AOC L19W861 User Manual

TABLE OF CONTENTS

FOR YOUR SAFETY …………………………………………………….... 2

PRCAUTIONS AND REMINDERS ………………………………………. 4

English

IMPORTANT SAFETY INSTRUCTIONS ……………………………….. 6 Package Contents………………………………………………… 8

Attaching the Base ………………………………………………… 8 Preparing Your LCD HDTV for Wall Mounting ……………… 9

PREPARATION …………………………………………………………… 10 PERIPHERAL CONNECTION GUIDE …………………………………. 12 OPERATING INSTRUCTIONS …………………………………………. 14

TO USE THE FRONT PANEL CONTROL ……………………... 14 TO USE THE REMOTE CONTROL ………………………….…. 15 VIEWING MODES ILLUSTRATIONS ………………………….…. 16 CONNECTING EQUIPMENT ………………………….………. 18 TO USE THE MENUS ……………………………………………. 30 SETUP MENU …………………………………………………….. 30 VIDEO MENU ……………………………………………………... 31 AUDIO MENU ……………………………………………………... 32 FEATURE MENU …………………………………………………. 33

TIPS ………………………………………………………………… 37 PRODUCT SPECIFICATION ………………………………………...…. 39 BEFORE CALLING SERVICE ……………………………………..…… 40

GLOSSARY ……………………………………………………….. 41

SYMBOL SYMBOL DEFINITION

DANGEROUS VOLTAGE: The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated

SA 1965

“dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electrical shock to persons.

INSTRUCTIONS: The exclamation point within on equilateral triangle to alert the User to the presence of important operating and maintenance (servicing)

SA 1966

instruction In the literature accompanying the appliance.

Apparatus shall not be exposed to dripping or splashing and no objects filled with liquids, Such as vases, Shall be placed on the apparatus. Caution - Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.

FOR YOUR SAFETY

Before operating the TV please read this manual thoroughly. This manual should be retained for future reference.

FCC Class B Radio Frequency Interference Statement WARNING: (FOR FCC CERTIFIED MODELS)

NOTE: This equipment has been tested and found to comply with the limits for a

Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

1. Reorient or relocate the receiving antenna.

2. Increase the separation between the equipment and receiver.

3. Connect the equipment into an outlet on a circuit different from that to which

the receiver is connected.

4. Consult the dealer or an experienced radio/TV technician for help.

NOTICE

1. The changes or modifications not expressly approved by the party

responsible for compliance could void the user's authority to operate the equipment.

2. Shielded interface cables and AC power cord, if any, must be used in order to

comply with the emission limits.

3. The manufacturer is not responsible for any radio or TV interference caused

by unauthorized modification to this equipment. It is the responsibilities of the user to correct such interference.

WARNING:

To prevent fire or shock hazard, do not expose the TV to rain or moisture. Dangerously high voltages are present inside the TV. Do not open the cabinet. Refer servicing to qualified personnel only.

SAFETY: Lamp Disposal

LAMP(S) INSIDE THIS PRODUCT CONTAIN MERCURY AND MUST BE RECYCLED OR DISPOSED OF ACCORDING TO LOCAL, STATE OR FEDERAL LAWS. FOR MORE INFORMATION, CONTACT THE ELECTRONIC INDUSTRIES ALLIANCE AT WWW.EIAE.ORG.

DIGITAL TELEVISION TRANSITION NOTICE

This device contains a digital television tuner, so it should receive digital over the air TV programming, with a suitable antenna, after the end of full-power analog TV broadcasting in the United States on February 17, 2009. Some older television receivers, if they rely on a TV antenna, will need a TV Converter to receive over the air digital pro-gramming, but should continue to work as before for other purposes (e.g., for watching low-power TV stations still broadcasting in analog, watching pre-recorded movies, or playing video games).

For more information,

call the FCC at 1-888-CALL-FCC (1-888-225-5322)

or see www.DTV.gov. For information on th e TV Conv erter program, and on

government coupons that may be used toward the purchase

of one, see www.dtv2009.gov

or call the NTIA at 1-888-DTV-2009.

AVISO RELATIVO A LA TRANSICIÓN A TELEVISIÓN DIGITAL

Este equipo incorpora un sintonizador de televisión digital, lo que le permitirá recibir una programación digital televisada por aire, con una antena adecuada, cuando se terminará la transmisión de alta potencia de la televisión analógica en los Estados Unidos el 17 de febrero de 2009. Ciertos receptores de televisión antiguos, si dependen de una antena de TV, necesitarán un conversor de TV para recibir por el aire una programación digital, pero seguirán funcionando como antes para otros usos (por ejemplo para ver emisoras de TV de baja potencia que todavía transmiten en analógico, para ver películas pregrabadas, o para utilizar sus videojuegos).

Para obtener más información,

llame FCC 1-888-CALL-FCC (1-888-225-5322)

o refiérase a www.DTV.gov. Para toda información sobre el programa de

conversores de TV, y acerca de los cupones del gobierno que se pueden usar

para comprarlos, refiérase a www.dtv2009.gov

o llame al NTIA al 1-888-DTV-2009.

PRECAUTIONS AND REMINDERS

Place unit on even surfaces.

Don't place the TV in confined spaces or in a box when using it.

Unplug immediately if is malfunction like no picture, no video/audio,smoke and bad odor from TV.

Don't throw any object inside the TV box like metals or other flammable materials.

Unplug immediately if other foreign materials are put inside TV box or if the TV fell down.

Prohibit/Avoid opening TV cabinet

Remember to unplug the AC cord from the AC outlet before cleaning. Do not use liquid cleaners or aerosol cleaners to clean the display.

Avoid direct sunlight, dusty, high humidity and smoky areas.

Make sure to unplug the unit when not in use for a long period of time (days).

Do not cover or block any vents and openings. Inadequate ventilation may shorten the life of the display unit and cause overheating.

Call service personnel to clean the internal part of the TV once a year.

Do not place the display near water, such as bathtub, washbasin, kitchen sink laundry tub, swimming pool or in a damp basement.

Notice for Remote Controller

Avoid Dropping Avoid Liquids Avoid Aerosol Cleaners

IMPORTANT SAFETY INSTRUCTIONS

Read before operating equipment

1. Read these instructions.

2. Keep these instructions.

3. Heed all warnings.

4. Follow all instructions.

5. Do not use this apparatus near water.

6. Clean only with a dry cloth.

7. Do not block any of the ventilation openings. Install in accordance with the

manufacturers instructions.

8. Do not install near any heat sources such as radiators, heat registers, stoves,

or other apparatus (including amplifiers) that produce heat.

9. Do not defeat the safety purpose of the polarized or grounding type plug. A

polarized plug has two blades with one wider than the other. A grounding type plug has two blades and third grounding prong. The wide blade or third prong is provided for your safety. When the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet.

10. Protect the power cord from being walked on or pinched particularly at plugs,

convenience receptacles, and the point where they exit from the apparatus.

11. Only use attachments/accessories specified by the manufacturer.

12. Use only with a cart, stand, tripod, bracket, or table specified by the

manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over.

13. The TV should be operated only from the type of power source indicated on

the label. If you are not sure of the type of power supplied to your home, consult your dealer or local power company.

14. Unplug this apparatus during lightning storms or when unused for long

periods of time.

15. Refer all servicing to qualified service personnel. Servicing is required when

the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.

16. This product may contain lead or mercury. Disposal of these materials may

be regulated due to environmental considerations. For disposal or recycling information, please contact your local authorities or the Electronic Industries Alliance: www.eiae.org

17. Damage Requiring Service – The appliance should be serviced by qualified

service personnel when: A. The power supply cord or the plug has been damaged; or B. Objects have fallen, or liquid has been spilled into the appliance; or C. The appliance has been exposed to rain; or D. The appliance does not appear to operate normally or exhibits a marked

change in performance; or

E. The appliance has been dropped, or the enclosure damaged.

18. Tilt/Stability – All televisions must comply with recommended international

global safety standards for tilt and stability properties of its cabinets design. y Do not compromise these design standards by applying excessive pull

force to the front, or top, of the cabinet, which could ultimately overturn the product.

y Also, do not endanger yourself, or children, by placing electronic

equipment/toys on the top of the cabinet. Such items could unsuspectingly fall from the top of the set and cause product damage

19. Wall or Ceiling Mounting – The appliance should be mounted to a wall or

20. Pow er Lines – An outdoor antenna should be located away from power lines.

21. Outdoor Antenna Grounding – If an outside antenna is connected to the

and/or personal injury.

ceiling only as recommended by the manufacturer.

receiver, be sure the antenna system is grounded so as to provide some protection against voltage surges and built up static charges. Section 810 of the National Electric Code, ANSI/NFPA No. 70-1984, provides information with respect to proper grounding of the mats and supporting structure grounding of the lead-in wire to an antenna-discharge unit, size of grounding connectors, location of antenna-discharge unit, connection to grounding electrodes and requirements for the grounding electrode. See Figure below.

EXAMPLE OF ANTENNA GROUNDING AS PER NATIONAL ELECTRICAL CODE Note to the CATV system installer: This reminder is provided to call the CATV system installer’s attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical. Please, make sure to connect the power plug to the wall outlet socket after connecting the TV to the adapter!

22. Objects and Liquid Entry – Care should be taken so that objects do not fall

and liquids are not spilled into the enclosure through openings.

Package Contents

◎AOC L19W861 TV unit

◎Remote Control ◎Two (AAA) Batteries for the Remote Control ◎Base ◎Power Cord ◎User Manual ◎Quick Setup Guide

IMPORTANT: Do not apply pressure to the screen display area which may compromise the integrity of the display. The manufacturer’s warranty does not cover user abuse or improper installations.

Attaching the Base

IMPORTANT: The Base of the HDTV must be assembled prior to usage.

1. Place TV unit face down on a soft and flat surface (blanket, foam, cloth, etc.) to prevent any damage to the HDTV.

2. Carefully align and insert the Base to the stand.

3. Gently push the Base towards the HDTV until the locking mechanism locks into place.

Preparing Your LCD HDTV for Wall Mounting

We suggest that you keep your TV at least

2.36 inches (60 mm) from the wall to prevent cable interference. Before mounting your TV on the wall, you need to remove the base.

To attach a wall mount bracket to your TV: 1 Remove the screws holding your TV to the stand. 2 Remove the stand base. 3 Secure the wall mount bracket to the back of your TV using four M4 screws,

as indicated in the illustration.

Note: 100mmx100mm wall mount bracket & M4 screws not included.

PREPARATION

Please, make sure to connect the power plug to the wall outlet socket after connecting the TV to the power cord!

. Install the base stand; place the TV on a solid surface.

Ensure that the TV is placed in a position to allow free flow of air. Do not cover the ventilation openings on the back cover. To prevent any unsafe situations, no naked flame sources, such as lighted candles, should be placed on or in the vicinity. Avoid heat, direct sunlight and exposure to rain or water. The equipment shall not be exposed to dripping or splashing.

2. Connect the antenna cable or CATV cable to the aerial socket ANT IN 7 5Ω at the back of the TV set.

3. Remote control:

Remove the cover of the battery compartment. Insert the 2 batteries supplied

(Type AAA 1.5V).

4. Power: Insert the power cord in the wall socket having an AC power supply. You can see LED states at the front panel. If the LED color is Blue, means the TV set is power on. If the LED color is Red, which means this TV set is in standby state.

5. Turn the TV on: Push the POWER key on the Remote control or the Front panel control knobs. Wait a minute, the TV will power on and can see the display on the screen

POWER Key

+ 30 hidden pages