Alpine AD-SPK1PRO Installation Manual

Mounting Bracket

AD-SPK1PRO 20210114v1

 1/2

Mounting Bracket

AD-SPK1PRO Installation Manual

Introduction

Congratulations on purchasing the AD-SPK1PRO. This manual is designed to take you through using the AD-

SPK1PRO with the AD-SPK1 Bluetooth speaker. Please familiarize yourself with the owners manual and if you still have additional questions please call 1-800-TECH-101.

Box Contents

Foam

Foot Pads

x 2

Adjustable

Straps

x 2

Hook And

Loop Straps

x 2

Base Foam

Pad

x 1

Bracket

Installation Instructions

Mounting Bracket

AD-SPK1PRO 20210114v1

 2/2

1 Remove the protective covering from the Base

Foam Pad and apply the adhesive side to the ﬂat side of the Bracket.

3 Wrap the (2) Hook And Loop Straps around the

Bracket, going under the metal mounts. Note: the hole in the middle of the Bracket can be used for a power cable depending on how the bracket will be used. A hole would likely need to be punched in the foam pad for this use case.

2 Remove the protective covering from the (2) Foam

Foot Pads and apply the adhesive side next to the metal mounts protruding out from the Bracket.

4 Use the (2) Adjustable Straps to secure the

Bluetooth speaker to the Bracket by wrapping them over the bottom of the bracket on the ends of the speaker where the circumference is the widest. This will ensure the Adjustable Straps can be tightened properly and they will not get in the way of the buttons.