AiM Channel Expansion User Manual

Page 1
Channel Expansion
User Manual
www.aim-sportline.com
Page 2
Channel Expansion
User Manual Release 1.00
Index
Chapter 1 – Introduction ...................................................................................................... 3
Capitolo 2 – Connection to MXL – Evo3 Pista/Pro – Evo4................................................... 4
Chapter 3 – Channel Expansion configuration ..................................................................... 5
3.1 – Display configuration ............................................................................................... 5
3.2 – Sensor Calibration ................................................................................................... 5
Appendix .............................................................................................................................. 6
Appendix A – Product code .............................................................................................. 6
Appendix B – Technical schemes .................................................................................... 6
Page 3
Channel Expansion
User Manual
0
Chapter 1 – Introduction
Release 1.00
Channel Expansion is an analog channels multiplier.
Channel Expansion communication protocol increases the available channels for data acquisition, without occupying or modifying any of the existing system channels. Channel Expansion allows to transfer to the logger signals from sensors, without any need of
wiring, so decreasing the number of cables.
Channel Expansion can be connected to MXL Pista/Pro05 and EVO3 Pro/Pista and EVO4. Channel Expansion is IP 67 waterproof.
Page 4
Channel Expansion
User Manual
1
Capitolo 2 – Connection to MXL – Evo3 Pista/Pro – Evo4
Release 1.00
Channel Expansion is very easy to install: it is enough to fix it using the side holes. After
installation, Channel Expansion connection is to be made according to the following connection scheme:
WARNING: it is recommended to install Channel Expansion away from heat sources and
electromagnetic interference.
Once configured via Race Studio 2, Channel Expansion will be recognized automatically by the logger when it switches on.
Page 5
Channel Expansion
User Manual
2
Chapter 3 – Channel Expansion configuration
Release 1.00
Channel Expansion must be configured using Race Studio2 software in order to be used. Channel Expansion configuration is to be made in the way explained in Race Studio 2 Configuration user manual - “How to configure Channel Expansion” chapter.
4
3.1 – Display configuration
When channels to enable/disable are defined, it is possible to visualize them according to the type of logger.
For more details, please refer to “How to configure MXL Strada/Pista/Pro/Pro05”, “ How
to configure AIM displays” (for all EVO loggers) chapters of Race Studio 2 Configuration user manual.
5
3.2 – Sensor Calibration
When configuration has been transmitted to the logger, it is necessary to do calibration of sensors, connecting them to Channel Expansion.
For more details, please refer to “Calibration and Autocalibration of sensors” of Race
Studio Configuration user manual.
Page 6
3
Appendix
6
Appendix A – Product code
Channel Expansion (Kit with cable): X08CHEXUC
7
Appendix B – Technical schemes
Channel Expansion
User Manual Release 1.00
Page 7
Channel Expansion
User Manual Release 1.00
Loading...