3M FM DWS 1500 User Manual

Replacement Cartridge Change Instructions
FM DWS 1500
Turn Clockwise To
Shut Off
1. Close the feed water valve and lift up the faucet handle.
Wait approximately 10 seconds for the water pressure to depressurize. Return faucet handle to the off position.
2. Twist the filter cartridge 1/4 turn counterclockwise (as
viewed from the bottom) so that the ears on the cartridge are able to disengage from the head. Firmly pull the cartridge downward to remove it from the head.
3. Remove the new filter cartridge from its sanitary sealed
wrapper. (Double check to see that it is the correct replacement filter cartridge by comparing the labels.)
4. Using either tap water, food grade silicon lubricant or
glycerine, lubricate the O-ring seals to make cartridge insertion easier. Do not use petroleum jelly.
Turn Counterclockwise
To Turn On
5. Line up the cartridge ears, insert the cartridge and push
it up into the head until it is fully seated. Twist the cartridge 1/4 turn clockwise to lock it into place.
6. Open the feed water valve and carefully check for
leaks.
7. Lift up on faucet handle to purge air and carbon fines
from the new filter cartridge. Flush 3 gallons through system before use (approximately 6 min).
NOTE: It is normal to have small air bubbles present in the
product water for 1-2 days after installation and filter changes. This may result in cloudy filtered water.
It is recommended that car tridg es be replaced every 6-12 months, depending on local water conditions and use.
7
System Location (Fig.1)
Outlet Fitting w/
Flow Control
To Faucet
Ball Valve
From Feedwater Source
Allow 2” Min. Clearance
8
Loading...