ZyXEL Communications P-791R User Manual

P-791R v2

G.SHDSL.bis Router

Quick Start Guide

Version 1.00
4/2007
Edition 1

DEFAULT LOGIN

IP Address http://192.168.1.1

Administrator Password 1234

User Password user

Copyright © 2007. All rights reserved.

P-791R v2 Quick Start Guide

Overview

The P-791R v2 is a G.SHDSL.bis Router providing high-speed LAN-to-LAN connection and
Internet access over the telephone line. You can use your P-791R v2 for either IP routing
or bridging depending on your ISP (Internet Service Provider) configuration.

This Quick Start Guide shows how to set up the P-791R v2 for Internet access.

See the User’s Guide for information about setting up point-to-point connections.

1 Hardware Connections

4

3

1DSL: Use the gray telephone wire to connect the P-791R v2’s DSL port to a telephone

jack.

2ETHERNET: Use the yellow Ethernet cable to connect a computer to the ETHERNET

port for Internet access or to configure the P-791R v2.

3POWER: Use the power adaptor provided with your P-791R v2 to connect an

appropriate power source to the POWER socket. Make sure the power source is on.

4 Push in the POWER button.

The CON/AUX port and corresponding CON, AUX switch are used when you want to set
up dial backup or use the console port. Make sure that the switch is set to AUX for dial
backup setup. See the User’s Guide for more details about these features.

2

1

2

P-791R v2 Quick Start Guide

Look at the LEDs

•The POWER LED blinks green while your P-791R v2 starts up and stays on when it is
ready.

•The DSL LED blinks while the P-791R v2 is trying to establish a connection with the ISP
and stays on when the connection is established.

•The ETHERNET LED stays on if the ETHERNET port is properly connected and blinks
when there is traffic.

V If any of these LEDs are off, check your connections, and inspect your

cables for damage. If the LEDs are still off, contact your local vendor.

2 Status Page

Use the status screen to view basic setup information.

1 Open your Internet browser, and enter

http://192.168.1.1.

V If you cannot access the web configurator, make sure you allow pop-up

windows and JavaScripts and set up Java permissions appropriately. See
the User’s Guide for more information and further troubleshooting tips.

V Make sure your computer’s IP address is in the same subnet as the P-791R

v2’s LAN IP address.

3