 mm of buffer.Slide activator tab to the
open position (towards ferrule).
9
8
Create and maintain a bow
with the ber, while sliding
the activator tab to the closed position
(towards boot).
7
Insert ber into connector up to the 13
mm buffer mark.
6
Mark buffer at 13 mm.
5
Align the end of the ber’s buffer at 8
mm and cleave.
1
Slide boot onto ber.
10 11
To watch a video of
this installation, visit
youtube.com/beldenvid
900 µm Buffered Fiber (To Scale)
900 µm Buffered Fiber
8
+0.5
-0.0
13
50
40
30
20
10
0 mm
900 µm Buffered Fiber
Do not turn on VFL light source until
ber is seated and activator tab is
closed. Light from VFL window has no
meaning until activator tab is closed.
Multimode
-
Light goes out.
Singlemode -
Light dims. *
* When using a Visual Fault
Locator (VFL) during termination
Install boot onto connector.
For complete details on this
procedure refer to Istallation
Guide PX105234.
*When using a Visual
fault Locator (VFL) during
termintation.
**When using a field cleaver
remove 40 mm of buffer.
A copy of the Guide is supplied
with each installation kit or visit
www.belden.com
Page 2
8
Open the activator tab and insert ber
into the connector. Refer to point D for
ber
insertion depth.
4
Insert boot.
7
3
Strip jacket at point B*.
11
Spread the Kevlar around
the threads then gently screw
on boot and release bow.
6
Wrap ber cable around nger, then
strip off buffer to point C*.
2
Cut Kevlar® off at point A*.
10
Unclip the connector, then
create another bow and
maintain it until the next step.
1
Mark jacket at points A and B, then strip
jacket at point A*.
9
Create a bow and slide the
activator tab to the closed
position, then bring the boot
to the rear of the connector.
Quick Reference Diagram ( To Scale)
* See Quick Reference Diagram
below
®
Kevlar is a registered
trademark of DuPont
JACKETED INSTALLATION INSTRUCTIONS
Ensure ber is fully pushed
into jacket, then mark points
C, D and E*.
5
Unclip
Quick Reference Diagram (lengths to scale)
Precision
Cleaver
Jacket
Point B
Point A
Point EPoint DPoint C
Buffer
Fiber
5 mm
13 mm 30 mm
18 mm
Clean then cleave ber
at 8 mm.
+0.5
-0.0
Universal
FiberExpress® Brilliance
®
LC-SC-ST
Loading...