The Ultimate High Performance Jogging Stroller
This product complies with BS EN 1888:2003+A1-3 This product complies with ASTM F833-98
Read these carefully before use and keep them for reference. safety may be you do not instructions.
For the sake of your precious cargo, please read these warnings before using your Baby Jogger.
•Warning: Parcels or accessory items, or both, placed on the unit may cause the unit to become unstable.
• Warning: Never leave your child unattended.
•Warning: Recommended weight for seat pocket is 2 lbs (1 kg) and basket is
7 lbs (3.2 kg). Excessive weight may cause a hazardous unstable condition to exist.
•Warning: Stroller is not meant for transporting children up or down stairs. Damage resulting to stroller will not be covered under warranty.
• Warning: Child may slip into leg openings and strangle. Never use in reclined carriage position unless safety harness is properly fastened.
•Accessories which are not approved by the manufacturer or distributor shall not be used.
•Always use your wrist strp – these strollers can really roll, and the wrist strap gives you control if you should slip or fall down.
•The passenger shall remain seated (no standing in the stroller).
•Watch out for cars – never assume that a driver can see you and your child.
•This stroller is suitable from 6 months to 5 years.
•Total weight load recommended for this stroller is 100 lbs (45 kg). (combined passenger and baggage weight)
•This stroller seats one passenger.
•It may be unsafe to use replacement parts other than those supplied or approved by the manufacturer.
2
Frame
Front
Tube
Connector
Snap
Locks
•To assemble, simply unfold frame and insert the front of handle assembly into Front Tube Connector and lock together, securing with Snap Locks.
Warning: Ensure that all locking devices are engaged before use.
1
1 Insert the footplate tab into |
2 Snap down onto |
3 Using a phillips head |
the footplate holder slot. |
stroller frame. |
screwdriver, attach footplate |
|
|
to stroller frame with screw |
|
|
supplied (You will find the |
|
|
screw in the bag with the |
|
|
instructions). |
Note: You will need to rest the stroller handle on the floor in order to get to the bottom of the footplate.
1To install front wheel, lay stroller back so handle is resting on floor. Squeeze V-Brake caliper together to release noodle.
2 Insert the front wheel into the forktips by aligning the axle flats with the forktip flats.
Note: Ensure that the brake caliper is properly installed before using stroller.
3Tighten by turning the wheel lever while holding the opposite side.
4Squeeze V-Brake caliper together to secure brake noodle into V-Brake mechanism.
2 |
3 |
Loading...