AT&T 2525 Quick Start Guide

Quick reference guide
Copyright © 2004 Advanced American Telephones. All Rights Reserved.
AT&T and the Globe Design are trademarks of AT&T Corp.,
licensed to Advanced American Telephones.
Answering system controls
ON/OFF ..................Press to turn answering system on or off.
DELETE ..................Press to delete message currently playing.
MENU......................Press to review or change answering system options.
CHANGE ................Press to change a menu option.
RECORD ................Press to record a memo or outgoing announcement.
Telephone function keys
SOFTKEYS ............Press to select menu item displayed just above the key.
CLEAR ....................Press to cancel an operation, back up to the
previous menu, or exit the menu display.
INTERCOM ............
Press to transfer a call or initiate an intercom conversation.
FLASH ....................During a call, press to receive an incoming call, if
Call Waiting is activated.
VOLUME ................Press to adjust speakerphone listening volume.
MUTE ......................Press to silence microphone; press again to resume.
SPEAKERPHONE ..Press to turn speakerphone on or off (begin or end a call).
Telephone Base
Answering system controls
Telephone function keys
Swivel antenna fully upright for best results.
Item 1 Item 2 Item 3
Press to play or stop playing messages.
Press to repeat message. Press twice to hear previous message.
Press to skip to next message.
ATT-2525QSG-d3.qxd 1/17/2004 5:21 PM Page 1
Quick Start Guide
2.4 GHz Cordless Telephone/Answering System E2525
with Caller ID & Call Waiting
ATT-2525QSG-d3.qxd 1/17/2004 5:21 PM Page 2
Installation and setup
Connect the base and install batteries as shown below. After installation, place the handset in the base and allow the battery to charge for 8 hours before use. You can keep the battery charged by returning the handset to the base after each use.
Press coin into slot on base of handset to release latch, then remove battery cover.
Insert supplied batteries.
Place handset in base to charge for 8 hours before first use. Rotate antenna to fully upright position.
Insert top tab first.
To replace battery cover
Press down to click in place.
Caution: Use only the supplied NiCd battery (80-5469-00-00) or AT&T model 2AA NiMH replacement battery (SKU 26820). Do not use
alkaline batteries.
ATT-2525QSG-d3.qxd 1/17/2004 5:21 PM Page 3
Quick reference guide
HANDSET 1
REDIAL MEMMENU
Off/Clear
During a call, press to hang up.
While using menus, press to cancel an operation, back up to the previous menu, or exit the menu display.
Speaker
Press to activate handset speaker­phone. Press again to switch call back to earpiece.
Softkeys
Press a softkey to select a menu item displayed just above the key.
Phone/Flash
Press to begin a call, then dial a number.
During a call, press to receive an incoming call, if Call Waiting is activated.
Sound Select
Press to customize speaker sound for clear speakerphone conversations.
Handset
Xfer/Intercom
Press to transfer a call or initiate an intercom conversation.
Redial Log Phonebook
Screen menus
Item 1 Item 2 Item 3
Menus
Main Menu
Calls Log
Play Messages
Handset Settings
Set Time
Clock Mode
Register
Handset Settings
Ringer Volume
Ringer Melody
Low Batt Tone
Range Tone
Keypad Tone
Contrast
Language
ATT-2525QSG-d3.qxd 1/17/2004 5:22 PM Page 4
Loading...