Atec F-203I-A-23 User Manual

RF electromagnetic fields frequently degrade the performance of
electronic equipment by generating common mode currents on
cables. RF immunity to these fields can be verified by injecting
common-mode currents onto the cables of the equipment under
test. The F-203I-A-23mm EM Clamp is an high-efficiency, broadband
clamp-on injection device that is used to test the immunity of
electronic equipment when direct capacitive coupling technique is
not possible nor appropriate. When the F-203I-A-23mm is used with
the F-203I-A-CF3-23mm-150 and the F-203I-A-CF3-23mm-50
calibration fixtures, it fully complies with IEC61000-4-6 Edition 4.0.

Impedance (TOSM / ABCD Transformation)

300

250

200

Z [Ω]

150

E M I n j e c t i o n C l a m p f o r I E C 6 1 0 0 0 - 4 - 6 E d i t i o n 4 . 0

100

50

0.1 1.0 10.0 100.0

Decoupling Factor (TOSM / ABCD Transformation)

0

-1

-2

a [dB]

-3

-4

-5

0.1 1.0 10.0 100.0

Frequency [MHz]

Frequency [MHz]

Fischer Custom Communications, Inc.

20603 Earl St., Torrance, CA 90503 • Phone: [phone] • Fax [phone] • email: [e-mail]
© Fischer Custom Communications, Inc.

600124

All rights reserved • Printed in USA

10

Input Power Rating:

Coupling Aperture:

Length:

Width:

Connector:

-5

-10

-15

-20

-25

E M I n j e c t i o n C l a m p f o r I E C 6 1 0 0 0 - 4 - 6 E d i t i o n 4 . 0

Insertion Loss Calibrated into a 300 ohm loop line impedance
Coupling Factor

5

0

-30
10kHz 100kHz 1MHz 10MHz 100MHz 1,000MHz

Frequency

Specifications Accessories

10kHz – 100MHz 100 watts CW for 15 minutes F-203I-A-CF3-23mm-150

(150Ω calibration jig) 100MHz – 230 MHz 100 watts CW for 10 minutes

230MHz – 1GHz 50 watts CW for 10 minutes

23mm F-203I-A-CF3-23mm-50
610mm
75mm
Type-N

(50Ω calibration jig)

20603 Earl St., Torrance, CA 90503 • Phone: [phone] • Fax [phone] • email: [e-mail]
© Fischer Custom Communications, Inc.

600124

Fischer Custom Communications, Inc.

All rights reserved • Printed in USA