2 DAC channels: 16-, 20-, or 24-bit
2 ADC channels: 16- or 20-bit
HD audio sample rates
8 kHz, 11.025 kHz, 16 kHz, 22.05 kHz, 32 kHz,
44.1 kHz,
Greater than 90 dB dynamic range
S/PDIF output: 32 kHz, 44.1 kHz or 48 kHz, 16- or 24-bit
Digital beep and analog PC beep pass-through
Integrated headphone amplifiers on two ports
Port retasking
Selectable microphone and line inputs
Full analog mixer
Mute MONO_OUT when a device is in the line out jack
Selectable trip level: high/low supports all jack types
Peripheral identification/enumeration
Jack event/presence detection using SENSE or GPIO pins
Microphone to MONO_OUT for speakerphone applications
Advanced power management modes
4 software-controlled microphone bias pins
Up to 30 dB microphone boost
4 GPIOs—external control or traditional jack sense
GA
GA
M
M
Σ
M
MM
MM
GA
GA
supply, 3.3 V DVDD supply
DD
when headphones are used
AV
DD
AV
SS
PC BEEP
GAM
Σ
SELECTOR
GAMHP
SELECTOR
MIC
BOOST
MIC
BOOST
Z
HP
Z
Z
BIAS
GAM
SELECTOR
BIAS
GAM
SELECTOR
5V
RESET
MONO_OUT
PORT-A
HEADPHONE
MIC_BIAS-D
Z
PORT-D
LINE_OUT
MIC_BIAS-C
PORT-C
LINE_IN
MIC
BIAS
GAM
PCM/FLOAT32
Σ-Δ ADC
MG
SELECTOR
AUX
PORT-E
DIFF
AMP
CD_R
CD_GND
M
M
CD_L
SELECTOR
BOOST
MIC
BIAS
BOOST
Figure 1.
Rev. 0
Information furnished by Analog Devices is believed to be accurate and reliable.
However, no responsibility is assumed by Analog Devices for its use, nor for any
infringements of patents or other rights of third parties that may result from its use.
Specifications subject to change without notice. No license is granted by implication
or otherwise under any patent or patent rights of Analog Devices. Trademarks and
registered trademarks are the property of their respective owners.
TEMPERATURE 25 °C
DIGITAL SUPPLY (DVDD) 3.3 ±10% V
ANALOG SUPPLY (AVDD) 5.0 ±10% V
SAMPLE RATE (FS) 48 kHz
INPUT SIGNAL 1.0 kHz
ANALOG OUTPUT PASS BAND 20 to 20,000 Hz
V
IH
V
IL
V
IH
V
IL
2.0 V
0.8 V
2.4 V
0.6 V
DAC Test Con diti ons
rated
Calib
Output −3 dB relative to full scale
10 kΩ output load, Ports C, D, F, and mono
32 Ω output load, Port A
ADC Test Conditions
Calib
rated
0 dB PGA gain
Input −3.0 dB relative to full scale
Input sourced on Port B, 0 dB boost
Table 2. Analog Input
Parameter Min Typ Max Unit
PORTS B, C, D, E: 0 dB 1 V rms
2.83 V p-p
PORTS B, C, D, E: 30 dB 0.032 V rms
0.089 V p-p
PORTS B, C, D, E: 20 dB 0.1 V rms
0.283 V p-p
PORTS B, C, D, E: 10 dB 0.316 V rms
0.894 V p-p
PORT F, CD IN 1 V rms
2.83 V p-p
INPUT IMPEDANCE
INPUT CAPACITANCE 5 7.5 pF
1
RMS values assume sine wave input.
2
Guaranteed by design; not production tested.
2
20 kΩ
1
Table 3. Master Volume
Parameter Min Typ Max Unit
STEP SIZE (Ports A, B, C, D, E, MONO_OUT) 1.5 dB
OUTPUT GAIN RANGE –46.5 +3 dB
MUTE ATTENUATION OF 0 dB FUNDAMENTAL80 dB
1
Guaranteed by design; not production tested.
Rev. 0 | Page 4 of 16
AD1981HD
www.BDTIC.com/ADI
Table 4. Programmable Gain Amplifier—ADC
Parameter Min Typ Max Unit
STEP SIZE 1.5 dB
PGA GAIN RANGE SPAN 0.0 22.5 dB
Table 5. Analog Mixer—Input Gain/Amplifiers/Attenuators
Parameter Min Typ Max Unit
SIGNAL-TO-NOISE RATIO (SNR)
Line In to Line Out 85 dB
Microphone In to Line Out
STEP SIZE: ALL MIXER INPUTS (Except PC BEEP) 1.5 dB
STEP SIZE: PC BEEP 3.0 dB
INPUT GAIN RANGE: ALL MIXER INPUTS (Except PC BEEP) −34.5 +12.0 dB
DIGITAL PC BEEP −45.0 0.0 dB
1
Guaranteed by design; not production tested.
Table 6. Digital Decimation and Interpolation Filters
Parameter Min Typ Max Unit
PASS BAND 0 0.4 × F
PASS-BAND RIPPLE ±0.09 dB
TRANSITION BAND 0.4 × F
STOP BAND 0.6 × F
STOP-BAND REJECTION −74 dB
GROUP DELAY 16/F
GROUP DELAY VARIATION OVER PASS BAND 0 μs
1
Guaranteed by design; not production tested.
1
1
80 dB
Hz
S
S
S
0.6 × F
∞ Hz
S
sec
Hz
S
Table 7. Analog-to-Digital Converters
Parameter Min Typ Max Unit
RESOLUTION 20 Bits
TOTAL HARMONIC DISTORTION (THD) −95 dB
DYNAMIC RANGE (−60 dB Input, THD + N Referenced to Full Scale, A-Weighted) −85 dB
CROSSTALK: LINE INPUTS (Input L, Ground R, Read R; Input R, Ground L, Read L) −80 dB
CROSSTALK: LINE INPUTS AND OTHER INPUTS −100 −80 dB
GAIN ERROR (Full-Scale Span Relative to Nominal Input Voltage) ±10 %
INTERCHANNEL GAIN MISMATCH (Difference of Gain Errors) ±0.5 dB
ADC OFFSET ERROR ±5 mV
Table 8. Digital-to-Analog Converters
Parameter Min Typ Max Unit
RESOLUTION 24 Bits
TOTAL HARMONIC DISTORTION (Line Out) −92 dB
TOTAL HARMONIC DISTORTION (Headphone Out) −75 dB
DYNAMIC RANGE (−60 dB Input, THD + N Referenced to Full Scale, A-Weighted) 90 dB
GAIN ERROR (Full-Scale Span Relative to Nominal Input Voltage) ±10 %
INTERCHANNEL GAIN MISMATCH (Difference of Gain Errors) ±0.7 dB
DAC CROSSTALK1 (Input L, Zero R, Read R Out; Input R, Zero L, Read L Out) −80 dB
1
Guaranteed by design; not production tested.
Rev. 0 | Page 5 of 16
Loading...
+ 11 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.