Abit AC11 User Manual
Specifications and Main Features
1. Chipset
- Intel 82562EH
2. Networking Using Home Phone Lines PNAlliance
- Embeds HomePNA PHY that supports 1.0 Mb/s Ethernet-like home networking across telephone lines. -Bears built-in support for dual HomePNA data transfer rates and two transmission power levels. -Permits automatic recognition between MII/LAN ports or HomePNA ports. -Provides HomePNA with a PHY interrupt generation that supports notification of PHY interrupts. -Is able to give software functionality to internal registers of HomePNA PHY.
3. Power Management and Power Saving Features
- The specification for network device class power management revision 1.0 is strictly adhered. -Adheres to all events for wake-up specified under network device class power management specification revision 1.0 -Complies with advanced configuration and power interface specification version 1.0 completely. -Compliant with PCI bus power management interface revision 1.0 specification fully.
4. Network Side Features
-Defines remote ports: HomePNA 1.0 standard (1Megabaud-1megabit. sipro).
5. Operating System Support
-Windows 95,98 and ME -Window NT version 4.0 -Windows 2000
6. Modem Chipset
-Conexant11246, 20463-11
7. Line Connection
-PSTN, 2 wires.
8. Data Modem
-V.90 &K56flex. -V.34 (33,600 bps - 2,400 bps). -V.32bis (14,400 bps - 4,800 bps). -V.32 (9,600 bps - 4,800 bps).
- V.22 bis (2400 bps-1200 bps) V.22 (1200 bps) V.23 (75 1200 600 bps) V.21 (300 bps) Bell 212A (1200 bps) Bell 103 (300 bps)
- Group III, Class 1.
- Class 1 fax error correction mode.
- V.17 (14400 12000 bps)
- V.29 (9600 7200 bps)
- V.27ter (4800 2400 bps)
- V.21 (300 bps)
- V.42, LAP-M & MNP 2-4.
- V42 bis & MNP 5.
- 8Khz PCM and Ima Adpcm, Concurrent DTMF detection, Voice/Silence detection,
- Asynchronous,
- Full-duplex with Acoustic and Line Echo Cancellation, Microphone agc and Mute on, Volume control through software, Music on Hold and Flash Hook,
- V.80 sync access mode interface, Transparent & Framed sub-modes, Voice call first or Intel video phone with ProShare technology,
- V.8 auto mode negotiation, V8 PRIME & V8bis, Adaptive Rate renegotiation,
- Tone detection, Dial tone second dial tone ring back, busy data fax answering tones and DTMF,
- PTT and Safety : FCC, CE, CTR 21.
18. Modem Support on the Operating System
- Windows Operating System 95/98/ME.
- Window’s NT 4.0 which is an Operating System.
- Windows 2000 Operating system.
19. 5.1-Audio Channels Support
- AD1885 Audio Codec of an Analog Device.
- Home theatre speaker output of five channels’ complement.
- AC’97 2.1 Standard of Regulation.
- Decoding of Dolby Digital is provided with Soft DVD.
20. Audio Converters Devices
- Codec of 16-bit stereo which is duplex.
- IMA and PCM Conversion of A/D.
21. For System Installation, the Following are the Hammington Constraints
- Processor of 233MHz Pentium II.
- Processor of 266MHz Celeron.
- 256K L2 Cache Memory.
- Windows 95 or 98 operating system with 16 Megabytes of RAM.
- For Windows NT 4.0 or 2000 requires 32 Megabytes of RAM.
- Seven Megabytes of free hard disk space.
- A single CNR slot.
Frequently Asked Questions
1. In Which Operating Systems Will the AC11 CNR Card Work?
- Windows 95/98/ME AND NT 4.0 AND Windows 2000.
2. The Type of Modem ChipSet That Is Present In The AC11 CNR Card:
- Conexant 11246, 20463-11.
3. What Is The Highest Data Rate When Using HomePNA?
- 1 Mb/s.
4. Is it possible for the modem to operate unattended and without any extra drivers installed?
- That is untrue, a modem will not function properly unless drivers are installed.
5. What kind of power management does the AC11 support?
- It is compliant with the Power Management Specification for Network Device Class and many wake-up events.
6. How about the system requirements, for the AC11 CNR card?
- The following system requirements are a must: For Windows 95/98, 233 MHz Pentium II CPU or higher with 256 KB of L2 cache and 16 MB of RAM, for both Windows NT(16 MB) and Windows 2000 (32 MB).
7. What type of audio output does the AC11 support: 5.1 channel or not?
- Yes, it supports Home Theater Speaker Output with more than five channels.
8. The modem needs what type of connection?
- It needs PSTN and it requires 2 wires.
9. Is it possible to use a telephone set through the modem?
- Yes, if you plug your telephone set into the PHONE output port located on the AC.
10. What features support error correction in the modem?
- Supported modems in us have LAP-M and MNP 2, 3 and 4 error correction protocols.
User Manual
Loading...