Amana ACF3375A Quick Reference Guide
Quick Start Reference Guide
Covering model ACF3375A
Refer to Installation Instructions and Owners Manual for safety statements.
Getting Ready
1. Remove storage drawer and verify that the anti tip bracket has been
installed and is engaged. Refer to
2. Read important safety instructions in Owner’s Manual.
3. Burner caps and grates must be placed correctly . Burner caps should
match the size of the burner base. Once caps are placed, grate needs
to be placed over the burners. Refer to
in the Owner’s Manual.
4. Remove all hanging tags and paper from the range. Check the inside oven
cavity for paper. Remove any residue with non abrasive cleanser. Do not
store paper in range, oven or storage drawer, or around range. For more
information, refer to
Care and Cleaning
Installation Instructions
Adjusting Burner Flame
section in the Owner’s Manual.
for details.
section
Setting the
¸
(1 through 0) to set the clock to the
correct time of day. The clock is a
twelve hour clock and does not display
AM, PM, or military time. To set time,
press START pad.
Clock
To set the clock, press the
CLOCK pad. Use digit pads
Operating Your New Range
It is normal for all four burner electrodes to spark when
one burner is turned on.
Burners should ignite within 4 seconds. If not, refer to
Adjusting Burner Flame
Oven may make noise during a heating or cooling cycle,
especially during a self-clean. This is normal. It is the sound of the oven cavity
expanding and contracting.
Do not allow flames to extend up the sides of the cooking utensil. This may
cause burns or damage.
Oven may generate smoke the first few times operated, especially during a
self-clean cycle. This is normal. If possible, ventilate odors.
Remove birds and animals from area when using the self-clean cycle.
Refer to
Surface burners should not be used during a self-clean cycle. A self-clean cycle
can be set for times when the oven is not in use. Refer to
the Owner’s Manual for more information.
Self-cleaning
section in the Owner’s Manual for more information.
section in Owner’s Manual.
Self-cleaning
section in
Questions?
:
Using the
Minute Timer
The minute timer is a timer only ,
and does not control baking, broiling or
cleaning functions of the oven. To set
timer, press TIMER ON/OFF pad. Use
digit pads (1 through 0) to enter the
desired time. Timer can be set up to 11
hours and 59 minutes. Timer begins
after 5 seconds of no further time
adjustment. To cancel timer, press
and hold TIMER ON/OFF pad for
five seconds or press the OVEN
CANCEL pad. At the end of the cycle,
END displays, timer signals three one
second beeps, and then once
approximately every 30 seconds until
CANCEL is pressed.
Refer to Owners Manual or
call Amana Consumer Affairs Department
1-800-843-0304
Quick Start Reference Guide
B
Bake
To bake in your new oven:
1. Arrange racks to desired position.
2. Press BAKE pad. Enter desired temperature using the digit pads (1 through 0).
• Temperature will be displayed in clock area.
• The default temperature is 350°F.
3. Press START pad. Oven will begin to heat automatically.
4. Once oven has reached selected temperature, a signal will sound.
5. To shut off oven, press OVEN CANCEL pad.
Timed Bake
To set the oven to perform a timed bake:
1. Arrange racks to desired position.
2. Press COOK pad. Use the digit pads to enter the selected amount of time.
3. Press BAKE pad. Use the digit pads to enter the selected temperature.
• Temperature will be displayed in clock area
• The default temperature is 350°F.
4. Press START pad. Oven begins to heat automatically.
5. When cooking time has elapsed, a signal will sound and END will be displayed.
6. To shut off oven, press OVEN CANCEL pad.
Delayed Bake
NOTE: Do not use delayed bake with any dairy, meat, or egg products:
1. Arrange racks to desired position.
2. Press STOP pad. Use the digit pads to enter the stop time.
3. Press COOK pad. Use the digit pads to enter the selected amount of time.
4. Press BAKE pad. Use the digit pads to enter the selected temperature.
• Temperature will be displayed in clock area
• The default temperature is 350°F.
5. Press START pad.
Oven control will automatically calculate the start time.
6. When start time is reached, oven will begin to heat.
7. When cooking time has elapsed, a signal will sound.
Self-Clean
To set a self-clean cycle in your
oven:
1. Prepare the oven and surrounding
area for self-clean (refer to Self-
cleaning section in Owner’s Manual).
2. Remove all animals from area and, if
possible, open a window the first few
self-clean cycles.
3. Remove all pans, broiler pans, oven
racks and accessories from inside
oven, range top, backguard and
storage drawer.
4. Remove excess spills from oven
interior and oven burner well.
Refer to Placing Oven Bottom in
Owner’s Manual.
5. Press CLEAN pad.
• CLEAN will display.
6. Default cycle time of 3 hours displays.
Cycle can be set from 2 to 4 hours by
adjusting time with digit pads.
7. Press START pad.
• Surface burners SHOULD NOT
be used during a self-clean cycle.
8. Self-clean will begin. Oven door will
automatically lock during the cycle.
9. When complete, oven will beep and
LOCK light will shut off. Oven may
still be warm to touch. DO NOT
force oven door.
Broil
NOTE: Oven door MUST be closed during broiling.
1. Arrange racks to desired position.
2. Place food in oven. Preheating is not required.
3. Close door.
4. Press BROIL pad.
5. Using digit pads, select a broil setting from HI (5) to LO (1).
6. Press START pad.
7. BROIL will display in clock area and oven will heat automatically.
Broil cycle will pause if oven door is open for more than 3 minutes.
8. When finished cooking, press OVEN CANCEL.
Part No.36-31980601-0
Printed in U.S.A.07/00
Amana Appliances Online
• http://www.amana.com
Y our oven temperatures are factory
set for the best performance. However,
to provide the flexibility to change
these settings, a temperature
adjustment feature has been added
for your convenience. Refer to your
Owner’s Manual for instructions.
2000 Amana Appliances
Amana, Iowa 52204
Loading...