Bauknecht GLT3657R, SCS3617R, SCS3017R User Manual
PRODUCT MODEL NUMBERS OVERALL DIMENSIONS
CABINET OPENING DIMENSIONS
GLT3057R
GLT3657R
SCS3017R
SCS3617R
Gas Supply: This cooktop is factory set for use
with Natural gas. Cooktop can be converted to LP
gas. Provide a gas supply line of ³⁄₄" (1.9 cm) rigid
pipe to the cooktop location. A smaller size pipe on
longer runs may result in insufficient gas supply.
Pipe-joint compounds that resist the action of LP
gas must be used. Do not use TEFLON
®
tape. With
LP gas, piping or tubing size can be ¹⁄₂" minimum.
Usually, LP gas suppliers determine the size and
materials used in the system.
Electrical: A 120 volt, 60 Hz., AC only, 15-amp
fused, electrical circuit is required. A time-delay
fuse or circuit breaker is also recommended. It is
recommended that a separate circuit serving only
this cooktop be provided.
®
Gas Built-in Cooktop
Because Whirlpool Corporation policy includes a continuous commitment to improve
our products, we reserve the right to change materials and specifications without notice.
Dimensions are for planning purposes only. For complete details, see Installation
Instructions packed with product. Specifications subject to change without notice.
Ref. 8286304
08-10-05
Metal Cooktops
B
A
A. 21
¹⁄₄
" (53.4 cm)
⁷⁄₁₆
" (79.8 cm) on 30" (76.2 cm) models,
B. 31
⁹⁄₁₆
" (95.4 cm) on 36" (91.4 cm) models
37
⁷⁄₈
" (7.3 cm)
C. 2
Straight-edge glass cooktops
B
A
⁵⁄₁₆
" (51.5 cm)
A. 20
³⁄₁₆
" (76.8 cm) on 30" (76.2 cm) models,
B. 30
⁷⁄₁₆
" (92.5 cm) on 36" (91.4 cm) models
36
⁷⁄₈
" (7.3 cm)
C. 2
C
C
A
D
C
M
B
K
F
E
G
H
L
J
A. 30" (76.2 cm) on 30" models; 36" (91.4 cm) on 36" models
B. Combustible area above countertop (shown by dashed box
above)
" (76.2 cm) minimum clearance between top of cooktop
C. 30
platform and bottom of unprotected wood or metal cabinet
" [61 cm] minimum clearance if bottom of wood or metal
(24
cabinet is protected by not less than ¹⁄₄
retardant millboard covered with not less than No. 28
MSG sheet steel, 0.015
" [0.06 cm] aluminum or 0.020" [0.05 cm] copper)
0.024
" (33 cm) maximum upper cabinet depth
D. 13
E. 2
¹⁄₈
" (5.4 cm)
" [0.04 cm] stainless steel, or
I
" [0.6 cm] flame
Curved-edge glass cooktops
B
A
¹⁄₈
" (53.7 cm)
A. 21
⁵⁄₁₆
" (77.0 cm) on 30" (76.2 cm) models,
B. 30
⁵⁄₁₆
" (92.3 cm) on 36" (91.4 cm) models
36
⁷⁄₈
" (7.3 cm)
C. 2
F. 1 9" (48.3 cm)
G. 18" (45.7 cm) minimum clearance from upper cabinet to
countertop within minimum horizontal clearances to cooktop
H. Grounded outlet - Locate within 24" (61 cm) of right rear
corner of cutout
I. 29" (73.7 cm) on 30" models; 35¼" (89.5 cm) on 36" models
" (21.3 cm) minimum distance to nearest left and right side
³⁄₈
J. 8
combustible surface
K. 2
" (7.3 cm) minimum distance to rear combustible surface
⁷⁄₈
L. Gas line opening - Wall: anywhere 5" (12.7 cm) below
underside of countertop. Cabinet floor: anywhere within
6" (15.2 cm) of rear wall is recommended
M. 24" (61 cm) minimum countertop depth is required
C
Loading...