Bacharach PCA400 Quick Start Guide

®

Front Side

1

2

Warm Up: 60 seconds

4

9

6

10

3

1 Pistol-Grip Probe

2 PCA® 400 Combustion Analyzer

3 Sample Line with Quick Connectors

4 Water Trap & Filter Assembly

5 IrDA Communications Port (Not Shown)

6 Full Color LCD Touch Screen

7

8

WARNING: This analyzer is not intended to be used as a
safety device.

7 Back, Home & Power Keys (Left to Right)

8 Navigation & Enter Keys

9 Micro-B USB Connector

10 T-Air Connector

11 T-Stack Connector & Sample Ports

12 Pressure Low Side (-∆P)

IMPORTANT: Ensure that the water trap assembly is
clean, dry, and properly assembled.

IMPORTANT: Check for obvious signs of splits and / or
cracks in the tubing.

Bottom

11

12

IMPORTANT: Ensure that the analyzer has sucient

charge before operation. If in doubt, recharge lithium-ion
battery, replace disposable batteries, or provide power
via the AC adapter and USB cable.

60-SECOND

WARM-UP

IMPORTANT: Perform power up and initialization in
fresh air to ensure proper calibration.

IMPORTANT: Address / acknowledge any faults or errors
discovered during initialization.

WARNING: This analyzer has not been designed to be

intrinsically safe for use in areas classied as hazardous

locations.

IMPORTANT: Perform routine maintenance (replacing
sensors, calibrating, etc.) as outlined in the PCA® 400 User
Manual (P/N 0024-9551).

A B

Warning: When testing an appliance, a full visual inspection should be performed to ensure
its safe operation.

CAUTION: The probe may be hot after analysis and can
cause bodily harm and or damage the analyzer. Allow the

probe sucient time to cool before handling or storing in

the supplied instrument case.

A B

A B

x

IMPORTANT: Use only original equipment components
with this device.

CAUTION: Except for sensor and battery replacement,
this analyzer should only be opened and / or serviced by
authorized Bacharach personnel. Failure to comply may
void the warranty.

The Sample Conditioner extracts

WAIT FOR

RESULTS TO

STABILIZE

ON

®

PCA

400 Active

ERROR

Sample Conditioner

BACHARACH, INC.
NEW KENSINGTON, PA 15068 USA
TELEPHONE: [phone]
www.MyBacharach.com

MADE IN THE USA

POWER: 12-15 VDC, 3A

P/N: 0024-XXXX

S/N:

Sample Conditioner

Viton® Sample Line

IrDA + Bluetooth®

Printer

Printer Paper

Water Trap Filters

O2 Sensor

CO

Sensor

LOW

CO

Sensor

HIGH

SO2 Sensor

NO2 Sensor

NO Sensor

Description:

P/N:

Description:

P/N:

Description:

P/N:

P/N 0024-1310 (contains 5 rolls of paper)

P/N 0007-1644 (contains 3 lters)

P/N 0024-1652

P/N 0024-1687

P/N 0024-1542

P/N 0024-1543

P/N 0024-1544

P/N 0024-1691

water vapor from samples, allowing
the PCA® 400 to accurately read
levels of NO2 and or SO2.

0024-7400

7.5' Viton® Sample Line with quick
connectors allows the PCA® 400 to
accurately read levels of NO2 and
or SO2.

0024-3236

The IrDA + Bluetooth® Printer allows
technicians to print reports directly
from the PCA® 400 without a wired
connection.

0024-1680