AT&T HS8211 User Manual
900 MHz Cordless
Telephone HS-8211
Please also read
Part 1 — Important
Product Information
USER’S MANUAL
Par t 2
AT&T and the globe symbol are registered trademarks of AT&TCorp.licensed to Advanced American Telephones.
© 2000 Advanced American Telephones. All rights reserved.
Printed in China. 850004128 Issue 1AT&T 7/00
INSTALLATION . . . . . . . . . . . . . . . . . . . . . . 3
Before You Install ...........................3
Ta ble/Desk Installation...................5
Wall Installation..............................6
TELEPHONE OPERATION . . . . . . . 8
Make or Answer a Call ...................8
End a Call.......................................8
Change Channel.............................8
Redial .............................................8
Handset Volume.............................8
Flash/Call Waiting...........................8
Page/Handset Locator....................9
Temporary Tone Dialing...............10
Handset Ringer Style....................10
Ringer Off/Battery Save ...............10
Headset Jack.................................11
Operating Range..........................11
TELEPHONE MEMORY . . . . . . . . . .12
Store Memory Numbers ...............12
Change/Replace a Stored
Memory Number......................12
Dial Memory Numbers.................12
Store a Pause in a
Memory Number......................12
Directory Label ............................12
BATTERIES . . . . . . . . . . . . . . . . . . . . . . . . . . .13
Charging the Handset
Battery Pack ..............................13
Replacing the Handset
Battery Pack ..............................14
IN CASE OF DIFFICULTY . . . . . . . . .15
CONTENTS
1
Before You Install
1 Choose a location for the base near an electrical outlet and a
telephone jack.
This phone requires a modular telephone jack and a standard electrical
outlet (110v AC) not controlled by a wall switch.
2 Install the handset battery.
INSTALLATION
3
b) Align two holes in
plug with socket
pins,and snap the
plug into place.
d) Replace
cover by
sliding it up
into place.
a) Remove battery
compartment
cover by pressing
on the
indentation
and sliding
downward.
c) Place battery pack
in compartment
with the wires in
the lower left
corner,along the
bottom of the
battery pack.
INSTALLATION
4
3 Attach the belt clip to the cordless handset (optional).
To attach
To remove
INSTALLATION
5
3 Charge the handset battery.
Place the handset in the base. Charge the battery for at least 24 hours
the first time. After the first charge,the batter y is typically fully
charged overnight.
4 Check for dial tone.
After the batteries are charged,pick up the handset and press P;
you should hear a dial tone.
5 Set the dial mode.
If you have touch tone service,the phone is ready to use as soon as the
batteries are charged.
If you have dial pulse (rotary) service,you’ll need to change the dial
mode. When the phone is off,press G,*, #,M to set the
dial mode to dial pulse. To retur n to touch tone dialing,press G,
*,*,M.
Standard
electrical outlet
Modular
telephone
jack
Table/Desk Installation
1 Connect the
telephone
line cord.
2 Connect the
power cord.
Loading...