Acu-Rite 888 User Manual

Instruction Manual

Thermometer with Probe

model 00888

Congratulations on your new AcuRite product. To ensure the best
possible product performance, please read this manual in its entirety
and retain it for future reference.

Unpacking Instructions

Remove the protective lm that is applied to the LCD screen prior to using this
product. Locate the tab and peel off to remove.

Package Contents

1. Display unit

2. Instruction Manual

Features & Benets

1 10

2

3

4 5 6 7 8

DISPLAY

1. IN/OUT Switch

Slide to view current indoor
(display) temperature or current

outdoor (probe) temperature.

2. Current Temperature

3. MIN/MAX Button

Displays high & low records.

4. CLEAR Button

5. LIGHT Button

Activates momentary backlight.

9

6. Probe Temperature Sensor

7. Fold-out Tabletop Stand

8. Battery Compartment

9. °F/°C Switch

Slide to select °F or °C
temperature units.

10. Integrated Hang Hole

For easy placement.

SETUP

Install or Replace Battery

AcuRite recommends high quality
alkaline batteries for the best
product performance. Heavy duty
or rechargeable batteries are not
recommended.

Slide battery compartment cover

1

off and install 1 fresh “AAA”
battery. Follow the polarity (+/-) diagram.

Replace battery cover.

2

PLEASE DISPOSE OF OLD OR DEFECTIVE BATTERIES IN AN ENVIRONMENTALLY SAFE
WAY AND IN ACCORDANCE WITH YOUR LOCAL LAWS AND REGULATIONS.

used for an extended period of time. Follow the polarity (+/-) diagram in the battery compartment. Promptly remove dead batteries from the device. Dispose of used
batteries properly. Only batteries of the same or equivalent type as recommended are to be used. DO NOT incinerate used batteries. DO NOT dispose of batteries in fire,
as batteries may explode or leak. DO NOT mix old and new batteries or types of batteries (alkaline/standard). DO NOT use rechargeable batteries. DO NOT recharge
non-rechargeable batteries. DO NOT short-circuit the supply terminals.

BATTERY SAFETY: Clean the battery contacts and also those of the device prior to battery installation. Remove batteries from equipment which is not to be

2

1

OPERATION

Placement for Maximum Accuracy

AcuRite sensors are sensitive to surrounding environmental conditions. Proper
placement of both the display unit and temperature probe are critical to the
accuracy and performance of this product.

Display Unit & Probe Placement

Place the display unit in a dry area free of dirt and dust. Display unit stands

upright for tabletop use or is wall-mountable.
To observe outdoor temperatures, the wired temperature probe must be placed

outside. The probe sensor can be securely mounted to a surface utilizing the
adhesive pad or the integrated hang hole. Take care not to damage the sensor
during mounting.

Important Placement Guidelines

• To ensure accurate temperature measurement, place units out of direct
sunlight and away from heat sources or vents.

• The wired temperature probe is not waterproof and is not intended for
permanent submersion in liquids. Submersion in liquid for more than 30
seconds may result in complete failure of the probe.

High & Low Records

High and low values are recorded for display (indoor) and probe (outdoor)

temperature. High and low records reect the minimum and maximum

temperature recorded since the unit was powered on, since the battery was
changed, or since it was manually reset (whichever was most recent).

2

To view the HIGH temperature record, press and release the “MIN/MAX”

button. The “MAX” icon appears on the display next to the high records.
To view the LOW temperature record, press and release the “MIN/MAX”

button twice. The “MIN” icon appears on the display next to the low records.
To reset the LOW records, press the “CLEAR” button while viewing the low

records. Dashes will display to conrm low values have been cleared.
To reset the HIGH records, press the “CLEAR” button while viewing the high

records. Dashes will display to conrm high values have been cleared.

Specications

TEMPERATURE RANGE

POWER

Display: -4°F to 122°F; -20°C to 50°C
Probe: -40°F to 158°F; -40°C to 70°C

Display: 1 x AAA alkaline battery

Troubleshooting

Inaccurate

temperature

Display screen

not working

FCC Information

This device complies with part 15 of FCC rules. Operation is subject to the following two conditions:
1- This device may NOT cause harmful interference, and

2- This device must accept any interference received, including interference that may cause undesired operation.

WARNING: Changes or modications to this unit not expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC

rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equip
ment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular
installation.

• Make sure both the display unit and sensor are
placed out of direct sunlight and away from any heat
sources or vents (see page 2).

• Check that the battery is installed correctly. Battery

may need to be replaced.

-

Customer Support

AcuRite customer support is committed to providing you with best-in-class
service. For assistance, please have the model number of this product
available and contact us in any of the following ways:

[phone] [e-mail]

24/7 support at www.AcuRite.com

► Installation Videos ► Register your Product
► Instruction Manuals ► Support User Forum
► Replacement Parts ► Submit Feedback & Ideas

3

IMPORTANT

TO RECEIVE WARRANTY SERVICE

PRODUCT REGISTRATION

Register online

to receive 1 year

warranty protection

PRODUCT MUST BE REGISTERED

Register a Product

www.AcuRite.com

►

Limited One Year Warranty

At AcuRite, we proudly uphold our commitment to quality technology. Chaney Instrument Co. warrants
that all products it manufactures to be of good material and workmanship, and to be free of defects when
properly installed and operated for a period of one year from the date of purchase. We recommend that
you visit us at www.AcuRite.com for the fastest way to register your product. However, product registration
does not eliminate the need to retain your original proof of purchase in order to obtain warranty benefits.

Chaney Instrument Co. warrants that all products it manufactures to be of good material and workmanship, and to be free of defects
when properly installed and operated for a period of one year from the date of purchase. Remedy for breach of this warranty is limited
to repair or replacement of the defective item(s). Any product which, under normal use and service, is proven to breach the warranty
contained herein within ONE YEAR from date of sale will, upon examination by Chaney, and at its sole option, be repaired or replaced
by Chaney. Transportation costs and charges for returned goods shall be paid for by the purchaser. Chaney hereby disclaims all
responsibility for such transportation costs and charges. This warranty will not be breached, and Chaney will give no credit for products
it manufactures which have received normal wear and tear, been damaged (including by acts of nature), tampered, abused, improperly
installed, damaged in shipping, or repaired or altered by others than authorized representatives of Chaney.

The above-described warranty is expressly in lieu of all other warranties, express or implied, and all other warranties are hereby
expressly disclaimed, including without limitation the implied warranty of merchantability and the implied warranty of fitness for a
particular purpose. Chaney expressly disclaims all liability for special, consequential or incidental damages, whether arising in tort
or by contract from any breach of this warranty. Some states do not allow the exclusion or limitation of incidental or consequential
damages, so the above limitation or exclusion may not apply to you. Chaney further disclaims all liability from personal injury relating
to its products to the extent permitted by law. By acceptance of any of Chaney’s products, the purchaser assumes all liability for the
consequences arising from their use or misuse. No person, firm or corporation is authorized to assume for Chaney any other liability in
connection with the sale of its products. Furthermore, no person, firm or corporation is authorized to modify or waive the terms of this
paragraph, and the preceding paragraph, unless done in writing and signed by a duly authorized agent of Chaney. This warranty gives
you specific legal rights, and you may also have other rights which vary from state to state.

For in-warranty claims:

Chaney Instrument Co. | 965 Wells St. | Lake Geneva, WI 53147

It’s more than accurate, it’s

AcuRite offers an extensive assortment of precision instruments,

designed to provide you with information you can depend on to

Plan your day with confidence

™

.

www.AcuRite.com

©Chaney Instrument Co. All rights reserved. AcuRite is a registered trademark of the
Chaney Instrument Co., Lake Geneva, WI 53147. All other trademarks and copyrights

Printed in China

00888 INST 072314

are the property of their respective owners. AcuRite uses patented technology.
Visit www.AcuRite.com/patents for details.