|
|
|
|
x2 ALKALINE |
|
|
|
|
|
|
|
AGES 3+ |
|
|
|
|
|
|
|
|
|
|
|
|
|||
|
|
|
™ |
1.5V AA/LR6 size |
BATTERIES |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
||||
|
|
|
NOT INCLUDED |
REQUIRED |
|
|
|
|
|
|
|
78464/78374 Asst. |
|
|
|
|
|
|
|
|
|
|
|||||
|
|
|
|
Phillips/cross head screwdriver (not |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|||||||||
|
|
|
|
included) needed to insert batteries. |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Zoom N’ Go HULK™ 4-Wheel Smasher
To install batteries:
1. Using a Phillips/cross head screwdriver (not included), unscrew battery cover.
2. Insert 2 fresh 1.5 V 
“AA” or LR6 batteries. 
See diagram for polarity. 
3. Replace battery cover 
and tighten screw. 
IMPORTANT: BATTERY INFORMATION
Please retain this information for future reference. Batteries should be replaced by an adult.
CAUTION: TO AVOID BATTERY LEAKAGE
1.Be sure to insert the batteries correctly and always follow the toy and battery manufacturers’ instructions;
2.Do not mix old and new batteries or alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries;
3.Always remove weak or dead batteries from the product.
CAUTION:
1.Always follow the instructions carefully. Use only batteries specified and be sure to insert item correctly by matching the + and – polarity markings.
2.Do not mix old and new batteries or standard (carbon-zinc) with alkaline batteries.
3.Remove exhausted or dead batteries from the product.
4.Remove batteries if product is not to be played with for a long time.
5.Do not short-circuit the supply terminals.
6.Should this product cause, or be affected by, local electrical interference, move it away from other electrical equipment. Reset (switching off and back on again or removing and reinserting batteries) if necessary.
7.RECHARGEABLE BATTERIES: Do not mix these with any other types of batteries. Always remove from the product before recharging. Recharge batteries under adult supervision. DO NOT RECHARGE OTHER TYPES OF BATTERIES.
Loading...