3R SYSTEM CASE K User Manual

Series User Manual

Package Contents and Installation of the parts

Mainboard supporter - Use this only where required, and assemble using Paper Washer(Red Washer).

Paper Washer ‒ Use this with 3.5 screws and mainboard supporter for electrical insulation.

Screw 3.5 - Use this to secure Mainboard and PSU.

* How to assemble the Screw: Be sure to install the paper washer between

the Mainboard and the Screw(3.5 ) to prevent a short circuit.

How to connect cables

POWER LED+-

H.D.D LED +-

POWER LED : Refer to the manual and install it while obeying the polarities, If a 4-pin connector is supported, then connect it to the power supply.

HDD LED : Refer to the manual and install it while obeying the polarities.

* In case of LED connector, the terminal with the ▲ mark is ‘+’.

POWER SW(Switch) : This switch has no polarity. POWER SW It doesn’t matter which place you

connect this to the mainboard.

RESET SW	RESET SW(Switch) : This switch has no polarity.
		It doesn’t matter which place you
		connect this to the mainboard.
USB	AUDIO	: Connect it to the terminals on the Mainboard.
USB	AUDIO

Screw 3 - Use this to secure CD-ROM, FDD and various PCI slot cards.

Screw(HDD) - Use this to secure HDD.

PC Speaker - This is installed in mainboard and calls the condition of the system.

Specifications and improvements in the design of our PC case are subject to change without any prior notice.

*Warranty voids when damage is caused by user’s abuse, misuse or

by a natural disaster.

*Warranty voids when damage is caused by modifying the product or by using the product in improper application.

For the detailed A/S and support, please visit our website. (http://www.3rsys.com)

TEL : [phone] Fax : [phone]

e-mail : [e-mail]