Alpine KAC-001 User Manual

Forbidden

1/8 2/8

Types of Precautions

External Accessory Control Module Installation Manual

KAC-001

* Only compatible with Alpine head units with the external accessory control feature. * ADS i-Datalink Maestro is required to operate this external accessory control module.

Thank you for purchasing this Alpine product. Please take a moment to protect your purchase by registering your product now at the following address: www.alpine-usa.com/registration. Your will be informed of product and software updates (if applicable), special promotions and news about Alpine.

Disclaimer

The KAC-001 External Accessory Control Module works with various accessory products manufactured by third parties. Please review and follow all manufacturer’s instructions and warnings for all accessory products.

Introduction

Design and speciﬁcations are subject to change without notice for improvement. This product has 8 low current outputs designed to control a number of third party

accessories.

To Ensure Safe Use, Always Follow These Precautions

The installation of this product requires specialized skills and experience. We

recommend that you have the product installed by the store that you purchased it from.

Before you use this product, be sure to carefully read this installation manual

and the separate user's manual so that you can use the product correctly. Alpine Electronics bears no responsibility for problems that arise as a result of failure to follow the instructions in the manuals.

This manual includes a number of symbols that are intended to help you use the

product safely, to prevent harm to you and others, and to protect against damage to property. These symbols and their meanings are listed below. Make sure you fully understand these symbols before you begin reading the main text.

Explanations of Injury and Damage That May Result from Incorrect Use

Forbidden

Indicates actions that are forbidden (must not be performed)

Indicates that disassembly is forbidden.

Mandatory

Indicates actions that are mandatory (must be performed)

Marks content that should receive your full attention.

Warning

Do not disassemble or modify the product. Doing so could lead to an accident, re, or electric shock.

Store screws and other small objects where small children cannot reach them. If one of these small objects is swallowed, consult with a doctor immediately.

When replacing fuses, be sure to use fuses with the specied current rating. Failing to do so could lead to an accident or re.

Only connect the product to a 12 VDC negative ground car. Failing to do so could lead to an accident or re.

Before you begin wiring, remove the ground wire from the negative terminal of the battery. Failing to do so could lead to electric shock or injury.

Do not cut the insulation on a cord and take power from another device. Doing so could lead to re or electric shock.

Do not install the product in a location where it will obstruct the driver’s forward view; interfere with the operation of the steering wheel, gearshift, or the like; or pose a threat to passengers. Doing so could lead to an accident or injury.

Mandatory

Forbidden

Ignoring the content marked by this indication and using

Warning

Caution

the product incorrectly is expected to lead to death or serious injury.

Ignoring the content marked by this indication and using the product incorrectly is only expected to lead to injury or property damage.

Do not install the product near the passenger-side airbag. Doing so could interfere with the operation of the airbag and lead to an accident or injury.

Bundle cords so that they don’t interfere with driving. Wrapping cords around the steering wheel, gearshift, brake pedal, or the like, could lead to an accident or damage equipment.

Take caution when wiring outputs to avoid unintentionally discharging the battery.

Forbidden

When making a hole in the vehicle body, be careful to avoid damaging pipes, the fuel tank, electrical wiring, and the like. This kind of damage could lead to an accident or re.

When installing and grounding the product, do not use any of the bolts or nuts of the steering wheel, brakes, fuel tank, or the like. Doing so could make the brakes stop working or lead to re.

Accessory List

Interface Module Power Harness Interface Harness

*Fuse Rating: 7A

8ch Output Harness Installation Manual

Forbidden

4/83/8

Caution

Connect the product properly according to the instructions. Failing to do so could lead to re or an accident.

Do not sandwich cords between the seat railing or allow them to touch protrusions. Resulting breaks or shorts could lead to electric shock or re.

Do not block vents or heat sinks. Doing so could lead to re or damage equipment.

Use the accessories according to the instructions, and attach them securely. Failing to do so could lead to an accident or damage equipment.

Do not install the product where it may be exposed to water or in a place with high levels of humidity or dust. Doing so could lead to re or damage equipment.

The installation and wiring of this product requires specialized skills and experience. Have the product installed and wired by the store that you purchased it from.

Forbidden

5/8 6/8

Component Connector View

SIDE VIEW

POWER RESET HEADUNIT CAN OUTPUT UPDATE

4 3 2 17 6 510 9 812 11

3 2 1

4 3 2 1 4 3 2 1

POWER (3-Pin White Connector)

Pin # Color Application Detail

1 BLACK Ground Lead Connect this lead to a good chassis ground on

the vehicle. Make sure the connection is made to bare metal and is securely fastened.

2 RED Ignition Connect this lead to an open terminal on the

vehicle’s fuse box or another unused power source which provides (+) 12V only when the

ignition is turned on or in the accessory position.

3 YELLOW Battery Lead Connect a fused 12V DC lead to the positive

(+) post of the vehicle battery.

OUTPUT (24-Pin Blue Connector)

Pin # Color Application Detail

17 PURPLE Output 1 (-) 250mA Accessory output

5 WHITE/RED Output 2 (-) 250mA Accessory output

18 BROWN Output 3 (-) 250mA Accessory output

6 BLUE Output 4 (-) 250mA Accessory output

19 GREEN Output 5 (-) 250mA Accessory output

7 PINK Output 6 (-) 250mA Accessory output

20 WHITE Output 7 (-) 250mA Accessory output

8 GRAY Output 8 (-) 250mA Accessory output

16 15 14 1319 18 1722 21 2024 23

Connection

This product has a maximum negative trigger output of 250mA. An automotive

grade Bosch-style 12V relay may be necessary for higher current accessories. (Sold separately)

ADS i-Datalink Maestro is required to operate this external accessory control

module.

For 3rd party controlled accessories, please refer to the corresponding installation

manual.

SIDE VIEW

POWER RESET HEADUNIT CAN OUTPUT UPDATE

Power Harness

BATT* (Yellow) ACC (Red) GND (Black)

*Fuse Rating: 7A

Reset

Button

(3-pin White)

Interface Harness (4-pin White)

Connect to IDATALINK I/F

cable from Head Unit

Interface Cable (4-pin)

[included with ADS module]

8ch Output Harness

(24-pin White)

ADS

module

(4-pin Black)

iDatalink

MAESTRO

Module

Connect to Relay/output to accessories (Sold separately)

USB port

(Firmware

updates only)

Output 1 (Purple) Output 2 (White/Red) Output 3 (Brown) Output 4 (Blue) Output 5 (Green) Output 6 (Pink) Output 7 (White) Output 8 (Gray)

Warning

IMPROPER INSTALLATION MAY RESULT IN SERIOUS DAMAGE OR INJURY INCLUDING ELECTRICAL SHOCK, AND INTERFERENCE WITH THE OPERATION OF THE VEHICLE.

7/8 8/8

System Diagram

iDatalink

MAESTRO

Module

OBD2

Relay Installation

(depending on the accessory)

Accessory Control Module Output

12V or GND

87a

To Accessory

12VDC Fused

Head Unit Setting

In order to use this feature, the “External Accessory Control” setting must be turned on.

Setup System External Accessories External Accessory Ctrl

Warning

IMPROPER INSTALLATION MAY RESULT IN SERIOUS DAMAGE OR INJURY INCLUDING ELECTRICAL SHOCK, AND INTERFERENCE WITH THE OPERATION OF THE VEHICLE.

LIMITED WARRANTY

ALPINE ELECTRONICS OF AMERICA, INC. ("Alpine"), is dedicated to quality craftsmanship and is pleased to offer this Warranty. We suggest that you read it thoroughly. Should you have any questions, please contact your Dealer or contact Alpine at one of the telephone numbers listed below.

PRODUCTS COVERED:

This Warranty covers Car Audio Accessories ("the product"). Products purchased in the Canada are covered only in the Canada. Products purchased in the U.S.A. are covered only in the U.S.A.

LENGTH OF WARRANTY:

This Warranty is in effect for one year from the date of the ﬁrst consumer purchase.

WHO IS COVERED:

This Warranty only covers the original purchaser of the product, who must reside in the United States, Puerto Rico or Canada.

WHAT IS COVERED:

This Warranty covers defects in materials or workmanship (parts and labor) in the product.

WHAT IS NOT COVERED:

This Warranty does not cover the following: 1 Damage occurring during shipment of the product to

Alpine for repair (claims must be presented to the carrier).

2 Damage caused by accident or abuse. 3 Damage caused by negligence, misuse, improper

operation or failure to follow instructions contained in the Owner's manual.

4 Damage caused by act of God, including without

limitation, earthquake, ﬁre, ﬂood, storms or other acts of nature. Any cost or expense related to the removal or reinstallation of the product.

5 Service performed by an unauthorized person,

company or association.

6 Any product which has the serial number defaced,

altered or removed.

7 Any product which has been adjusted, altered or

modiﬁed without Alpine's consent.

8 Any product not distributed by Alpine within the United

States, Puerto Rico or Canada.

9 Any product not purchased from an Authorized

Alpine Dealer.

HOW TO OBTAIN WARRANTY SERVICE:

1 You are responsible for delivery of the product to an

Authorized Alpine Service Center or Alpine for repair and for payment of any initial shipping charges. Alpine will, at its option, repair or replace the product with a new or reconditioned product without charge. If the repairs are covered by the warranty, and if the product was shipped to an Authorized Alpine Service Center or Alpine, Alpine will pay the return shipping charges.

2 You should provide a detailed description of the

problem(s) for which service is required.

3 You must supply proof of your purchase of the

product.

4 You must package the product securely to avoid

damage during shipment. To prevent lost packages it is recommended to use a carrier that provides a tracking service.

HOW WE LIMIT IMPLIED WARRANTIES:

ANY IMPLIED WARRANTIES INCLUDING FITNESS FOR USE AND MERCHANTABILITY ARE LIMITED IN DURATION TO THE PERIOD OF THE EXPRESS WARRANTY SET FORTH ABOVE AND NO PERSON IS AUTHORIZED TO ASSUME FOR ALPINE ANY OTHER LIABILITY IN CONNECTION WITH THE SALE OF THE PRODUCT.

HOW WE EXCLUDE CERTAIN DAMAGES:

ALPINE EXPRESSLY DISCLAIMS LIABILITY FOR INCIDENTAL AND CONSEQUENTIAL DAMAGES CAUSED BY THE PRODUCT. THE TERM "INCIDENTAL DAMAGES" REFERS TO EXPENSES OF TRANSPORTING THE PRODUCT TO THE ALPINE SERVICE CENTER, LOSS OF THE ORIGINAL PURCHASER'S TIME, LOSS OF THE USE OF THE PRODUCT, BUS FARES, CAR RENTALS OR OTHERS COSTS RELATING TO THE CARE AND CUSTODY OF THE PRODUCT. THE TERM "CONSEQUENTIAL DAMAGES" REFERS TO THE COST OF REPAIRING OR REPLACING OTHER PROPERTY WHICH IS DAMAGED WHEN THIS PRODUCT DOES NOT WORK PROPERLY. THE REMEDIES PROVIDED UNDER THIS WARRANTY ARE EXCLUSIVE AND IN LIEU OF ALL OTHERS.

HOW STATE/PROVINCIAL LAW RELATES TO THE WARRANTY:

This Warranty gives you speciﬁc legal rights, and you may also have other rights which vary from state to state and province to province. In addition, some states/ provinces do not allow limitations on how long an implied warranty lasts, and some do not allow the exclusion or limitation of incidental or consequential damages. Accordingly, limitations as to these matters contained herein may not apply to you.

IN CANADA ONLY:

This Warranty is not valid unless your Alpine car audio product has been installed in your vehicle by an Authorized Installation Center, and this upon installation by the installation center.

HOW TO CONTACT CUSTOMER SERVICE:

Should the product require service, please call the following number for your nearest Authorized Alpine Service Center.

CUSTOMER SERVICE 1-800-421-2284, ext. 860304 TECH SUPPORT

Or visit our website at; http://www.alpine-usa.com

1-800-TECH-101 (1-800-832-4101)

warranty stamped

Please refer to the head unit’s owner’s manual for detailed operating instructions.

Ext Acc Ctrl

ALPINE ELECTRONICS OF AMERICA, INC., 19145 Gramercy Place, Torrance, California 90501, U.S.A.

Do not send products to this address.

Call the toll free telephone number or visit the website to locate a service center.