ZyXEL Communications B-122 User Manual

ZyAIR B-122

CardBus 11Mbps Wireless LAN Card

Quick Installation Guide

Version 1.00

December 2003

Important Note

Federal Communications Commission (FCC) Interference Statement

The Wireless LAN Adapter has been tested to the FCC exposure requirements
(Specific Absorption Rate).

The equipment complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment, under 47 CFR 2.1093 paragraph (d) (2).

This Transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.

Refer to the User’s Guide for general FCC statements.

Procedure to View a Product’s Certification(s)

1. Go to www.zyxel.com

2. Select your product from the drop-down list box on the ZyXEL home page to go
to that product's page.

3. Select the certification you wish to view from this page.

2

About Your ZyAIR

The ZyAIR is an IEEE 802.11b compliant wireless LAN PC card that fits into any
32-bit CardBus slots. Its maximum 11 Mbps data rate, which gives Ethernet
equivalent speed, is ideal in the corporate or home environment.

1. Installation Requirements

Before installation, make sure you have the following requirements.

• Pentium II 300MHz or above

• A minimum of 6 MB available hard disk space

• A minimum of 32 MB RAM

• A CD-ROM drive

• A CardBus slot

• Windows 98 SE/Me/2000/XP

• Windows 98 SE users may need the Windows 98 SE CD

2. ZyAIR Utility and Hardware Installation

The installation procedures are similar for all supported Windows versions.
Windows XP screen shots are shown unless otherwise specified.

DO NOT insert the ZyAIR at this point.

1. Insert the support CD into the CD-ROM drive on your computer. The CD

auto runs. Otherwise, locate and double-click on setup.exe.
A Welcome screen displays. Click Next.

3