Zyxel WPA-1000 installation guide

WPA-1000

802.11g Wireless Projector Adapter

Quick Start Guide

Version 2.00 10/2007 Edition 1

DEFAULT SETTINGS

IP Address http://192.168.1.10

Passwords

Conference

Control

Host

Admin 1234

SSID ZyXEL

1234

WPA-1000 Quick Start Guide

WPA-1000 Overview

The WPA-1000 allows meeting participants to access and share one projector via wireless connection to the WPA-1000, as shown in the figure below. IEEE 802.11b/g standards are supported and wireless connections can be secured with WEP security.

This Quick Start Guide shows how to connect to the WPA-1000 with an Ethernet cable in order to access it and first enable wireless security. This is recommended as the wireless connection is not secure by default, so people in adjacent rooms may be able to view your presentation. After you configure wireless security, everyone who knows the security settings can connect wirelessly to the WPA-1000 and use the WPA-1000 to display their presentation.

" See your User’s Guide on the CD in the package for more information on all

features.

To read the User’s Guide, insert the CD that came in the box into your CD-ROM drive. A screen should pop up. Navigate to the User’s Guide from this screen. If a screen does not pop up, open Windows Explorer (click My Computer), click on the CD-ROM drive (usually drive D:) and navigate to it from there.

What You Have To Do

1 Make hardware connections

2 Note information in the standby screen

3 Configure wireless security

4 Connect wirelessly to the WPA-1000

5 Install the WPA-1000 utility

WPA-1000 Quick Start Guide

6 Start sharing projections

What Your Computer Should Have

• Intel Pentium III 800MHz or faster processor

• 256 MB RAM required; 512 MB, or more recommended

• 10 MB free hard-disk space

• Microsoft Windows 2000 Service Pack 4 or later, Windows XP Service Pack 2 or later, or Windows Vista 32 bit

• Microsoft Internet Explorer 6.0 or 7.0 (recommended); Firefox 1.5 or 2.0

• Ethernet adapter for direct Ethernet connection to the WPA-1000

• IEEE 802.11b/g wireless adapter for wireless connection to the WPA-1000

1 Make Hardware Connections

POWER ON|OFF VGA RESET LAN

1 Connect your computer to the LAN port using the red Ethernet cable that came with the

package or any other cross-over Ethernet cable.

2 Connect the projector to the WPA-1000's VGA socket with the gray VGA cable that

came with the package.

3 Use the power adapter from the package to connect your WPA-1000’s power socket to

a power source.

4 Press the ON/OFF button in to turn your device on.

V I cannot start my WPA-1000

• Check the POWER is turned on.

• Check the WPA-1000 is connected to a power source and the power source is turned on.

WPA-1000 Quick Start Guide

• Restart your device.

5 Look at the LEDs (lights) on the front panel of the WPA-1000.

•The STATUS LED is orange while the WPA-1000 is starting up, and green when it is ready.

•The LAN LED is steady green when it has a successful connection to your computer; it blinks while sending/receiving data.

V I cannot make a LAN connection to the WPA-1000 from my computer.

• Check the cables are connected properly and you are using the red Ethernet cable that came in the package or an auto-crossover Ethernet cable.

• Check your computer is set to obtain IP addresses automatically. See the User’s Guide for details on how to check this setting.

+ 9 hidden pages