AT&T EL52459, EL52419 User Manual
Quick start guide
EL52209/EL52259/EL52309/
EL52409/EL52419/EL52459
DECT 6.0 cordless telephone/
answering system with
caller ID/call waiting
Installation
Install the telephone base close to a telephone jack and a power outlet not
controlled by a wall switch. For optimum range and better reception, place
the telephone base in a central and open location.
If you subscribe to high-speed Internet service (digital subscriber line - DSL)
through your telephone lines, you must install a DSL filter between the
telephone line cord and the telephone wall jack (see the following page).
The filter prevents noise and caller ID problems caused by DSL interference.
Please contact your DSL service provider for more information about
DSL filters.
Your product may be shipped with a protective sticker covering the handset
or base display - remove it before use.
For customer service or product information, visit our website at
www.telephones.att.com or call 1 (800) 222-3111. In Canada, dial
1 (866) 288-4268.
Avoid placing the telephone base too close to:
• Communication devices such as: television sets, VCRs, wireless routers, or
other cordless telephones.
• Excessive heat sources.
• Noise sources such as a window with traffic outside, motors, microwave
ovens, refrigerators, or fluorescent lighting.
• Excessive dust sources such as a workshop or garage.
• Excessive moisture.
• Extremely low temperature.
• Mechanical vibration or shock such as on top of the washing machine or
work bench.
1
Battery installation & charging
Install the battery as shown on the next page. Once you have installed the
battery, the screen indicates the battery status (see table below). If necessary,
place the handset in the telephone base or charger to charge the battery.
For best performance, keep the handset in the charger when not in use.
The battery is fully charged after 16 hours of continuous charging. See the
table on the Technical specifications page of the user’s manual for battery
operating times.
If the screen is blank, you need to charge the handset without interruption for
at least 10 minutes to give the handset enough charge to use the telephone
for a short time. The screen shows LOW BATTERY the backlight is off until
you have charged the battery without interruption for at least one hour. The
following table summarizes the battery charge indicators and actions to take.
Battery indicators Battery status Action
The screen is blank. Battery has no charge
and the handset cannot
be used.
The screen shows
PLACE IN CHARGER
and flashes.
The screen shows LOW
BATTERY and flashes.
Battery has very little
charge and the handset
cannot be used.
Battery has enough
charge to be used for a
short time.
The screen shows
Battery is charged. To keep the battery
HANDSET X.
Charge without
interruption until the
screen shows LOW
BATTERY (at least 10
minutes).
Charge without
interruption until the
screen shows LOW
BATTERY (at least four
minutes).
Charge without
interruption until the
screen shows HANDSET
X (at least one hour).
charged, place it in
the telephone base or
charger when not
in use.
NOTE: If you are on a phone call in low battery mode, you hear four short beeps
every minute.
2
Loading...