Adamatic DFC Installation Manual

INSTALLATION
INSTRUCTIONS

PROFESSIONAL SERIES HANDLE KIT

For Use with DFC Trash Compactor with Full Overlay Front
Retain for Future Reference

VIKING RANGE CORPORATION

111 FRONT STREET

GREENWOOD, MISSISSIPPI (MS) 38930 USA

[phone]

IMPORTANT-PLEASE READ AND FOLLOW

•Before beginning, please read these instructions completely and carefully.

•Do not remove permanently affixed labels, warnings, or plates from the product. This may void the warranty.

•Please refer to the Trash Compactor Installation Instructions for more information on installing the compactor door
panel.

•The installer should leave instructions with the consumer who should retain for local inspector’s use and for future

reference.

Parts included: Required Tools:
Professional Series Handle Electric Drill Phillips Head Screwdriver
(2) End Caps Pilot Bit Masking Tape
(4) 1/4” x 1 1/4” Phillips Head Screws 1/4” (.6 cm) Drill Bit Pencil
Installation Instructions Counter Sink Drill Bit Tape Measure

Rubber Mallet

INSTALLATION WITH WOODEN FULL OVERLAY CUSTOM DOOR FRONT

To Install:

1. Using the illustration on the right, layout the

handle location on the custom door. It is
recommended that masking tape be placed
where the four holes will be drilled to help
mark the hole placement and to prevent any
damage to the door when drilling the holes.

2. Drill small pilot holes completely through the

door at each of the four hole locations.

3. The Professional Series handle will be

mounted using the screws provided. These
screws require the holes to be countersunk on
the back of the panel in order for the storage
compartment cover plate to fit flush against
the compactor door panel. Using the four
pilot holes as guides, drill completely through
the door in the four hole locations with a 1/4”
(.6 cm) bit. Countersink the four holes on the
backside of the custom door panel.

4. Place a handle encap on both ends of the

handle tube. Tap the endcaps firmly into
place with a rubber mallet ensuring that both
endcaps mounting surfaces are parallel.

5. Align the holes in the endcaps with the holes

on the panel and attach the Professional
Series handle to the panel using the four
screws provided.

VIKING RANGE CORPORATION

111 Front Street • Greenwood,Mississippi (MS) 38930 USA • [phone]

Specifications subject to change without notice

For more product information, call 1-888-VIKING1 (845-4641) or visit our web site at http//www.vikingrange.com

(PS0903VR)

F20278

1/4” (0.6 cm)
hole locations
countersink
holes

(2) 1/32”
(.08 cm)
pilot holes,
1/4” (0.6
cm) deep

Custom Door - Back View

7-9/32”

(18.5 cm)

28-1/4”
(71.8 cm)

15”

(38.1 cm)

17-3/16” (43.7 cm)

1” (2.5 cm)

1-3/8”
(3.5 cm)

1-5/16”
(3.3 cm)

3/4” (1.9 cm) thick

Side View