AT&T PWS02, Hot Joe II User Manual

User’s Manual

Hot Joe II

PWS02

Portable Bluetooth® Speaker

Page 2

Welcome

|

Thank you for buying AT&T Hot Joe II

Introduction

Features

- Bluetooth 2.1 + A2DP, AVRCP

- Hands-free speakerphone

- Wireless range of up to 30 feet

- Stereo speakers with RealBass technology

- Easy USB charging

- Rechargeable Lithium Battery

- 3.5 mm auxilary input jack

Page 3

What’s Included

Unpack the Hot Joe II and make sure all accessories are put
aside so they will not be lost.

Micro USB Cable

Portable Speaker

Page 4

Content

Introduction

Features 2

What’s Included 3

Safety Information

Important Safety Instructions 5

Getting Started

Location of Main Unit Controls 6

Operational Instructions

Charging the Unit 7
Power ON/OFF 7
AUX Input 7
Pairing Your Bluetooth Device 8
Music Playback Functions 8
Hands-free Speakerphone 9

Troubleshooting 10

Compliance with FCC Regulations 11

Warranty Information

Limited Warranty 12

Specications 14

Page 5

Please read all safety and operating instructions carefully
before installation and use, and keep these instructions handy
for future reference. Take special note of all warnings listed in
this user’s manual and on the Hot Joe II.

1. Attachments - Do not use attachments that are not
recommended by the manufacturer.

2. Water and Moisture - The unit should not be used near water.
For example: near a bathtub, washbowl, kitchen sink, laundry tub,
swimming pool or in a wet basement.

3. Ventilation - The unit should be situated so that its location or
position does not interfere with its proper ventilation. For example,
it should not be situated on a bed, sofa, rug or similar surface that
may block ventilation openings. Also, it should not be placed in
a built-in installation, such as a bookcase or cabinet, which may

impede the flow of air through the ventilation openings.

4. Objects and Liquid Entry - Care should be taken so that external
objects do not fall into and liquids are not spilled onto any openings
or vents located on the product.

5. Power Source - The unit should be connected only to a power
supply of the type described in the operating instructions or as
marked on the unit. If you are not sure, please consult the dealer
or local power company.

6. Heat - The unit should be situated away from heat sources such
as radiators, heat registers, stoves or other appliances (including

amplifiers) that produce heat.

7. Servicing - The user should not attempt to service the unit
beyond those methods described in the user’s manual. Opening or
removing covers will expose you to dangerous voltage and other
hazards. Service methods not covered in the user’s manual should

be referred to qualified service personnel.

Safety Information

Important Safety Instructions