Ag Leader GPS 2500 RTK Installation Instructions

2202 South Riverside Drive, Ames, IA 50010

Phone: [phone] Internet: http://www.agleader.com

P/N: 2006342 - GPS 2500 RTK Radio Installation Instructions:

1. Remove the 14 screws from the radio bay
cover plate

2. Remove the radio bay cover to expose the
open radio bay.

2/4/2013 Rev A

1

2202 South Riverside Drive, Ames, IA 50010

Phone: [phone] Fax: [phone] Internet: http://www.agleader.com

3. Hand tighten the RF coax cable from the
receiver onto the radio RF connector. Do not
over tighten. The cable should end up at
roughly a 30 degree angle to the radio board.

4. Attach the 10-pin connector with the clasp
facing inward, as shown in the picture.
Ensure it snaps into place.

p/n: 2006342 Rev A

2

2202 South Riverside Drive, Ames, IA 50010

Phone: [phone] Fax: [phone] Internet: http://www.agleader.com

5. With the RF coax cable at the correct angle, it
will fit into the access hole as shown.

6. Using the screws provided in the radio kit,
secure the radio assembly into the radio bay.
Verify the o-ring is installed in the groove,
before re-installing the radio bay cover.

7. The cover should be tightened evenly as to
not distort the o-ring. Ending torque should
be 5 in/lbs.

8. Install the RTK antenna mount using the
screws provided in the radio kit.

p/n: 2006342 Rev A

3

2202 South Riverside Drive, Ames, IA 50010

Phone: [phone] Fax: [phone] Internet: http://www.agleader.com

9. Attach the coax cable to the RF connector on
the outside of the GPS 2500 housing and
install in the antenna mount.

10. Attach the RTK antenna to the mount.

11. Power the GPS 2500 and verify it communicates with the base station.

NOTE: verify the RTK unlock has been installed and RTK is an available differential option.

p/n: 2006342 Rev A

4