Atec Exfo-PPM-350B-EG User Manual

Page 1
The market’s first BPON/EPON/GPON power meter
New PPM-352B-EG-ER: the only power meter truly optimized for EPON and GPON architectures
Pass/warning/fail indicators (10 threshold sets) for easy assessment of power values—anywhere on the network
Simultaneous measurement and display of all PON signals—voice, data and video
Filtered measurements, providing distinct power values for each signal (1310 nm, 1490 nm and 1550 nm)
Two-port pass-through configurations* enabling full OLT-to-ONT communication while testing.
The most easy-to-use instrument of its kind: simply connect the fiber and read the results
Extended-range for testing at the central office (CO) and before the splitter
Go-anywhere versatility: enables quick, accurate testing all across the network
*Protected by US patent no. 7,187,861, German Utility Patent no. 20 2004 021 208.0, and subject of several pending national entries in other countries under the Patent Cooperation Treaty.
PON POWER METER
Telecom Test and Measurement
www.EXFO.com
PPM-350B
NETWORK TESTING—OPTICAL
Page 2
PPM-350B
PON Power Meter
www.EXFO.com
A Revolutionary Testing Tool for FTTH and FTTP Systems
The industry’s first PON-specific power meter, the PPM-350B is the flagship of EXFO’s line of test instruments specifically intended for FTTH and FTTP systems. The PPM-352B-EG-ER is the ideal tool for FTTH/FTTP service activation and troubleshooting.
Service Activation Testing
Optimizing network reliability requires that all PON signals be measured all the way through service activation to ensure they meet established standards. The PPM-350B offers the features to address this need:
Pass-through connection for ONT signal measurement and simultaneous measurement of all PON signals
Filtered detectors for individual measurement of each wavelength
Upstream burst detection at 1310 nm
Troubleshooting Testing
Throughout the maintenance phase, various transmission problems—fiber cuts, damaged/dirty connectors, macrobendings, optical transmitter failure, etc.—may ultimately cause signal loss or degradation. Benefit from the PPM-350B’s troubleshooting functionalities:
Quick, on-site test and measurement of PON signals, anywhere on the network
Fault identification and isolation
Upstream signal from the ONT
Downstream signal from the OLT
The PPM-352B-EG-ER
The PPM-350B’s threshold configuration software interface.
The PPM-350B is a choice solution for service activation and maintenance of all PON architectures within a network.
Page 3
PPM-350B
PON Power Meter
www.EXFO.com
Correctly measuring PON signals can be a challenging task: not only can a single fiber carry up to three signals, but the upstream signal coming from the ONT operates in burst mode, which means that it is only active during its “allowed” timeslot. This is true whether the network is based on the BPON, EPON or GPON technology. Moreover, the timeslot is shorter in higher-speed networks such as EPON and GPON. Designed with this in mind, the PPM­350B PON Power Meter delivers accurate results for burst signals.
Groundbreaking Technology—Two-Port Pass-Through*
The PPM-352B-EG-ER acts as a pass-through device, which means that it is connected between the OLT and the ONT. A small percentage of the signal is extracted for use by the power meter's detectors.
This approach enables all wavelengths to be used simultaneously. Also, since the PON equipment can keep functioning normally, the ONT continues to operate (to respond to the OLT), and therefore to transmit and have its laser on.
Up to 10 User-Definable Threshold Sets
Depending on the location of the test and the type of equipment used, different threshold values can be required. The PPM-350B enables you to select from up to 10 threshold sets—each set consisting of three wavelengths (1310, 1490 and 1550 nm) having their own pass, warning and fail thresholds. These values can be configured via the PC-based software.
CONFIGURATION
PPM-352B-EG-ER Two-port pass-through: all wavelengths; X upstream measurement Downstream OLT signal (1490 nm) X for up to 2.5 Gbit/s Downstream RF video signal (1550 nm) X Upstream BPON ONT signal for up to X 622 Mbit/s, as per ITU 983 (A, B, C) Upstream EPON and G PON ONT signal for up X to 1.25 Gbit/s, as per ITU 984 and IEEE 802.3ah Extended range for testing over the entire X BPON, E PON or GPON architecture
Voice
Data
1 x N
Splitter
. . . . .
Drop
Terminal
Drop
Terminal
CO
Patch Panel
Patch Panel
FDH
Distribution Fiber
OLT
Optical
Video
Transmitter
EDFA
ONT
WDM
Coupler
ONT
Drop
Terminal
ONT
ONT
*Protected by US patent no. 7,187,861, German Utility Patent no. 20 2004 021 208.0, and subject of several pending national entries in other countries under the Patent Cooperation Treaty.
Upstream Burst Detection—Not To Be Taken Lightly
The PPM-350B allows for pass-through connection in any PON architecture.
The PPM-350B’s display. The PPM-352B-EG-ER used at the ONT.
Page 4
SPPPM-350B.8AN © 2007 EXFO Electro-Optical Engineering Inc. All rights reserved. Printed in Canada 07/11
EXFO Corporate Headquarters > 400 Godin Avenue, Quebec City (Quebec) G1M 2K2 CANADA
Tel.: 1 418 683-0211 Fax: 1 418 683-2170 info@EXFO.com
Toll-free: 1 800 663-3936 (USA and Canada) www.EXFO.com
EXFO is certified ISO 9001 and attests to the quality of these products. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. EXFO has made every effort to ensure that the information contained in this speci fication sheet is accurate. H owever, we accept no responsibility for any errors or omissions, and we reserve the right to modify design, characteristics and products at any time without obligation. Units of measurement in this document conform to SI standards and practices. In addition, all of EXFO’s manufactured products are compliant with the European Union’s WEEE directive. For more information, please visit
www.EXFO.com/recycle. Contact EXFO for prices and availability or to obtain the phone number of your local EXFO distributor.
For the most recent version of this spec sheet, please go to the EXFO website at
http://www.EXFO.com/specs
In case of discrepancy, the Web version takes precedence over any printed literature.
EXFO America 3701 Plano Parkway, Suite 160 Plano, TX 75075 USA Tel.: 1 800 663-3936 Fax: 1 972 836-0164 EXFO Europe Omega Enterprise Park, Electron Way Chandlers Ford, Hampshire S053 4SE ENGLAND Tel.: +44 2380 246810 Fax: +44 2380 246801 EXFO Asia 151 Chin Swee Road, #03-29 Manhattan House SINGAPORE 169876 Tel.: +65 6333 8241 Fax: +65 6333 8242 EXFO China No. 88 Fuhua, First Road, Central Tower, Room 801 Shenzhen 518048, CH INA Tel.: +86 (755) 8203 2300 Fax: +86 (755) 8203 2306
Futian District Beijing New Century Hotel Office Tower, Room 1754-1755 Beijing 100044 P. R. CHINA Tel.: +86 (10) 6849 2738 Fax: +86 (10) 6849 2662 No. 6 Southern Capital Gym Road
PPM-350B
PON Power Meter
Rugged Handheld Solutions
OTDR s OLTSs Power meters Light sources Talk sets
OPTICAL
ADSL/ADSL2+, SHDSL, VD SL test sets
VoI P and IPTV test sets Ethernet test sets POTS test sets
COPPER ACCESS
Platform-Based Solutions
OTDR s OLTSs ORL meters Variable attenuators
OPTICAL FIB ER
OSAs PMD analyzers Chromatic
dispersion analyzer
DWDM TEST SYSTE MS
Next-generation SONET/SDH and OTN testers SONET/DSn (DS0 to OC-192) testers SDH/ PDH (64 kbit/s to STM-64) testers T1/T3, E1 testers 10/100 Mbit/s and Gigabit Ethernet testers Fibre Channel testers 10 Gigabit Ethernet testers
TRANSPORT AND DATACOM
ORDERING INFORMATION
PPM-352B-EG-ER-XX
SPECIFICATIONS
a
PPM-352B-EG-ER
BPON EPON/GPON Power measurement range – pass zone 1310 nm 10 to –40 for continuous data stream (dBm) 1490 nm 12 to –40
1550 nm 25bto –40 Burst mode measurement capability: CO to ONT Burst mode measurement range b(dBm) 1310 nm 10 to –33 10 to –29 ORL c(dB) 1550 nm 55 Pass through insertion loss b(dB) 1.5 Spectral passband (nm) 1310 nm 1260 to 1360
1490 nm 1480 to 1500
1550 nm 1539 to 1565 Power uncertainty at calibrated 0.5 wavelengths
b, d
(dB) Refresh rate of display (Hz) 2.5 Calibrated wavelengths (nm) 1310, 1490, 1550 Threshold sets 10 configurable threshold sets with threshold naming Autonomy b(hours) > 30 Number of ports 2 Warranty and recommended 1 calibration interval (year)
User guide, three AA batteries, wrist strap, PC threshold-transfer software, RS-232 cable.
STANDARD ACCESSORIES
Size (H x W x D) 185 mm x 100 mm x 55 mm (7 1/4 in x 4 in x 2 1/8 in) Weight 0.4 kg (0.9 lb) Temperature
operating –10 °C to 50 °C (14 °F to 122 °F) storage –40 °C to 70 °C (–40 °F to 158 °F)
Relative humidity 0 % to 95 % non-condensing
GENERAL SPECIFICATIONS
Model
PPM-35
2B-EG-ER = PON power meter, two ports, BPON,
extended range EPON, G PON
Connector
e
EI-EUI-28 = UPC/ DIN 47256 EI-EUI-76 = UPC/HMS-10/AG EI-EUI-89 = UPC/FC narrow key EI-EUI-90 = UPC/ST EI-EUI-
91 = UPC/SC
EI-EUI-95 = UPC/ E-2000 EA-EUI-28 = APC/DIN 47256 EA-EUI-89 = APC/ FC narrow key EA-EUI-
91 = APC/SC
EA-EUI-95 = APC/E-2000
Example: PPM-352B-EG-E R-EA-EUI-91
Notes
a. At room temperature. b. Typical. c. For APC connectors. Typically > 35 dB for UPC connectors. d. Around –7 dBm, CW. e. S ame connectors for both ports.
Loading...