No part of this manual may be reproduced, transcribed, transmitted, or translated in
any language, in any form or by any means, except duplication of documentation by
the purchaser for backup purpose, without written consent of ASRock Inc.
Products and corporate names appearing in this manual may or may not be registered trademarks or copyrights of their respective companies, and are used only for
identification or explanation and to the owners’ benefit, without intent to infringe.
Disclaimer:
Specifications and information contained in this manual are furnished for informational use only and subject to change without notice, and should not be constructed
as a commitment by ASRock. ASRock assumes no responsibility for any errors or
omissions that may appear in this manual.
With respect to the contents of this manual, ASRock does not provide warranty of
any kind, either expressed or implied, including but not limited to the implied warranties or conditions of merchantability or fitness for a particular purpose.
In no event shall ASRock, its directors, officers, employees, or agents be liable for
any indirect, special, incidental, or consequential damages (including damages for
loss of profits, loss of business, loss of data, interruption of business and the like),
even if ASRock has been advised of the possibility of such damages arising from any
defect or error in the manual or product.
3. Power Menu ..................................................................... 30
4. Boot Menu ......................................................................... 31
5. Exit Menu .......................................................................... 32
3
Chapter 1 Introduction
Thank you for purchasing ASRock P4i45G / P4i45GL / P4i45GV / P4i45GE motherboard,
a reliable motherboard produced under ASRock’s consistently stringent quality control.
It delivers excellent performance with robust design conforming to ASRock’s
commitment to quality and endurance.
Chapter 1 and 2 of this manual contain introduction of the motherboard and step-bystep installation guide for new DIY system builders. Chapter 3 and 4 contain basic
BIOS setup and Support CD information.
For advanced users’ reference, the Appendix appearing on page 26 offers more
advanced BIOS setup information.
Because the motherboard specifications and the BIOS software
might be updated, the content of this manual will be subject to
change without notice. In case any modifications of this manual
occur, the updated version will be available on ASRock website
without further notice.
ASRock website http://www.asrock.com
1.1 Package Contents
ASRock P4i45G or P4i45GL or P4i45GV or P4i45GE motherboard
(Micro ATX form factor: 9.6" x 9.6", 24.4 x 24.4 cm)
ASRock P4i45G / P4i45GL / P4i45GV / P4i45GE Quick Installation Guide
ASRock Intel-Intel Support CD
1 cable for IDE devices (1 x ATA 66 / 100)
1 cable for floppy drive (1 x ribbon cable)
1 ASRock I/O shield
1 COM port bracket
4
1.2 Specifications
Platform:Micro ATX form factor (9.6" x 9.6", 24.4 x 24.4 cm)
CPU:Socket 478 for Intel® Pentium® 4
/ Celeron
Chipsets:North Bridge on P4i45G motherboard: Intel® 845G chipsets,
standard FSB 533 MHz, Max. 800 MHz (see CAUTION 1),
supports Hyper-Threading Technology (see CAUTION 2);
North Bridge on P4i45GL motherboard: Intel® 845GL chipsets,
standard FSB 400 MHz (see CAUTION 3),
Max. 533 MHz (see CAUTION 1);
North Bridge on P4i45GV motherboard: Intel® 845GV chipsets,
standard FSB 533 MHz,
supports Hyper-Threading Technology (see CAUTION 2);
North Bridge on P4i45GE motherboard: Intel® 845GE chipsets,
standard FSB 533 MHz, Max. 800 MHz (see CAUTION 1),
supports Hyper-Threading Technology (see CAUTION 2);
IDE2: ATA 100 / Ultra DMA Mode 5;
Can connect up to 4 IDE devices
Floppy Port:Supports floppy disk drive
Audio:5.1 channels AC’97 Audio
PCI LAN:Speed: 802.3u (10/100 Ethernet), supports Wake-On-LAN
Hardware Monitor: CPU temperature sensing (ASRock U-COP);
CPU overheat shutdown to protect CPU life (ASRock U-COP)
(see CAUTION 4); Chassis temperature sensing;
Voltage monitoring: +12V, +5V, +3V, Vcore;
CPU fan tachometer; Chassis fan tachometer
PCI slots:3 slots with PCI Specification 2.2
AGP slot:1 AGP slot, supports 1.5V, 4X AGP card (see CAUTION 5)
(AGP Slot only available on P4i45G/P4i45GE Motherboard)
®
processor
5
AMR slot:1 slot, supports ASRock MR card (optional)
USB 2.0:4 default USB 2.0 ports and 1 extra set of header for 2 additional
USB 2.0 ports upgrade (see CAUTION 6)
ASRock I/OTM:PS/2: 1 keyboard port / 1 mouse port;
1 RJ 45 port; 4 rear default USB 2.0 ports;
1 VGA port; 1 parallel port: ECP/EPP support;
Audio Jack: Line Out/ Line In/ Microphone + Game port
BIOS:AMI legal BIOS; Supports “Plug and Play”;
ACPI 1.1 compliance wake up events;
Supports jumperfree; SMBIOS 2.3.1 support;
CPU frequency stepless control
(only for advanced users’ reference, see CAUTION 7)
OS:Microsoft® Windows® 98SE / ME / 2000 / XP compliant
CAUTION!
1. P4I45G/P4I45GL/P4I45GE motherboard may be fine tuned to support higher
CPU bus frequencies on certain condition. Please refer to the tables on
pages 7-9 for the details.
2. About the setting of “Hyper Threading Technology”, please check
page 26.
3. If the installed CPU runs with the front side bus frequency at 533 MHz on
P4i45GL motherboard, it will only support DDR 266.
4. While CPU overheat is detected, the system will automatically shutdown.
Please check if the CPU fan on the motherboard functions properly before
you resume the system. To improve heat dissipation, remember to spray
thermal grease between the CPU and the heatsink when you install the
PC system.
5. Do NOT plug a 3.3V AGP card in the AGP slot on P4i45G/P4i45GE
motherboard! It may cause permanent damage!
6. Power Management for USB 2.0 works fine under Microsoft® Windows
XP. It may not work properly under Microsoft® Windows® 98/ME/2000.
Please refer to Microsoft® official document at
http://www.microsoft.com/HWDEV/BUS/usb/USB2support.asp
7. Although P4i45G / P4i45GL / P4i45GV / P4i45GE offers stepless control,
it is not recommended to perform over clocking. When the CPU
frequency of P4i45G / P4i45GL / P4i45GV / P4i45GE is set to perform
over clocking, other clocks, such as PCI clock, AGP clock, and Memory
clock will also be overclocked proportionally. Frequencies other than the
recommended CPU bus frequencies may cause the instability of the
system or damage the CPU and the motherboard.
®
6
NOTE
P4i45G, P4i45GL, and P4i45GE may be fine tuned to support higher CPU front side bus
frequencies on certain condition. Please refer to the table below for the details.
CPU FSB Configuration Note
P4i45G800 MHz 1. Set the “FSB” jumper to “TEST” mode (see page 18).
2. Only support one DDR 333 memory module.
P4i45GL533 MHz Only support DDR 266 memory module.
P4i45GE800 MHz 1. Set the “FSB” jumper to “TEST” mode (see page 18).
2. Only support one DDR 400 memory module.
(If it is set to DDR 400 mode, then it does not
support CL3 module.)
The Recommended Memory Modules list for
P4i45G motherboard.
FSB 800 MHz / DDR 300 Mode
DRAMSIZE TYPECELLCELL NO.SINGLE SIDE /VGAVGA
VENDOR(MB)VENDORDOUBLE SIDE(Add on) (On-board)
APACER256DDR400 SAMSUNG K4H560838D-TCC4 SINGLE SIDEOKOK
NANYA512DDR333 NANYANT5DS32M8AT-6DOUBLE SIDEOKOK
Since the memory types are changing rapidly, please visit ASRock website
(http://www.asrock.com/support/index.htm) for the latest recommended memory support list.
7
The Recommended Memory Modules list for P4i45GL motherboard.
FSB 533 MHz / DDR 266 Mode
DRAMSIZE TYPECELLCELL NO.SINGLE SIDE /
VENDOR(MB)VENDORDOUBLE SIDE
TWINMOS256DDR266M.TECTTD7608F8E75BSINGLE SIDE
TWINMOS256DDR266HYNIXHY5DU28822AT-HSINGLE SIDE
TWINMOS128DDR266M.TECTTD7608F8E75BSINGLE SIDE
TWINMOS256DDR266M.TECTTD7608F8E76DSINGLE SIDE
TWINMOS512DDR333WINBOND W942508AB-6DOU BLE S IDE
KINGMAX128DDR266KINGMAXKDL684T4A2C-07ASINGLE SIDE
KINGMAX256DDR266KINGMAXKDL684T4AA-75DOUBL E SIDE
KINGSTON256DDR266KINGSTON D328DM-75SINGLE SIDE
KINGSTON128DDR266MOSELV58C2128804SAT7SINGLE SIDE
KINGSTON256DDR333MOSELV58C225680SAT6SINGLE SIDE
HYNIX256DDR333HYNIXHY5DU28822BT-JDOUBLE SIDE
TRANSCEND 128DDR266SAMSUNG K4H280838C-TCB0SINGLE SIDE
TRANSCEND 256DDR266MITSUBISHI 24099A38-75SINGLE SIDE
INFINEON256DDR333INFINEON HYB250256800BT-6SINGLE SIDE
ELIXIR256DDR266ELIXIRN2DS12880AT-75BDOUB LE SIDE
APACER128DDR266NANYANT5DS16M8AT-7KSINGLE SIDE
SAMSUNG256DDR266SAMSUNG K4H280838C-TCB0SINGLE SIDE
Since the memory types are changing rapidly, please visit ASRock website
(http://www.asrock.com/support/index.htm) for the latest recommended memory support list.
8
The Recommended Memory Modules list for P4i45GE motherboard.
FSB 800 MHz / DDR 400 Mode
(only support one DDR 400 memory module)
DRAMSIZE TYPECELLCELL NO.SINGLE SIDE /
VENDOR(MB)VENDORDOUBLE SIDE
TWINMOS512DDR400 TWINMOS TMD7608F8E508DOUBLE SIDE
KINGMAX256DDR400 KINGMAXKDL684T4AA-50DOUBLE SIDE
KINGSTON256DDR400 WINBOND W942508BH-5SINGLE SIDE
APACER256DDR400 SAMSUNG K4H560838D-TCC4 SINGLE SIDE
FSB 533MHz / DDR 333 Mode
DRAMSIZE TYPECELLCELL NO.SINGLE SIDE /
VENDOR(MB)VENDORDOUBLE SIDE
KINGSTON512DDR333 INFINEON HYB25D256800BT-6 DOUBLE SIDE
KINGSTON256DDR333 MOSELV58C2256804SAT6 SINGLE SIDE
KINGMAX256DDR333 KINGMAXKDL684T4AA-60DOUBLE SIDE
TWINMOS256DDR333 TWINMOS TMD7608F8E60BSINGLE SIDE
HYNIX256DDR333 HYNIXHY5DU28822BT-J DOUBLE SIDE
HYNIX128DDR333 HYNIXHY5DU28822BT-J SINGLE SIDE
TRANSCEND 512DDR333 SAMSUNG K4H560838D-TCB3 DOUBLE SIDE
TRANSCEND 256DDR333 SAMSUNG K4H560838D-TCB3 SINGLE SIDE
INFINEON256DDR333 INFINEON HYB250256800BT-6 DOUBLE SIDE
MICRON256DDR400 MICRONMT46V16M8DOUBLE SIDE
MICRON512DDR333 MICRONMT46V32M8DOUBLE SIDE
NANYA512DDR333 NANYANT5DS32M8AT-6DOUBLE SIDE
Since the memory types are changing rapidly, please visit ASRock website
(http://www.asrock.com/support/index.htm) for the latest recommended memory support list.