SANTO
ARCTIS
Integrierbare Unterbau-Kühl- und Gefriergeräte
Réfrigérateurs et congélateurs sous-plan à intégrer
Geïntegreerde onderbouwkoelen vriesapparaten
Integrated built-under refrigerators and freezers
Integrerbara underbänk-kyl- och frysskåp Työtason alle asennettavat jääkaapit ja pakastimet
Frigoriferi e congelatori sottotavolo da incasso
k Montageanweisung |
2-10 |
p Instructions de montage |
11-19 |
N Montage-aanwijzing |
20-28 |
t Installation instructions |
29-37 |
U Monteringsanvisning |
38-46 |
q Asennusohjeet |
47-55 |
C Istruzioni di montaggio |
56-63 |
Grid preparation
t
When changing the side at which the door opens, remove plug from the mains.
Left door opening: |
|
|
Remove the left side (A) of the grid cutting |
A |
|
it from the rear (see figure) |
||
Right door opening: |
B |
|
Remove the right side (B) of the grid cutting |
||
|
||
it from the rear (see figure) |
|
|
|
DO002/2 |
Re-install the grid to the base of the appliance by pushing on to the clasps (a) until they click.
a
a
Reversing the door
The side at which the door opens can be changed from the right side (as supplied) to the left side, if the installation site requires.
To reverse the opening direction of the door, proceed as shown in the figures:
|
4 |
1 |
|
|
5 |
2 |
3 |
1 |
|
29
Warning! After completion of the door reversing operation, check that the door gasket adheres to the cabinet. If the ambient temperature is cold (i.e. in Winter), the gasket may not fit perfectly to the cabinet. In that case, wait for the natural fitting of the gasket or accelerate this process by heating up the part involved with a normal hairdryer on a low setting.
6 |
2 |
10 |
13 |
9 |
12 |
11 |
3 |
Changing over the freezer compartment door
(not on all models)
Open the freezer compartment door a little way.
Using a small screwdriver, press the spring in the opening of the lower door bearing slightly upwards and take the door bearing out complete with the door.
30
Position the covering cap (M) on the opposite side.
Turn the freezer compartment door through 180° and fit the lower door bearing into the lower bearing cavity of the freezer compartment door.
Lift the freezer compartment door a |
|
|
little way upwards, fit it into the |
M |
|
upper door bearing, and at the same |
||
|
time insert the lower door bearing AEG43 into the square hole. Small upwards
and downwards adjustments of the freezer compartment door will make fitting easier.
Building the appliance in under a worktop
|
The dimensions of the recessed |
|
|
600 |
|
|
||
|
installation area must correspond |
|
|
with those indicated in the figure. |
|
|
|
550 |
|
|
min. |
|
|
600 |
Installation kit |
|
|
1xB |
|
2xC |
1xA |
|
|
|
|
12 |
2 |
1 |
|
2 |
1 |
2 |
1 |
|
|
|
|
31